WLWelton Da Silva Lima

Welton Da Silva Lima

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Welton Da Silva Lima has a total of 28 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Single-Phase Single-Stage NPC AC-DC Converter Applied as Electric Vehicle Battery Charger

    by José Janiere Silva De Souza, Luan Carlos Dos Santos Mazza, Welton Da Silva Lima, Samanta Gadelha Barbosa, Fernando Luiz Marcelo Antunes

    This paper explores the application of a bidirectional single-phase single-stage NPC ac-dc converter for electric vehicle onboard chargers. The ac side consists of two NPC arms with an autotransformer, providing reduced voltage and current stress on switches while generating a five-level waveform and increasing current ripple frequency. The battery side employs a full-bridge converter and the power transfer is based on the dual active bridge principle. A theoretical study of the structure and operating principles is presented, along with descriptions of the modulation and control strategies. A dedicated control loop implements real-time monitoring of battery voltage and current on the secondary side, ensuring safe charging operation for OBC applications. The mathematical analysis and control strategy are validated through simulations and a 750 W small-scale experimental prototype.

  • A Solid State Transformer Based on a Single-Stage Three-Phase AC-DC T-Type Converters

    by Robério Oliveira Rodrigues, Luan Carlos Dos Santos Mazza, Welton Da S. Lima, Demercil De Souza Oliveira Júnior, Luiz H. Silva Colado Barreto, Dalton De Araújo Honório

    Conventional power transformers are equipment that are used to raise or lower voltages and currents and transfer energy in transmission and distribution systems. They are established and widely accepted devices, however, these transformers have limitations, as they do not have an onboard control system capable of controlling voltages and currents, an increase in reactive power and propagation of harmonics to the electrical network can occur. Therefore, the development of new technologies that can perform voltage and current transformation without presenting such deficiencies is necessary, and one of these technologies is the solid-state transformer (SST). Thus, this paper proposes a three-phase and bidirectional AC-DC converter, with an active power of 50 kW, voltages of 7.2 kVac and 800 Vdc, for applications in SSTs. The proposed topology is based on Dual Active Bridge (DAB) converters applied to the secondary and primary sides, respectively. In the course of this paper, it is also proposed to use the 15 kV/20 A silicon carbide (Sic) insulated gate bipolar transistor (IGBT) for the primary side with a diode in antiparallel to the IGBT of the 10 kV/10 A junction barrier schottky (JBS) type.


  • Open Access

    A Bidirectional Isolated Integrated AC–DC Converter Based on an Interleaved 3-Level T-Type Power Converters

    by Welton da S. Lima, Luan Carlos dos S. Mazza, Gustavo A. de L. Henn, Dalton de A. Honorio, Paulo P. Praca, Demercil de S. Oliveira, Luiz Henrique S. C. Barreto

    This paper presents an integrated single-phase bidirectional ac–dc converter based on a dual-active-bridge (DAB) topology. The primary side is based on a multi-state switching cell (MSSC) with a T-type (TNPC) cell, which is composed of two three-level interleaved legs and coupled inductor, while the secondary side is a single-phase full-bridge (FB). Moreover, a comparative analysis between an isolated ac–dc converter with a neutral point clamped (NPC) converter on the primary side is presented. The basic converter operating principles and experimental results of a 850 W prototype are presented in order to validate the theoretical analysis. The control strategy is implemented on the TMS320F28379D DSP. The proposed topology achieves a maximum efficiency of 91.40% at 300 W output power, and 89.40% at rated power. From the experimental results, it can be stated that the converter based on the T-type topology is more efficient than the structure based on the NPC.


  • Open Access

    TRANSFORMADOR DE ESTADO SÓLIDO CA-CC MONOFÁSICO 5 NÍVEIS BASEADO NO INTERCALAMENTO DE BRAÇOS NPC

    by Luan C. S. Mazza, José J. S. Souza, Welton da S. Lima, Demercil S. Oliveira Jr., Fernando L. M. Antunes, Raimundo N. M. de Oliveira, Cícero A. dos Santos

    Este artigo propõe uma topologia de Transformador de Estado Sólido (TES) CA-CC monofásico cinco níveis com característica de isolação em alta frequência e controle do fluxo de potência bidirecional. A topologia é composta pelo lado primário, que consiste em dois braços de conversor três níveis com ponto neutro grampeado (NPC-3L) monofásico conectados em paralelo com intercalamento, e pelo lado secundário, no qual é composto por um full bridge (FB) monofásico. O diagrama de estados de chaveamento e a estratégia de modulação e controle são apresentados. A análise teórica do conversor é realizada, visando demonstrar o fluxo de potência através do modelo fundamental, de forma similar ao conversor dual active bridge (DAB) monofásico. Para validação do estudo teórico são apresentados resultados experimentais do conversor proposto, através de um protótipo de 800 W.


  • Performance analysis of synchronization algorithms for grid-connected power converters under sub and inter-harmonics distortion

    by Jean M. L. Fonseca, Samuel S. Queiroz, Siomara R. Lima, Welton da Silva Lima, Rosana G. Almeida, Francisco Kleber A. Lima, Carlos Gustavo C. Branco

    This paper analyzes the performance of two synchronization algorithms, the EPLL and the ISI-PLL, under scenarios where inter-harmonics and sub-harmonics distortion are present in the input signals. Synchronization algorithms main goals are to estimate, with high accuracy, power grid parameters such as frequency and phase-angle. The EPLL is a well-known structure that is widely studied in the literature, whereas the ISI-PLL is a recent proposal. In order to obtain experimental results, both structures were implemented in the hardware-in-the-loop (HIL) dSPACE 1103 platform. Results showed that where the proposed structure is highly accurate under the considered scenarios, the EPLL estimation is not as precise.


  • Didactic kit for pratical testing of the basic switched mode power supply topologies

    by Isabelli P. Viana, Welton S. Lima, Caio A. Aquino, Joao G. R. Johannesson, Claudio M. S. Medeiros

    The DC/DC converters are widely used in regulated switch-mode DC power supplies and in DC motor drives. Their concepts are, in general, initially approached in disciplines like Power Electronics or Industrial Electronics, when the students have the first experience with high or medium frequency power switching. Thus, to overcome the natural difficulties in practicing this technology, the authors propose a didactic kit, equipped with basic structure for laboratory experiments related with Buck, Boost, and Buck-Boost converters.