Arnaldo Teixeira Coelho
Research Subjects
Arnaldo Teixeira Coelho has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Jefferson Lins da Silva
Universidade de São Paulo
3 shared publications - Marta Pereira da Luz
Pontifícia Universidade Católica de Goiás, Brazil
3 shared publications - Clever Aparecido Valentin
Department of Geotechnical Engineering , São Carlos School of Engineering of São Carlos , University of São Paulo , São Paulo , Brazil , usp.br
2 shared publications - Gustavo Borel Menezes
Department of Civil Engineering, California State University, Los Angeles, CA 90032, USA
2 shared publications - Maria Alejandra Aparicio-Ardila
Universidade de São Paulo
2 shared publications - Marlon Silva Schliewe
Eletrobras, Furnas Centrais Elétricas S.A., Aparecida de Goiânia, Goiás 74923-650, Brazil
2 shared publications
Latest Publications
- Open Access
- 11 July 2021
- Published by MDPI AG in Sustainability
- Vol. 13 (14) , 7731
Performance of Rolled Erosion Control Products (RECPs) as Bioswale Revetments
Vegetated swales, or bioswales, are among the most commonly used type of green infrastructure (GI) for managing stormwater in temperate climate regions. However, performance data on bioswale drainage technology applied to highly weathered soils (low fertility, high acidity, and erosion prone) in tropical and subtropical climates are still limited. Aimed at closing this gap, this research investigated the performance—assessed in terms of vegetation biomass, biodiversity and coverage of swale, the structural integrity of revetments, and erosion control potential—and cost effectiveness of five rolled erosion control products (RECPs) currently available on the market, in combination with herbaceous vegetation as the revetment of drainage swales, in tropical soils. Additionally, the research project evaluated the performance of a new preseeded RECP, the Preseeded Reinforcement Mat, for drainage in areas that are difficult to access. The performances of all six RECPs were generally adequate as bioswale revetments in the conditions investigated, with performance index values ranging from 6 to 10 in a 0 to 10 scale. At the same time, some RECPs were more conducive to the growth of regional herbaceous vegetation species, measured in terms of biodiversity, which ranged from 2 to 14 species in the different bioswales, and some were more cost effective than others, with costs ranging from 19% to 106% of the cost of concrete lined swales.
- 11 July 2021
- Published by MDPI AG in Sustainability
- Vol. 13 (14) , 7731
Open AccessPerformance of Rolled Erosion Control Products (RECPs) as Bioswale Revetments
Vegetated swales, or bioswales, are among the most commonly used type of green infrastructure (GI) for managing stormwater in temperate climate regions. However, performance data on bioswale drainage technology applied to highly weathered soils (low fertility, high acidity, and erosion prone) in tropical and subtropical climates are still limited. Aimed at closing this gap, this research investigated the performance—assessed in terms of vegetation biomass, biodiversity and coverage of swale, the structural integrity of revetments, and erosion control potential—and cost effectiveness of five rolled erosion control products (RECPs) currently available on the market, in combination with herbaceous vegetation as the revetment of drainage swales, in tropical soils. Additionally, the research project evaluated the performance of a new preseeded RECP, the Preseeded Reinforcement Mat, for drainage in areas that are difficult to access. The performances of all six RECPs were generally adequate as bioswale revetments in the conditions investigated, with performance index values ranging from 6 to 10 in a 0 to 10 scale. At the same time, some RECPs were more conducive to the growth of regional herbaceous vegetation species, measured in terms of biodiversity, which ranged from 2 to 14 species in the different bioswales, and some were more cost effective than others, with costs ranging from 19% to 106% of the cost of concrete lined swales.
- Open Access
Geomats Used to Control Erosion on Reservoir Margins in Brazilian Hydroelectric Power Plants
Erosion on reservoir margins causes losses in the production of energy in Hydroelectric Power Plants (HPPs), making it necessary to implement control techniques that ensure the reduction in sediment deposits inside reservoirs. Among these techniques, geomats (geosynthetic erosion mats) are widely used to control erosion processes in slopes and watercourses. This material protects the margins both in the short and long term, contributing to strengthening the vegetation’s roots developed in the erosion areas. This paper studies the performance of geomats (with and without sack gabion) installed in six margin sections distributed in three experimental units of the Brazilian HPPs called Porto Colômbia and Volta Grande. The geomat performance was evaluated over four years of monitoring through a qualitative evaluation matrix and differential bathymetry. The influence of ultraviolet (UV) radiation on the degradation of geomats installed in each section (natural conditions), as well as on geomat ultraviolet-aging samples in the laboratory (accelerated conditions), was also evaluated using differential scanning calorimetry (DSC). The results showed no significant difference in performance between using the erosion control technique consisting only of geomats and the technique consisting of geomats and sack gabion. The highest bathymetric difference value obtained in the present study was 1.62 m in the experimental unit VG1, controlled with geomat without the application of sack gabion on the margin.
Open AccessGeomats Used to Control Erosion on Reservoir Margins in Brazilian Hydroelectric Power Plants
Erosion on reservoir margins causes losses in the production of energy in Hydroelectric Power Plants (HPPs), making it necessary to implement control techniques that ensure the reduction in sediment deposits inside reservoirs. Among these techniques, geomats (geosynthetic erosion mats) are widely used to control erosion processes in slopes and watercourses. This material protects the margins both in the short and long term, contributing to strengthening the vegetation’s roots developed in the erosion areas. This paper studies the performance of geomats (with and without sack gabion) installed in six margin sections distributed in three experimental units of the Brazilian HPPs called Porto Colômbia and Volta Grande. The geomat performance was evaluated over four years of monitoring through a qualitative evaluation matrix and differential bathymetry. The influence of ultraviolet (UV) radiation on the degradation of geomats installed in each section (natural conditions), as well as on geomat ultraviolet-aging samples in the laboratory (accelerated conditions), was also evaluated using differential scanning calorimetry (DSC). The results showed no significant difference in performance between using the erosion control technique consisting only of geomats and the technique consisting of geomats and sack gabion. The highest bathymetric difference value obtained in the present study was 1.62 m in the experimental unit VG1, controlled with geomat without the application of sack gabion on the margin.
