Evangelos D. Evangelou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Evangelos D. Evangelou has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Ioannis N. Markou
Soil Mechanics and Foundation Engineering Laboratory, Department of Civil Engineering, Democritus University of Thrace, University Campus Kimmeria, GR-67150 Xanthi, Greece
3 shared publications - Konstantinos E. Bantralexis
Soil Mechanics and Foundation Engineering Laboratory, Department of Civil Engineering, Democritus University of Thrace, University Campus Kimmeria, GR-67150 Xanthi, Greece
2 shared publications - Adrián Riquelme
Department of Civil Engineering, University of Alicante, Alicante, Spain
1 shared publication - Andreas S. Christoforou
Soil Mechanics and Foundation Engineering Laboratory, Department of Civil Engineering, Democritus University of Thrace, Xanthi, Greece
1 shared publication - Eleni S. Boura
Soil Mechanics and Foundation Engineering Laboratory, Department of Civil Engineering, Democritus University of Thrace, University Campus Kimmeria, GR-67150 Xanthi, Greece
1 shared publication - George Papathanassiou
Department of Geology, Aristotle University of Thessaloniki, 54124 Thessaloniki, Greece
1 shared publication
Latest Publications
- Open Access
Dynamic Parameters of Fiber-Reinforced Soils at Very Small Strains
Improvement of the engineering properties of soils by reinforcing them with fibers, at an appropriate percentage of the weight of dry soil, is frequently selected to ensure the safe construction and operation of many structures. However, the published information regarding the investigation of the dynamic properties of fiber-reinforced soils at very small strains is very limited. Toward this end, the dynamic behavior of fiber-reinforced soils is investigated experimentally by conducting Bender Element tests under different confining pressures. The effect of polypropylene fiber reinforcement on the shear wave velocity (Vs), the velocity of the primary wave (Vp), the initial Young’s modulus (E0) and the initial shear modulus (G0) of sand and sand–clay mixtures with varying compositions is examined in this study. The soils were reinforced with five different types of polypropylene fibers having lengths from 9 mm to 50 mm, at fiber contents from 0.5% to 2% by weight of dry soil. The results indicate that the dynamic and the small-strain stiffness parameters of fiber-reinforced soils increase with increasing confining pressure, while also being affected by the soil type, the fiber type, and content. Although fiber inclusion resulted generally in a reduction of the dynamic properties of soils, increases ranging from 5% to 55% were observed in certain soil–fiber combinations in comparison with the unreinforced soils.
Open AccessDynamic Parameters of Fiber-Reinforced Soils at Very Small Strains
Improvement of the engineering properties of soils by reinforcing them with fibers, at an appropriate percentage of the weight of dry soil, is frequently selected to ensure the safe construction and operation of many structures. However, the published information regarding the investigation of the dynamic properties of fiber-reinforced soils at very small strains is very limited. Toward this end, the dynamic behavior of fiber-reinforced soils is investigated experimentally by conducting Bender Element tests under different confining pressures. The effect of polypropylene fiber reinforcement on the shear wave velocity (Vs), the velocity of the primary wave (Vp), the initial Young’s modulus (E0) and the initial shear modulus (G0) of sand and sand–clay mixtures with varying compositions is examined in this study. The soils were reinforced with five different types of polypropylene fibers having lengths from 9 mm to 50 mm, at fiber contents from 0.5% to 2% by weight of dry soil. The results indicate that the dynamic and the small-strain stiffness parameters of fiber-reinforced soils increase with increasing confining pressure, while also being affected by the soil type, the fiber type, and content. Although fiber inclusion resulted generally in a reduction of the dynamic properties of soils, increases ranging from 5% to 55% were observed in certain soil–fiber combinations in comparison with the unreinforced soils.
- Open Access
- 5 September 2023
- Published by MDPI AG in Geotechnics
- Vol. 3 (3) , 874-893
Mechanical Behavior of Fiber-Reinforced Soils under Undrained Triaxial Loading Conditions
The design of fiber-reinforced soil structures, such as embankments and pavements, can be carried out using the results of unconsolidated, undrained triaxial compression tests conducted on specimens at their “as-compacted” water content and analyzed in terms of total stresses. The effects of soil and fiber type on the mechanical behavior of fiber-reinforced soils have not been methodically or adequately examined in the past under these conditions, and the effects of fiber length and content on the shear strength parameters of fiber-reinforced soils need further experimental documentation. Accordingly, five soils ranging from “excellent” to “poor” materials for use in earthwork structures were tested in the present study, in combination with five types of polypropylene fibers having lengths ranging from 9 to 50 mm. Unconsolidated undrained triaxial compression tests were conducted on specimens at their “as-compacted” water content, with fiber contents ranging from 0.5 to 2% by weight of dry soil. Fiber reinforcement reduces the stiffness and increases the deformability of the soil. The fiber-reinforced soils exhibit a more ductile behavior in comparison with the unreinforced soils. A Mohr–Coulomb type linear failure criterion satisfactorily describes the shear strength behavior of fiber-reinforced soils in total stress terms. The cohesion values of the fiber-reinforced soils range between 61 kPa and 301 kPa and increase up to seven times in comparison with the cohesion values of the unreinforced soils. The variations of the angle of internal friction of soils due to fiber reinforcement are generally limited to ±25%. The cohesion improvement due to fiber reinforcement is increased with increasing fiber content and fiber length up to 30 mm and is inversely proportional to the fine-grained fraction and the cohesion of the unreinforced soil.
