KBKlara Bogar

Klara Bogar

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Klara Bogar has a total of 168 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Quantification of locked mode instability triggered by a change in confinement

    by M. Peterka, J. Seidl, T. Markovic, A. Loarte, N.C. Logan, J.-K. Park, P. Cahyna, J. Havlicek, M. Imrisek, L. Kripner, et al.

    This work presents the first analysis of the disruptive locked mode (LM) triggered by the dynamics of a confinement change. It shows that, under certain conditions, the LM threshold during the transient is significantly lower than expected from steady states. We investigate the sensitivity to a controlled n = 1 error field (EF) activated prior to the L-H transition in the COMPASS tokamak, at q 95 ∼ 3, β N ∼ 1, and using EF coils on the high-field side of the vessel. A threshold for EF penetration subsequent to the L-H transition is identified, which shows no significant trend with density or applied torque, and is an apparent consequence of the reduced intrinsic rotation of the 2/1 mode during this transient phase. This finding challenges the assumption made in theoretical and empirical works that natural mode rotation can be predicted by global plasma parameters and urges against using any parametric EF penetration scaling derived from steady-state experiments to define the EF correction strategy in the entire discharge. Furthermore, even at EFs below the identified penetration threshold, disruptive locking of sawtooth-seeded 2/1 tearing modes is observed after about 30% of L-H transitions without external torque.


  • Open Access

    Orbit tomography in constants-of-motion phase-space

    by M. Rud, D. Moseev, F. Jaulmes, K. Bogar, Y. Dong, P.C. Hansen, J. Eriksson, H. Järleblad, M. Nocente, G. Prechel, et al.

    Tomographic reconstructions of a 3D fast-ion constants-of-motion phase-space distribution function are computed by inverting synthetic signals based on projected velocities of the fast ions along the diagnostic lines of sight. A spectrum of projected velocities is a key element of the spectrum formation in fast-ion D-alpha spectroscopy, collective Thomson scattering, and gamma-ray and neutron emission spectroscopy, and it can hence serve as a proxy for any of these. The fast-ion distribution functions are parameterised by three constants of motion, the kinetic energy, the magnetic moment and the toroidal canonical angular momentum. The reconstructions are computed using both zeroth-order and first-order Tikhonov regularisation expressed in terms of Bayesian inference to allow uncertainty quantification. In addition to this, a discontinuity appears to be present in the solution across the trapped-passing boundary surface in the three-dimensional phase space due to a singularity in the Jacobian of the transformation from position and velocity space to phase space. A method to allow for this apparent discontinuity while simultaneously penalising large gradients in the solution is demonstrated. Finally, we use our new methods to optimise the diagnostic performance of a set of six fans of sightlines by finding where the detectors contribute most complementary diagnostic information for the future COMPASS-Upgrade tokamak.


  • Open Access

    Diagnostic weight functions in constants-of-motion phase-space

    by M. Rud, D. Moseev, F. Jaulmes, K. Bogar, J. Eriksson, H. Järleblad, M. Nocente, G. Prechel, B.C.G. Reman, B.S. Schmidt, et al.

    The fast-ion phase-space distribution function in axisymmetric tokamak plasmas is completely described by the three constants of motion: energy, magnetic moment and toroidal canonical angular momentum. In this work, the observable regions of constants-of-motion phase-space, given a diagnostic setup, are identified and explained using projected velocities of the fast ions along the diagnostic lines-of-sight as a proxy for several fast-ion diagnostics, such as fast-ion D α spectroscopy, collective Thomson scattering, neutron emission spectroscopy and gamma-ray spectroscopy. The observable region in constants-of-motion space is given by a position condition and a velocity condition, and the diagnostic sensitivity is given by a gyro-orbit and a drift-orbit weighting. As a practical example, 3D orbit weight functions quantifying the diagnostic sensitivity to each point in phase-space are computed and investigated for the future COMPASS-Upgrade and MAST-Upgrade tokamaks.


  • Open Access

    Experimental evidence of very short power decay lengths in H-mode discharges in the COMPASS tokamak

    by J Hecko, M Komm, M Sos, J Adamek, P Bilkova, K Bogar, P Bohm, F Jaulmes, I Mysiura, M Tomes, et al.

