Alok Kumar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Alok Kumar has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Atul Srivastava
Indian Institute of Technology Bombay
6 shared publications - Abinash Mahapatro
Department of Mechanical Engineering, Siksha ‘O’ Anusandhan (Deemed to be University), Bhubaneswar, India
2 shared publications - Jaywant H. Arakeri
Department of Mechanical Engineering, Indian Institute of Science, Bangalore, India
2 shared publications Pinakeswar Mahanta
NIT Arunachal Pradesh
2 shared publicationsBor Abubakr
1 shared publicationJaywant H. Arakeri
1 shared publication
Latest Publications
- Open Access
- 1 June 2026
- Published by Elsevier in SSRN Electronic Journal
Vapor evolution and condensation dynamics in a differentially-heated immiscible DCM-Water layer system: High speed videography and IR measurements
The present study is concerned with the experimental investigation of boiling and condensation characteristics of one of the high volatile fluids as it undergoes phase change in a differentially-heated two-fluids system. The vertically stratified immiscible-fluids system is realized with dichloromethane (DCM), the more volatile component, as the (heavier) bottom fluid and water as the top fluid layer. Phase change in the bottom DCM layer is affected through localized heating using a transparent ITO-coated borofloat glass substrate, triggering nucleate boiling. The resulting vapor bubbles rise through the overlying water layer and condense on a horizontally placed top plate. Synchronized high-speed videography and infrared thermography are employed to resolve key interfacial processes including nucleation, interface deformation, neck formation, pinch-off of entrapped vapor volume, and its condensation at the top plate. An energy balance framework is developed to quantify local heat storage, lateral conduction, natural convection, radiation at the top plate. The analysis shows that lateral conduction within the copper plate constitutes the dominant heat dissipation pathway during condensation. Spatio-temporal variations in surface heat flux around the impact region highlight the influence of localized phase-change events on transient thermal transport. Comparison of the total estimated dissipated energy with the theoretical latent energy corresponding to a pure vapor bubble reveals that the entrapped volume carries a lower effective vapor content. It is thus inferred that the entrapped vapor bubble therefore consists of a composite liquid–vapor mixture, with the liquid fraction estimated to be approximately 45–58% across the tested heat flux range. The presence of this encapsulated liquid layer explains the stability of the rising entrapped volume, which undergoes almost negligible condensation while traversing through the water layer. The insights obtained enhance the understanding of vapor transport and condensation mechanisms in immiscible fluid systems and offer guidance for the development of passive, high-performance thermal management schemes.
- 1 June 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessVapor evolution and condensation dynamics in a differentially-heated immiscible DCM-Water layer system: High speed videography and IR measurements
The present study is concerned with the experimental investigation of boiling and condensation characteristics of one of the high volatile fluids as it undergoes phase change in a differentially-heated two-fluids system. The vertically stratified immiscible-fluids system is realized with dichloromethane (DCM), the more volatile component, as the (heavier) bottom fluid and water as the top fluid layer. Phase change in the bottom DCM layer is affected through localized heating using a transparent ITO-coated borofloat glass substrate, triggering nucleate boiling. The resulting vapor bubbles rise through the overlying water layer and condense on a horizontally placed top plate. Synchronized high-speed videography and infrared thermography are employed to resolve key interfacial processes including nucleation, interface deformation, neck formation, pinch-off of entrapped vapor volume, and its condensation at the top plate. An energy balance framework is developed to quantify local heat storage, lateral conduction, natural convection, radiation at the top plate. The analysis shows that lateral conduction within the copper plate constitutes the dominant heat dissipation pathway during condensation. Spatio-temporal variations in surface heat flux around the impact region highlight the influence of localized phase-change events on transient thermal transport. Comparison of the total estimated dissipated energy with the theoretical latent energy corresponding to a pure vapor bubble reveals that the entrapped volume carries a lower effective vapor content. It is thus inferred that the entrapped vapor bubble therefore consists of a composite liquid–vapor mixture, with the liquid fraction estimated to be approximately 45–58% across the tested heat flux range. The presence of this encapsulated liquid layer explains the stability of the rising entrapped volume, which undergoes almost negligible condensation while traversing through the water layer. The insights obtained enhance the understanding of vapor transport and condensation mechanisms in immiscible fluid systems and offer guidance for the development of passive, high-performance thermal management schemes.
