Katja Kohopää
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Katja Kohopää has a total of 55 co-authors. Here are the top co-authors by number of shared publications:
- Antti Kemppinen
VTT Technical Research Centre of Finland
3 shared publications - Joonas Govenius
VTT Technical Research Centre of Finland Ltd
3 shared publications - Alberto Ronzani
VTT Technical Research Centre of Finland
2 shared publications - Arijit Bera
VTT Technical Research Centre of Finland Ltd. 2 , P.O. Box 1000, FI-02044 VTT, Finland
2 shared publications - Emma Mykkänen
VTT Technical Research Centre of Finland
2 shared publications - Janne Samuel Lehtinen
VTT Technical Research Centre of Finland
2 shared publications
Latest Publications
- Open Access
Fast optical data transfer into a Josephson junction array
We employ externally shunted Nb-AlO$_x$-Nb Josephson junctions for demonstrating a circuit that is suitable for an optically driven Josephson Arbitrary Waveform Synthesizer (JAWS). This technology enables overdamped junctions with characteristic frequencies above 100 GHz and critical currents of the order of 100 $μ$A, which is promising, e.g., for low-dissipation optical control of quantum circuits such as superconducting quantum bits. Here we utilize a double-pulse technique to experimentally determine the maximum rate at which optical pulse data can be reliably delivered to the superconducting circuit. We demonstrate the feasibility of data transfer up to 60 Gbit/s, which is about factor 4 higher than for typical JAWS.
Open AccessFast optical data transfer into a Josephson junction array
We employ externally shunted Nb-AlO$_x$-Nb Josephson junctions for demonstrating a circuit that is suitable for an optically driven Josephson Arbitrary Waveform Synthesizer (JAWS). This technology enables overdamped junctions with characteristic frequencies above 100 GHz and critical currents of the order of 100 $μ$A, which is promising, e.g., for low-dissipation optical control of quantum circuits such as superconducting quantum bits. Here we utilize a double-pulse technique to experimentally determine the maximum rate at which optical pulse data can be reliably delivered to the superconducting circuit. We demonstrate the feasibility of data transfer up to 60 Gbit/s, which is about factor 4 higher than for typical JAWS.
- Open Access
- 19 August 2025
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 37 (17) , 6770-6781
Atomic Layer Deposition of Superconductive Niobium Carbonitride Thin Films
Transition metal carbonitrides (TMCN) are stable materials with excellent catalytic and superconductive properties. Atomic layer deposition (ALD) stands out as the optimal method for the fabrication of these materials, enabling their use in future applications. In this study, we deposit ALD NbC x N y films at 250–450 °C with NbF5 and 1,4-bis(trimethylsilyl)–1,4-dihydropyrazine on Si, Ru, TiN, and soda lime glass. We analyze the film growth characteristics, composition, and phase. The films show substrate-enhanced growth on Si with a growth per cycle (GPC) of 1.3 Å. Additionally, the films were superconductive as-deposited and had a superconducting critical temperature (T c ) of 14.5 K after annealing at 950 °C. This work expands the range of TMCNs deposited by ALD and demonstrates the applicability of ALD for thin film materials with a high T c .
- 19 August 2025
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 37 (17) , 6770-6781
Open AccessAtomic Layer Deposition of Superconductive Niobium Carbonitride Thin Films
Transition metal carbonitrides (TMCN) are stable materials with excellent catalytic and superconductive properties. Atomic layer deposition (ALD) stands out as the optimal method for the fabrication of these materials, enabling their use in future applications. In this study, we deposit ALD NbC x N y films at 250–450 °C with NbF5 and 1,4-bis(trimethylsilyl)–1,4-dihydropyrazine on Si, Ru, TiN, and soda lime glass. We analyze the film growth characteristics, composition, and phase. The films show substrate-enhanced growth on Si with a growth per cycle (GPC) of 1.3 Å. Additionally, the films were superconductive as-deposited and had a superconducting critical temperature (T c ) of 14.5 K after annealing at 950 °C. This work expands the range of TMCNs deposited by ALD and demonstrates the applicability of ALD for thin film materials with a high T c .
- Open Access
- 1 July 2024
- Published by AIP Publishing in APL Materials
- Vol. 12 (7)
Effect of ion irradiation on superconducting thin films
We demonstrate ion irradiation by argon or gallium as a wafer-scale post-processing method to increase disorder in superconducting thin films. We study several widely used superconductors, both single-elements and compounds. We show that ion irradiation increases normal-state resistivity in all our films, which is expected to enable tuning their superconducting properties, for example, toward a higher kinetic inductance. We observe an increase in superconducting transition temperature for Al and MoSi and a decrease for Nb, NbN, and TiN. In MoSi, ion irradiation also improves the mixing of the two materials. We demonstrate the fabrication of an amorphous and homogeneous film of MoSi with uniform thickness, which is promising, for example, for superconducting nanowire single-photon detectors.