    Analysis of heat fluxes in scrape-off layer (SOL) plasma is important for the prediction of divertor tile heat loads in future reactor-sized tokamak machines. Typically, the radial heat flux profile can be accurately characterized by the decay length parameter λ q . The predictions are then based on the dependence of λ q on plasma and machine parameters. In recent years, several empirical scaling models were derived from a collective database of decay lengths observed in several large tokamaks as well as two spherical tokamaks. Most recently, a report from the TCV tokamak showed a deviation from several of the proposed models (Maurizio et al (TCV team) 2021 Nucl. Fusion 61 024003). In this work, ∼ 100 edge plasma profiles of ELMy H-mode discharges were collected from the COMPASS tokamak database for heat flux analysis. The COMPASS tokamak has a similar machine size and plasma parameters to the TCV tokamak, offering a valuable comparison. The λ q was measured in both downstream and upstream SOL utilizing a divertor probe array validated by an IR camera and Thomson scattering diagnostics. A comparison with the predictions of several scaling models indicated an occurrence of anomalously short (by a factor of 2–5) inter-ELM power decay lengths in both upstream and downstream, as well as a difference in λ q between these two regions. Possible causes related to the accuracy of magnetic reconstruction were eliminated and physics-based sources of apparent compression effects were hypothesized as a motivation for future research.


  • Characterisation of the auxiliary heating power delivered by the 40 keV neutral beam injectors on the COMPASS tokamak

    by K Bogar, J Varju, J Havlicek, J Stockel, A Podolnik, M Hron, R Panek

    Two identical neutral beam injectors (NBIs) have been installed on the COMPASS tokamak. Each of them is capable of producing a deuterium (or hydrogen, helium) neutral beam with nominal power of up to 400 kW at 40 keV. Since the COMPASS tokamak is a compact machine, the design of the neutral beams was carefully optimized to fit the neutral beam through the narrow ports of the tokamak. However, once the neutral beams are operated out of the scope of their optimal parameters, additional power losses occur due to neutral beam scraping. This article investigates the amount of power loss due to neutral beam scraping. The losses are calculated using the neutral beam models and measured neutral beam parameters. The calculated results are compared with the measured power delivered into the plasma. Two different neutral beam models are employed. One describes the neutral beam as a sum of small beamlets, which are Gaussian-like. The second one describes the neutral beam as a single Gaussian beam. The amount of the power lost to scraping is determined by both models and compared. Neutral beam parameters, the input parameters for both models, are derived from the Doppler-shifted spectra emitted by fast neutral atoms. It is shown that when operating NBIs at nominal parameters, the scraping losses are negligible ( < 5% ). If the NBIs are operated too far from the nominal parameters, the scraping losses can reach up to ∼60% of the NBI output power. As the highest fractional losses occur with low power NBI, the beam duct is capable of withstanding the corresponding power loads. The expected auxiliary heating power P A U X , the power entering the tokamak chamber carried by fast neutrals, is benchmarked against the additional plasma input power observed in the measured plasma parameters P N B I . The additional plasma input power P N B I is derived from the plasma power balance. The power balance terms are independent of the neutral beam model used for the auxiliary heating power calculation P A U X . The results of the power balance evaluation reveal a difference between two NBIs installed on COMPASS. One of the injectors systematically delivers 17% less power than the other into the plasma given the same beam parameters. It is concluded that the additional losses occur before the beam enters the tokamak chamber.


