Christiaan E. Lokin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Christiaan E. Lokin has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Bram Nauta
University of Twente
2 shared publications - Daniel Schinkel
Axign, Enschede, BE, The Netherlands
2 shared publications - Anne-Johan Annema
IC Design Group, EEMCS, University of Twente, Enschede, The Netherlands
1 shared publication - Harijot Singh Bindra
University of Twente
1 shared publication - Ronan van der Zee
Integrated Circuit Design Group, University of Twente, Enschede, The Netherlands
1 shared publication
Latest Publications
- Open Access
- 30 July 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 9, 108101-108111
Compensating Processing Delay in Excess of One Clock Cycle in Noise Shaping Loops Without Altering the Filter Topology
This work presents an analytical method to design a stable loop filter for a noise shaper with parasitic delays or poles in the loop. This method does not require an increase in the order of the loop or extra feedback paths and keeps the original poles and zeros of the noise-transfer function at the same location. The method has been applied to a low-pass loop filter with a parasitic unit delay and a band-pass loop filter with either three unit delays or a high-frequency pole, obtaining stable loop filters in all three cases.
- 30 July 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 9, 108101-108111
Open AccessCompensating Processing Delay in Excess of One Clock Cycle in Noise Shaping Loops Without Altering the Filter Topology
This work presents an analytical method to design a stable loop filter for a noise shaper with parasitic delays or poles in the loop. This method does not require an increase in the order of the loop or extra feedback paths and keeps the original poles and zeros of the noise-transfer function at the same location. The method has been applied to a low-pass loop filter with a parasitic unit delay and a band-pass loop filter with either three unit delays or a high-frequency pole, obtaining stable loop filters in all three cases.
- Top Cited Papers
- 23 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 53 (7) , 1902-1912
A 1.2-V Dynamic Bias Latch-Type Comparator in 65-nm CMOS With 0.4-mV Input Noise
A latch-type comparator with a dynamic bias pre-amplifier is implemented in a 65-nm CMOS process. The dynamic bias with a tail capacitor is simple to implement and ensures that the pre-amplifier output nodes are only partially discharged to reduce the energy consumption. The comparator is analyzed and compared to its prior art in terms of energy consumption and input referred noise voltage. First-order equations are presented that show how to optimize the pre-amplifier for low noise and high gain. Both the dynamic bias comparator and the prior art are implemented on the same die and measurements show that the dynamic bias can reduce the average energy consumption by about a factor 2.5 for the same input-equivalent noise at an input common-mode level of half the supply voltage.
- 23 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 53 (7) , 1902-1912
Top Cited PapersA 1.2-V Dynamic Bias Latch-Type Comparator in 65-nm CMOS With 0.4-mV Input Noise
A latch-type comparator with a dynamic bias pre-amplifier is implemented in a 65-nm CMOS process. The dynamic bias with a tail capacitor is simple to implement and ensures that the pre-amplifier output nodes are only partially discharged to reduce the energy consumption. The comparator is analyzed and compared to its prior art in terms of energy consumption and input referred noise voltage. First-order equations are presented that show how to optimize the pre-amplifier for low noise and high gain. Both the dynamic bias comparator and the prior art are implemented on the same die and measurements show that the dynamic bias can reduce the average energy consumption by about a factor 2.5 for the same input-equivalent noise at an input common-mode level of half the supply voltage.