- 5 September 2023
- Published by MDPI AG in Geotechnics
- Vol. 3 (3) , 874-893
Open AccessMechanical Behavior of Fiber-Reinforced Soils under Undrained Triaxial Loading Conditions
The design of fiber-reinforced soil structures, such as embankments and pavements, can be carried out using the results of unconsolidated, undrained triaxial compression tests conducted on specimens at their “as-compacted” water content and analyzed in terms of total stresses. The effects of soil and fiber type on the mechanical behavior of fiber-reinforced soils have not been methodically or adequately examined in the past under these conditions, and the effects of fiber length and content on the shear strength parameters of fiber-reinforced soils need further experimental documentation. Accordingly, five soils ranging from “excellent” to “poor” materials for use in earthwork structures were tested in the present study, in combination with five types of polypropylene fibers having lengths ranging from 9 to 50 mm. Unconsolidated undrained triaxial compression tests were conducted on specimens at their “as-compacted” water content, with fiber contents ranging from 0.5 to 2% by weight of dry soil. Fiber reinforcement reduces the stiffness and increases the deformability of the soil. The fiber-reinforced soils exhibit a more ductile behavior in comparison with the unreinforced soils. A Mohr–Coulomb type linear failure criterion satisfactorily describes the shear strength behavior of fiber-reinforced soils in total stress terms. The cohesion values of the fiber-reinforced soils range between 61 kPa and 301 kPa and increase up to seven times in comparison with the cohesion values of the unreinforced soils. The variations of the angle of internal friction of soils due to fiber reinforcement are generally limited to ±25%. The cohesion improvement due to fiber reinforcement is increased with increasing fiber content and fiber length up to 30 mm and is inversely proportional to the fine-grained fraction and the cohesion of the unreinforced soil.
- 9 June 2022
- Published by Springer Nature in International Journal of Geosynthetics and Ground Engineering
- Vol. 8 (3) , 1-11
Compaction Characteristics of Fiber-Reinforced Soils
- 9 June 2022
- Published by Springer Nature in International Journal of Geosynthetics and Ground Engineering
- Vol. 8 (3) , 1-11
Compaction Characteristics of Fiber-Reinforced Soils
- Open Access
- 28 September 2020
- Published by MDPI AG in Geosciences
- Vol. 10 (10) , 389
Rock Mass Characterization of Karstified Marbles and Evaluation of Rockfall Potential Based on Traditional and SfM-Based Methods; Case Study of Nestos, Greece
Rockfall consists one of the most harmful geological phenomena for the man-made environment. In order to evaluate the rockfall hazard, a variety of engineering geological studies should be realized, starting from conducting a detailed field survey and ending with simulating the trajectory of likely to fail blocks in order to evaluate the kinetic energy and the runout distance. The last decade, new technologies, i.e., remotely piloted aircraft systems (RPAS) and light detection and ranging (LiDAR) are frequently used in order to obtain and analyze the characteristics of the rock mass based on a semi-automatic or manual approach. Aiming to evaluate the rockfall hazard in the area of Nestos, Greece, we applied both traditional and structure from motion (SfM)-oriented approaches and compared the results. As an outcome, it was shown that the semi-automated approaches can accurately detect the discontinuities and define their orientation, and thus can be used in inaccessible areas. Considering the rockfall risk, it was shown that the railway line in the study area is threaten by a rockfall and consequently the construction of a rockfall netting mesh or a rock shed is recommended.
- 28 September 2020
- Published by MDPI AG in Geosciences
- Vol. 10 (10) , 389
Open AccessRock Mass Characterization of Karstified Marbles and Evaluation of Rockfall Potential Based on Traditional and SfM-Based Methods; Case Study of Nestos, Greece
Rockfall consists one of the most harmful geological phenomena for the man-made environment. In order to evaluate the rockfall hazard, a variety of engineering geological studies should be realized, starting from conducting a detailed field survey and ending with simulating the trajectory of likely to fail blocks in order to evaluate the kinetic energy and the runout distance. The last decade, new technologies, i.e., remotely piloted aircraft systems (RPAS) and light detection and ranging (LiDAR) are frequently used in order to obtain and analyze the characteristics of the rock mass based on a semi-automatic or manual approach. Aiming to evaluate the rockfall hazard in the area of Nestos, Greece, we applied both traditional and structure from motion (SfM)-oriented approaches and compared the results. As an outcome, it was shown that the semi-automated approaches can accurately detect the discontinuities and define their orientation, and thus can be used in inaccessible areas. Considering the rockfall risk, it was shown that the railway line in the study area is threaten by a rockfall and consequently the construction of a rockfall netting mesh or a rock shed is recommended.