- Open Access
Semi-Rigid Erosion Control Techniques with Geotextiles Applied to Reservoir Margins in Hydroelectric Power Plants, Brazil
In Brazil, hydroelectricity represents close to 70% of the energy consumed in the country. However, hydroelectric plant operations may be affected by the deposit of sediments for erosive processes on reservoir margins. This study presents the results of implementing two semi-rigid erosion control techniques installed on reservoir margins of two Brazilian Hydroelectric Power Plants (HPPs). These techniques were the gabion and gabion mattress used as a mixed technique and geogrid mattress technique. This paper highlights the importance of implementing geotextiles in the construction process of these erosion control techniques, taking advantage of their separation properties. The performance of the techniques was evaluated using qualitative performance variables and by differential bathymetry studies performed in 2016 and 2020 in the experimental units installed in each HPP. Moreover, the degradation of the geotextiles in each installation was evaluated through thermal analysis. The erosion control techniques that showed the best results were gabion and gabion mattress. Regarding the exhumed geotextiles, thermal analyses have shown that the commercial geotextiles that were used can withstand temperatures of up to 200 °C leading to no changes to their structure.
Open AccessSemi-Rigid Erosion Control Techniques with Geotextiles Applied to Reservoir Margins in Hydroelectric Power Plants, Brazil
In Brazil, hydroelectricity represents close to 70% of the energy consumed in the country. However, hydroelectric plant operations may be affected by the deposit of sediments for erosive processes on reservoir margins. This study presents the results of implementing two semi-rigid erosion control techniques installed on reservoir margins of two Brazilian Hydroelectric Power Plants (HPPs). These techniques were the gabion and gabion mattress used as a mixed technique and geogrid mattress technique. This paper highlights the importance of implementing geotextiles in the construction process of these erosion control techniques, taking advantage of their separation properties. The performance of the techniques was evaluated using qualitative performance variables and by differential bathymetry studies performed in 2016 and 2020 in the experimental units installed in each HPP. Moreover, the degradation of the geotextiles in each installation was evaluated through thermal analysis. The erosion control techniques that showed the best results were gabion and gabion mattress. Regarding the exhumed geotextiles, thermal analyses have shown that the commercial geotextiles that were used can withstand temperatures of up to 200 °C leading to no changes to their structure.
- Open Access
- 24 September 2020
- Published by MDPI AG in Sustainability
- Vol. 12 (19) , 7886
Bioengineering Techniques Adopted for Controlling Riverbanks’ Superficial Erosion of the Simplício Hydroelectric Power Plant, Brazil
Controlling and preventing soil erosion on slope surfaces is a pressing concern worldwide, and at the same time, there is a growing need to incorporate sustainability into our engineering works. This study evaluates the efficiency of bioengineering techniques in the development of vegetation in soil slopes located near a hydroelectric power plant in Brazil. For this purpose, twelve different bioengineering techniques were evaluated, in isolation and in combination, in the slopes (10 m high) of two experimental units (approximately 70 m long each) located next to the Paraíba do Sul riverbanks, in Brazil. High-resolution images of the slopes’ frontal view were taken in 15-day interval visits in all units for the first 90 days after implantation, followed by monthly visits up to 27 months after the works were finished. The images were treated and analyzed in a computer algorithm that, based on three-color bands (red–green–blue scale), helps to assess the temporal evolution of the vegetative cover index for each technique adopted. The results showed that most of the solutions showed a deficiency in vegetation establishment and were sensitive to climatological conditions, which induced changes in the vegetation phytosanitary aspects. Techniques which provided a satisfactory vegetative cover index throughout the investigated period are pointed out.
- 24 September 2020
- Published by MDPI AG in Sustainability
- Vol. 12 (19) , 7886
Open AccessBioengineering Techniques Adopted for Controlling Riverbanks’ Superficial Erosion of the Simplício Hydroelectric Power Plant, Brazil
Controlling and preventing soil erosion on slope surfaces is a pressing concern worldwide, and at the same time, there is a growing need to incorporate sustainability into our engineering works. This study evaluates the efficiency of bioengineering techniques in the development of vegetation in soil slopes located near a hydroelectric power plant in Brazil. For this purpose, twelve different bioengineering techniques were evaluated, in isolation and in combination, in the slopes (10 m high) of two experimental units (approximately 70 m long each) located next to the Paraíba do Sul riverbanks, in Brazil. High-resolution images of the slopes’ frontal view were taken in 15-day interval visits in all units for the first 90 days after implantation, followed by monthly visits up to 27 months after the works were finished. The images were treated and analyzed in a computer algorithm that, based on three-color bands (red–green–blue scale), helps to assess the temporal evolution of the vegetative cover index for each technique adopted. The results showed that most of the solutions showed a deficiency in vegetation establishment and were sensitive to climatological conditions, which induced changes in the vegetation phytosanitary aspects. Techniques which provided a satisfactory vegetative cover index throughout the investigated period are pointed out.