Harshul Thakkar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Harshul Thakkar has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- Fateme Rezaei
Department of Chemical, Environmental and Materials Engineering, University of Miami, 1251 Memorial Drive, Coral Gables, Florida 33124, United States
12 shared publications Ali A. Rownaghi
8 shared publicationsAmit Hajari
4 shared publicationsQasim Al-Naddaf
Department of Chemical & Biochemical Engineering, Missouri University of Science and Technology, 1101 North State Street, Rolla, Missouri 65409, United States
4 shared publications- Ali Asghar Rownaghi
Department of Mechanical and Aerospace Engineering, University of Miami, 1251 Memorial Dr, Coral Gables, Florida 33146, United States
3 shared publications - Andrew Ruba
Materials Synthesis and Integrated Devices (MPA-11), Material, Physics and Applications Division, Los Alamos National Laboratory, Los Alamos, New Mexico 87545, United States
3 shared publications
Latest Publications
- Open Access
- 2 November 2026
- Published by American Chemical Society (ACS) in ACS Omega
Energy-Efficient and Low-Temperature Gaseous Concentration Swing Adsorption (GCSA)-Based Regeneration Method Utilizing Hydrogen Sweep for Direct Air Capture
Solid sorbent-based direct air capture (DAC) is a promising pathway for durable carbon dioxide removal (CDR), but large-scale deployment remains constrained by sorbent degradation and the high cost and energy associated with temperature-vacuum swing adsorption (TVSA). Here, we introduce a hydrogen (H2)-enabled gaseous concentration swing adsorption (GCSA) process that eliminates vacuum and enables regeneration at 35–70 °C using a closed-loop H2 sweep with a commercial amine sorbent. By lowering the CO2 partial pressure under reducing conditions near ambient pressure, H2-GCSA achieves effective regeneration with reduced thermal severity and suppressed oxidative degradation. Accelerated testing between 65 and 95 °C under oxidative and anaerobic environments demonstrates superior sorbent stability over 100 h under oxygen-free conditions. A process-integrated techno-economic analysis for a 100,000 tCO2/yr modular DAC plant, utilizing a total of less than 8.5 tons of H2 and incorporating downstream H2/CO2 separation via pressure swing adsorption (PSA), projects an energy demand of 2.78 GJ/tCO2 (775 KWh/tCO2) and a capture cost of 81 USD/tCO2, representing a 2–3× lower capital cost and 1.5–4× lower energy demand relative to TVSA. Further process integration using low-grade waste heat and PSA elimination reduces the energy demand to 0.85 GJ/tCO2 (235 KWh/tCO2), with projected costs approaching 31 USD/tCO2. Sensitivity analysis indicates that the sorbent cost below 95 USD/kg enables DAC below 100 USD/tCO2. Collectively, these results demonstrate that H2 sweep-mediated GCSA offers a scalable, lower-energy alternative to vacuum-driven (TVSA) regeneration on a wide range of sorbents, eliminating the sorbent material development risks and addressing a central bottleneck in solid-sorbent DAC.
- 2 November 2026
- Published by American Chemical Society (ACS) in ACS Omega
Open AccessEnergy-Efficient and Low-Temperature Gaseous Concentration Swing Adsorption (GCSA)-Based Regeneration Method Utilizing Hydrogen Sweep for Direct Air Capture
Solid sorbent-based direct air capture (DAC) is a promising pathway for durable carbon dioxide removal (CDR), but large-scale deployment remains constrained by sorbent degradation and the high cost and energy associated with temperature-vacuum swing adsorption (TVSA). Here, we introduce a hydrogen (H2)-enabled gaseous concentration swing adsorption (GCSA) process that eliminates vacuum and enables regeneration at 35–70 °C using a closed-loop H2 sweep with a commercial amine sorbent. By lowering the CO2 partial pressure under reducing conditions near ambient pressure, H2-GCSA achieves effective regeneration with reduced thermal severity and suppressed oxidative degradation. Accelerated testing between 65 and 95 °C under oxidative and anaerobic environments demonstrates superior sorbent stability over 100 h under oxygen-free conditions. A process-integrated techno-economic analysis for a 100,000 tCO2/yr modular DAC plant, utilizing a total of less than 8.5 tons of H2 and incorporating downstream H2/CO2 separation via pressure swing adsorption (PSA), projects an energy demand of 2.78 GJ/tCO2 (775 KWh/tCO2) and a capture cost of 81 USD/tCO2, representing a 2–3× lower capital cost and 1.5–4× lower energy demand relative to TVSA. Further process integration using low-grade waste heat and PSA elimination reduces the energy demand to 0.85 GJ/tCO2 (235 KWh/tCO2), with projected costs approaching 31 USD/tCO2. Sensitivity analysis indicates that the sorbent cost below 95 USD/kg enables DAC below 100 USD/tCO2. Collectively, these results demonstrate that H2 sweep-mediated GCSA offers a scalable, lower-energy alternative to vacuum-driven (TVSA) regeneration on a wide range of sorbents, eliminating the sorbent material development risks and addressing a central bottleneck in solid-sorbent DAC.