- 28 November 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 261
Non-intrusive experiments on coupled bubble dynamics and heat transfer during nucleate boiling under varying pressure conditions
- 28 November 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 261
Non-intrusive experiments on coupled bubble dynamics and heat transfer during nucleate boiling under varying pressure conditions
- Open Access
- 1 August 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (8)
Coupled bubble dynamics and interaction mechanisms of adjacently nucleated vapor bubbles under subcooled pool boiling regime
The present work investigates the plausible modes of interaction between two adjacently located vapor bubbles growing on high wettability surface during subcooled nucleate pool boiling. The study becomes important as the phenomenon of bubble interaction has a significant impact on the resulting bubble dynamic parameters as well as on microlayer dynamics of the respective vapor bubbles. As against the symmetric growth of microlayer in the case of isolated pool boiling, microlayers of mutually interacting vapor bubbles no longer remain symmetric and tend to deplete relatively faster, thereby influencing the resulting wall heat transfer rates. Toward this, the microlayers and dynamics of adjacently located interacting vapor bubbles have been mapped in a simultaneous manner using thin-film interferometry and high-speed rainbow schlieren deflectometry as a function of varying subcooling levels. Results of the experiments revealed that parameters such as non-dimensional spacing between the two vapor bubbles, supplied heat flux, and degree of subcooling have a strong impact on the mechanism of bubbles' interaction, which, in turn, influence the bubble departure frequency, bubble diameter, and microlayer dynamics. Three dominant modes of bubble interaction, hydrodynamic interaction (HI), thermal interaction (TI), and coalescence (C), were identified as a function of the level of subcooling. Quantification of the experimental data showed that the equivalent diameter of the vapor bubble increases with an increase in the level of heat flux, while it decreases with an increase in the subcooling level. Additionally, the secondary nucleation affects the liftoff time and movement of the primary bubble and can hydrodynamically deplete the microlayer of the first bubble even when the bubbles are far apart, with the depletion rates showing a strong dependence on the growth rate and location of the secondary nucleation.
- 1 August 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (8)
Open AccessCoupled bubble dynamics and interaction mechanisms of adjacently nucleated vapor bubbles under subcooled pool boiling regime
The present work investigates the plausible modes of interaction between two adjacently located vapor bubbles growing on high wettability surface during subcooled nucleate pool boiling. The study becomes important as the phenomenon of bubble interaction has a significant impact on the resulting bubble dynamic parameters as well as on microlayer dynamics of the respective vapor bubbles. As against the symmetric growth of microlayer in the case of isolated pool boiling, microlayers of mutually interacting vapor bubbles no longer remain symmetric and tend to deplete relatively faster, thereby influencing the resulting wall heat transfer rates. Toward this, the microlayers and dynamics of adjacently located interacting vapor bubbles have been mapped in a simultaneous manner using thin-film interferometry and high-speed rainbow schlieren deflectometry as a function of varying subcooling levels. Results of the experiments revealed that parameters such as non-dimensional spacing between the two vapor bubbles, supplied heat flux, and degree of subcooling have a strong impact on the mechanism of bubbles' interaction, which, in turn, influence the bubble departure frequency, bubble diameter, and microlayer dynamics. Three dominant modes of bubble interaction, hydrodynamic interaction (HI), thermal interaction (TI), and coalescence (C), were identified as a function of the level of subcooling. Quantification of the experimental data showed that the equivalent diameter of the vapor bubble increases with an increase in the level of heat flux, while it decreases with an increase in the subcooling level. Additionally, the secondary nucleation affects the liftoff time and movement of the primary bubble and can hydrodynamically deplete the microlayer of the first bubble even when the bubbles are far apart, with the depletion rates showing a strong dependence on the growth rate and location of the secondary nucleation.
- 19 March 2021
- Published by Springer Nature
- p. 555-566
Hydrodynamic Behavior of Sawdust in Pressurized Fluidized Bed
- 19 March 2021
- Published by Springer Nature
- p. 555-566
Hydrodynamic Behavior of Sawdust in Pressurized Fluidized Bed
- 22 November 2020
- Published by Springer Nature
- p. 591-600
Experimental Investigation of Paddy Drying in Rotating Fluidized Bed in Static Geometry
- 22 November 2020
- Published by Springer Nature
- p. 591-600
Experimental Investigation of Paddy Drying in Rotating Fluidized Bed in Static Geometry