- 1 July 2024
- Published by AIP Publishing in APL Materials
- Vol. 12 (7)
Open AccessEffect of ion irradiation on superconducting thin films
We demonstrate ion irradiation by argon or gallium as a wafer-scale post-processing method to increase disorder in superconducting thin films. We study several widely used superconductors, both single-elements and compounds. We show that ion irradiation increases normal-state resistivity in all our films, which is expected to enable tuning their superconducting properties, for example, toward a higher kinetic inductance. We observe an increase in superconducting transition temperature for Al and MoSi and a decrease for Nb, NbN, and TiN. In MoSi, ion irradiation also improves the mixing of the two materials. We demonstrate the fabrication of an amorphous and homogeneous film of MoSi with uniform thickness, which is promising, for example, for superconducting nanowire single-photon detectors.
- Open Access
- 19 July 2021
- Published by AIP Publishing in Applied Physics Letters
- Vol. 119 (3) , 032601
Driving a low critical current Josephson junction array with a mode-locked laser
We report proof-of-concept experiments on an optically driven Josephson voltage standard based on a mode-locked laser (MLL), a time-division multiplexer, and a cryogenic ultrafast photodiode driving an overdamped Josephson junction array (JJA). Our optical pulse pattern generator (PPG) concept builds on the capability of MLLs to produce trains of picosecond-wide optical pulses with little amplitude and temporal spread. Our present setup enables multiplication of the original 2.3 GHz pulse repetition frequency by a factor of 8. A commercial photodiode converts the optical pulses into about 25 ps wide electrical pulses in liquid helium several cm from the JJA. Using a custom-made MLL, we can drive a JJA with a low critical current of 360 μA at multiple Shapiro steps. We have performed experiments with pulse pairs whose time interval can be set freely without distorting the shapes of individual pulses. Experimental results are in qualitative agreement with theoretical simulations, and they demonstrate, e.g., crossover in the Shapiro step pattern when the time interval between the pulses is approximately equal to the inverse of the characteristic frequency of the JJA. However, there are quantitative discrepancies, which motivate an improved integration of photodiodes and JJAs to improve both the understanding and fidelity of Josephson Arbitrary Waveform Synthesizers. Considering future quantum technologies in a wider perspective, our optical approach is a potential enabler for fast and energy-efficient pulse drive without an expensive high-bandwidth electrical PPG and without high-bandwidth electrical cables that yield too high thermal conductance between cryogenic and room temperatures.
- 19 July 2021
- Published by AIP Publishing in Applied Physics Letters
- Vol. 119 (3) , 032601
Open AccessDriving a low critical current Josephson junction array with a mode-locked laser
We report proof-of-concept experiments on an optically driven Josephson voltage standard based on a mode-locked laser (MLL), a time-division multiplexer, and a cryogenic ultrafast photodiode driving an overdamped Josephson junction array (JJA). Our optical pulse pattern generator (PPG) concept builds on the capability of MLLs to produce trains of picosecond-wide optical pulses with little amplitude and temporal spread. Our present setup enables multiplication of the original 2.3 GHz pulse repetition frequency by a factor of 8. A commercial photodiode converts the optical pulses into about 25 ps wide electrical pulses in liquid helium several cm from the JJA. Using a custom-made MLL, we can drive a JJA with a low critical current of 360 μA at multiple Shapiro steps. We have performed experiments with pulse pairs whose time interval can be set freely without distorting the shapes of individual pulses. Experimental results are in qualitative agreement with theoretical simulations, and they demonstrate, e.g., crossover in the Shapiro step pattern when the time interval between the pulses is approximately equal to the inverse of the characteristic frequency of the JJA. However, there are quantitative discrepancies, which motivate an improved integration of photodiodes and JJAs to improve both the understanding and fidelity of Josephson Arbitrary Waveform Synthesizers. Considering future quantum technologies in a wider perspective, our optical approach is a potential enabler for fast and energy-efficient pulse drive without an expensive high-bandwidth electrical PPG and without high-bandwidth electrical cables that yield too high thermal conductance between cryogenic and room temperatures.
- Open Access
- 16 May 2020
- Published by MDPI AG in Nanomaterials
- Vol. 10 (5) , 950
Enhancement of Superconductivity by Amorphizing Molybdenum Silicide Films Using a Focused Ion Beam
We have used focused ion beam irradiation to progressively cause defects in annealed molybdenum silicide thin films. Without the treatment, the films are superconducting with critical temperature of about 1 K. We observe that both resistivity and critical temperature increase as the ion dose is increased. For resistivity, the increase is almost linear, whereas critical temperature changes abruptly at the smallest doses and then remains almost constant at 4 K. We believe that our results originate from amorphization of the polycrystalline molybdenum silicide films.
- 16 May 2020
- Published by MDPI AG in Nanomaterials
- Vol. 10 (5) , 950
Open AccessEnhancement of Superconductivity by Amorphizing Molybdenum Silicide Films Using a Focused Ion Beam
We have used focused ion beam irradiation to progressively cause defects in annealed molybdenum silicide thin films. Without the treatment, the films are superconducting with critical temperature of about 1 K. We observe that both resistivity and critical temperature increase as the ion dose is increased. For resistivity, the increase is almost linear, whereas critical temperature changes abruptly at the smallest doses and then remains almost constant at 4 K. We believe that our results originate from amorphization of the polycrystalline molybdenum silicide films.