Donald Mclean
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Donald Mclean has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Alfred Cuschieri
Institute for Medical Science and Technology (IMSaT), University of Dundee, Wilson House, 1 Wurzburg Loan, Dundee Medipark, Dundee DD2 1FD, UK
2 shared publications - Stuart I. Brown
Institute for Medical Science and Technology, University of Dundee, Dundee, UK
2 shared publications - Zhigang Wang
Institute for Medical Science and Technology, University of Dundee, Dundee DD2 1FD, UK
2 shared publications - Andrew William Brown
Arkansas Children’s Research Institute, Little Rock, AR, USA
1 shared publication - Gordon John Florence
School of Chemistry & BSRC, and Integrated Institute of Engineering, University of St Andrews, North Haugh, St Andrews, Fife KY16 9ST, UK
1 shared publication - Pascal André
School of Physics and Astronomy (SUPA), University of St Andrews, St Andrews, UK
1 shared publication
Latest Publications
- 26 August 2014
- Published by IOP Publishing in Medical Engineering & Physics
- Vol. 36 (11) , 1521-1525
Intraluminal magnetisation of bowel by ferromagnetic particles for retraction and manipulation by magnetic probes
Feasibility studies are needed to demonstrate that safe and effective manipulation of bowel during Minimal Access Surgery (MAS) can be obtained by use of magnetic force. This paper characterises two classes of magnetic particles: stainless steel microparticles (SS-μPs) and iron oxide nanoparticles (IO-nPs) in terms of their magnetisation, chemical composition, crystallinity, morphology and size distribution. Both magnetic particles were dispersed in a high viscosity biological liquid for intraluminal injection of bowel. Ex vivo porcine bowel segments were then retracted by permanent magnetic probes of 5.0 and 10mm diameter. Strong retraction forces reaching 6N maximum were obtained by magnetic fluid based on dispersion of SS-μPs. In contrast, the IO-nP-based magnetic liquid generated less attraction force, due to both lower magnetic and solution properties of the IO-nPs. The comparison of the two particles allowed the identification of the rules to engineer the next generation of particles. The results with SS-μPs provide proof on concept that intraluminal injection of magnetic fluid can generate sufficient force for efficient bowel retraction. Thereafter we shall carry out in vivo animal studies for efficacy and safety of both types of ferrofluids.
- 26 August 2014
- Published by IOP Publishing in Medical Engineering & Physics
- Vol. 36 (11) , 1521-1525
Intraluminal magnetisation of bowel by ferromagnetic particles for retraction and manipulation by magnetic probes
Feasibility studies are needed to demonstrate that safe and effective manipulation of bowel during Minimal Access Surgery (MAS) can be obtained by use of magnetic force. This paper characterises two classes of magnetic particles: stainless steel microparticles (SS-μPs) and iron oxide nanoparticles (IO-nPs) in terms of their magnetisation, chemical composition, crystallinity, morphology and size distribution. Both magnetic particles were dispersed in a high viscosity biological liquid for intraluminal injection of bowel. Ex vivo porcine bowel segments were then retracted by permanent magnetic probes of 5.0 and 10mm diameter. Strong retraction forces reaching 6N maximum were obtained by magnetic fluid based on dispersion of SS-μPs. In contrast, the IO-nP-based magnetic liquid generated less attraction force, due to both lower magnetic and solution properties of the IO-nPs. The comparison of the two particles allowed the identification of the rules to engineer the next generation of particles. The results with SS-μPs provide proof on concept that intraluminal injection of magnetic fluid can generate sufficient force for efficient bowel retraction. Thereafter we shall carry out in vivo animal studies for efficacy and safety of both types of ferrofluids.
- 24 December 2013
- Published by Springer Nature in Surgical Endoscopy
- Vol. 28 (4) , 1277-1283
Impact of fenestrations and surface profiling on the holding of tissue by parallel occlusion laparoscopic graspers
Despite the importance of efficient grasping during laparoscopic surgery, the published literature on jaw features, e.g., fenestrations and surface profiling on grasping efficiency defined as resistance to slip without inflicting trauma, is limited. Various surface geometries of the jaws were tested with respect to (i) inclusion of fenestrations; (ii) surface contact to fenestration area ratio, and (iii) surface profiling of the jaws. Various loads were applied to the tissue which was subsequently pulled at a constant rate until free from the jaws. The maximal force necessary to pull the tissue free was recorded. The jaws were designed for use in parallel-occlusion graspers to avoid the well documented high pinch forces encountered with pivoted occlusion. At all applied forces the force needed to pull tissue from any fenestration design was significantly higher than the force necessary to pull tissue from non-fenestrated jaws (p < 0.05) with no significant differences between the three fenestration designs. The ratio of surface contact to fenestration area must exceed 1:0.4 to achieve a significant increase in the tissue retention. All the profiles studied were made using a single fenestration and with a surface contact to fenestration area ratio of 1:0.8. All such profile designs studied performed significantly better than the control (p < 0.005). The ratio of the mean retraction to applied force across all load conditions tested were 1.23:1.0 and 1.7:1.0 for the waved and toothed profile respectively, with standard deviations for the corresponding retraction force of ±0.45 and ±0.38 respectively. The retention efficiency of laparoscopic graspers is improved by fenestration which must, however, exceed a certain ratio (>1.0:0.4). Likewise surface profiling of the jaws enhances retention efficiency and its design (tooth, waved, mixed) directly influences the amount of pressure needed to retain tissue.
- 24 December 2013
- Published by Springer Nature in Surgical Endoscopy
- Vol. 28 (4) , 1277-1283
Impact of fenestrations and surface profiling on the holding of tissue by parallel occlusion laparoscopic graspers
Despite the importance of efficient grasping during laparoscopic surgery, the published literature on jaw features, e.g., fenestrations and surface profiling on grasping efficiency defined as resistance to slip without inflicting trauma, is limited. Various surface geometries of the jaws were tested with respect to (i) inclusion of fenestrations; (ii) surface contact to fenestration area ratio, and (iii) surface profiling of the jaws. Various loads were applied to the tissue which was subsequently pulled at a constant rate until free from the jaws. The maximal force necessary to pull the tissue free was recorded. The jaws were designed for use in parallel-occlusion graspers to avoid the well documented high pinch forces encountered with pivoted occlusion. At all applied forces the force needed to pull tissue from any fenestration design was significantly higher than the force necessary to pull tissue from non-fenestrated jaws (p < 0.05) with no significant differences between the three fenestration designs. The ratio of surface contact to fenestration area must exceed 1:0.4 to achieve a significant increase in the tissue retention. All the profiles studied were made using a single fenestration and with a surface contact to fenestration area ratio of 1:0.8. All such profile designs studied performed significantly better than the control (p < 0.005). The ratio of the mean retraction to applied force across all load conditions tested were 1.23:1.0 and 1.7:1.0 for the waved and toothed profile respectively, with standard deviations for the corresponding retraction force of ±0.45 and ±0.38 respectively. The retention efficiency of laparoscopic graspers is improved by fenestration which must, however, exceed a certain ratio (>1.0:0.4). Likewise surface profiling of the jaws enhances retention efficiency and its design (tooth, waved, mixed) directly influences the amount of pressure needed to retain tissue.