- 31 July 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (15) , 11758-11770
Role of Hierarchical Porosity in Dictating Adsorption Dynamics in Direct Air Capture Systems
- 31 July 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (15) , 11758-11770
Role of Hierarchical Porosity in Dictating Adsorption Dynamics in Direct Air Capture Systems
- 3 December 2024
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 6 (23) , 14421-14435
Experimental and Techno-Economic Analysis of Polybenzimidazole Thin-Film Membranes for Efficient Pervaporation Desalination of Produced Water
- 3 December 2024
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 6 (23) , 14421-14435
Experimental and Techno-Economic Analysis of Polybenzimidazole Thin-Film Membranes for Efficient Pervaporation Desalination of Produced Water
- Open Access
- 6 November 2024
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 9 (46) , 45970-45982
Accelerated Testing of PEI-Silica Sorbent Pellets for Direct Air Capture
Amine-based sorbents have shown exceptional CO2 uptake for direct air capture (DAC). However, amine degradation is a major issue for this class of materials, hindering their deployment for large-scale DAC. In this study, a comprehensive evaluation of polyethylenimine (PEI) sorbents was conducted to understand their degradation under process-relevant environments for the DAC of CO2. A solvent-minimized silica-supported PEI-sorbent powder synthesis method using centrifugal mixing was developed. Unlike traditional solvent-assisted impregnated sorbent synthesis methods, the centrifugal mixing method enabled a 94% reduction in volatile and toxic organic solvent use in pelletized sorbent synthesis. The pelletized sorbents exhibited CO2 adsorption capacities consistent with traditional fabrication methods for PEI-based solid sorbents (about 1 mmol/g). The pelletized sorbent degradation behavior was evaluated at three different regeneration temperatures (80, 100, and 120 °C) under nitrogen (N2), ambient air (21% O2), and saturated dry and wet (75% relative humidity (RH)) CO2 environments using fixed-bed breakthrough (BT) experiments. Additionally, accelerated testing (AT) protocols that mimic industrial DAC conditions were developed to assess the long-term stability of the PEI-silica pellets. Our results indicate that the sorbent degrades rapidly (ca. 94% within 24 h) at 120 °C in ambient air (21% O2), demonstrating the detrimental impact of oxygen when compared to an O2-free environment. AT performed for 100 h (equivalent to 33, 100, and 100 cycles) continuously at 80, 100, and 120 °C reveals that dry CO2-induced degradation of the PEI-silica sorbent pellets is 30-40% and 40-50% more than the degradation measured in wet CO2 and inert (pure N2) environments.
- 6 November 2024
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 9 (46) , 45970-45982
Open AccessAccelerated Testing of PEI-Silica Sorbent Pellets for Direct Air Capture
Amine-based sorbents have shown exceptional CO2 uptake for direct air capture (DAC). However, amine degradation is a major issue for this class of materials, hindering their deployment for large-scale DAC. In this study, a comprehensive evaluation of polyethylenimine (PEI) sorbents was conducted to understand their degradation under process-relevant environments for the DAC of CO2. A solvent-minimized silica-supported PEI-sorbent powder synthesis method using centrifugal mixing was developed. Unlike traditional solvent-assisted impregnated sorbent synthesis methods, the centrifugal mixing method enabled a 94% reduction in volatile and toxic organic solvent use in pelletized sorbent synthesis. The pelletized sorbents exhibited CO2 adsorption capacities consistent with traditional fabrication methods for PEI-based solid sorbents (about 1 mmol/g). The pelletized sorbent degradation behavior was evaluated at three different regeneration temperatures (80, 100, and 120 °C) under nitrogen (N2), ambient air (21% O2), and saturated dry and wet (75% relative humidity (RH)) CO2 environments using fixed-bed breakthrough (BT) experiments. Additionally, accelerated testing (AT) protocols that mimic industrial DAC conditions were developed to assess the long-term stability of the PEI-silica pellets. Our results indicate that the sorbent degrades rapidly (ca. 94% within 24 h) at 120 °C in ambient air (21% O2), demonstrating the detrimental impact of oxygen when compared to an O2-free environment. AT performed for 100 h (equivalent to 33, 100, and 100 cycles) continuously at 80, 100, and 120 °C reveals that dry CO2-induced degradation of the PEI-silica sorbent pellets is 30-40% and 40-50% more than the degradation measured in wet CO2 and inert (pure N2) environments.
- 30 June 2022
- Published by Elsevier in Applied Energy
- Vol. 322, 119526
Reduced building energy consumption by combined indoor CO2 and H2O composition control
- 30 June 2022
- Published by Elsevier in Applied Energy
- Vol. 322, 119526
Reduced building energy consumption by combined indoor CO2 and H2O composition control
- 1 January 2020
- Published by Elsevier in Separation and Purification Technology
- Vol. 230
Diffusion kinetics of ethane, ethylene, and their binary mixtures in ethane-selective adsorbents
- 1 January 2020
- Published by Elsevier in Separation and Purification Technology
- Vol. 230
Diffusion kinetics of ethane, ethylene, and their binary mixtures in ethane-selective adsorbents
- 30 November 2018
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 57 (51) , 17470-17479
MOF-GO Hybrid Nanocomposite Adsorbents for Methane Storage
- 30 November 2018
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 57 (51) , 17470-17479
MOF-GO Hybrid Nanocomposite Adsorbents for Methane Storage
- 2 October 2018
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 6 (11) , 15228-15237
Adsorption of Ethane and Ethylene over 3D-Printed Ethane-Selective Monoliths
- 2 October 2018
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 6 (11) , 15228-15237
Adsorption of Ethane and Ethylene over 3D-Printed Ethane-Selective Monoliths
- 1 September 2018
- Published by Elsevier in Chemical Engineering Journal
- Vol. 348, 109-116
Development of 3D-printed polymer-zeolite composite monoliths for gas separation
- 1 September 2018
- Published by Elsevier in Chemical Engineering Journal
- Vol. 348, 109-116
Development of 3D-printed polymer-zeolite composite monoliths for gas separation