  • Numerical modelling for beam duct heat loads calculations and application to the new 1 MW neutral beam injector in the COMPASS tokamak

    by F Jaulmes, G Zadvitskiy, K Bogar, I Mysiura, J Varju, M Jeřáb, M Komm, M Imrisek, The COMPASS Team

    We introduce detailed numerical modelling of the fast neutral particles inside the duct of a new neutral beam injector (NBI) recently installed at the COMPASS tokamak (major radius R 0 = 0.56 m , vessel midplane minor radius a = 0.23 m , toroidal field B t = 0.9–2.1 T ). This new NBI system is able to deliver 1 M W power to the plasma at nominal injection energy of 80 k e V . Collisions with the background neutrals inside the beam duct give birth to fast ions according to the density of the gas and tabulated cross-sections. The ion trajectories are then computed in the complete 3D magnetic field, showing the importance of the stray magnetic field and the magnitude of the field within the gap in between toroidal coils.During the experimental campaign dedicated to the new 1 MW NBI, the beam duct heating was measured by a row of thermocouples located on the top-half of the beam duct. The fast ions collisions with the duct wall cause a local temperature increase with a characteristic pattern. In COMPASS, the location of the fast ions power deposition measured experimentally is in qualitative agreement with modelling of ion losses when following them after the re-ionization process. We trace back the details of the orbits corresponding to deposition at the hot-spot inside the beam duct. Quantitative comparison between the experiment and the simulation shows that a larger than expected amount of neutral gas was inside the duct and this study will guide the design of the future NBI duct in COMPASS Upgrade.


  • Open Access

    Overview of the COMPASS results *

    by M. Hron, J. Adámek, J. Cavalier, R. Dejarnac, O. Ficker, O. Grover, J. Horáček, M. Komm, E. Macúšová, E. Matveeva, et al.

    COMPASS addressed several physical processes that may explain the behaviour of important phenomena. This paper presents results related to the main fields of COMPASS research obtained in the recent two years, including studies of turbulence, L–H transition, plasma material interaction, runaway electron, and disruption physics: Tomographic reconstruction of the edge/SOL turbulence observed by a fast visible camera allowed to visualize turbulent structures without perturbing the plasma. Dependence of the power threshold on the X-point height was studied and related role of radial electric field in the edge/SOL plasma was identified. The effect of high-field-side error fields on the L–H transition was investigated in order to assess the influence of the central solenoid misalignment and the possibility to compensate these error fields by low-field-side coils. Results of fast measurements of electron temperature during ELMs show the ELM peak values at the divertor are around 80% of the initial temperature at the pedestal. Liquid metals were used for the first time as plasma facing material in ELMy H-mode in the tokamak divertor. Good power handling capability was observed for heat fluxes up to 12 MW m−2 and no direct droplet ejection was observed. Partial detachment regime was achieved by impurity seeding in the divertor. The evolution of the heat flux footprint at the outer target was studied. Runaway electrons were studied using new unique systems—impact calorimetry, carbon pellet injection technique, wide variety of magnetic perturbations. Radial feedback control was imposed on the beam. Forces during plasma disruptions were monitored by a number of new diagnostics for vacuum vessel (VV) motion in order to contribute to the scaling laws of sideways disruption forces for ITER. Current flows towards the divertor tiles, incl. possible short-circuiting through PFCs, were investigated during the VDE experiments. The results support ATEC model and improve understanding of disruption loads.


  • Experimental study of ELM induced fast-ion transport using passive FIDA spectroscopy at the ASDEX Upgrade tokamak

    by Anton Jansen van Vuuren, Benedikt Geiger, Philip Adrian Schneider, Klara Bogar, Peter Zsolt Poloskei, Andres Cathey, Matthias Hoelzl, Asger Schou Jacobsen, Marco Cavedon, Ralph Dux, et al.

    Measurements using a recently installed edge fast-ion D-alpha (FIDA) diagnostic at the ASDEX Upgrade tokamak show a clear effect of edge localised modes (ELMs) on the passive FIDA signals. While a reduction in the passive FIDA emission is observed in the scrape-off layer (SOL) region, measurements close to the last closed flux surface show an increase in signals shortly after ELMs, followed by a decrease. The decrease provides a clear sign of fast-ion losses in the SOL, while the increase can be explained by an enhanced neutral density during ELMs inside the plasma. In addition, small ELMs are observed, which barely change the neutral density and plasma position but still cause significant changes in the passive FIDA signals. A comparison of the measurements with forward modelling shows that 60% to 80% of the fast ions are lost by ELMs outside the last closed flux surface. In addition, a 20% decrease of the fast-ion density in a range up to 4 cm within the last closed flux surface can be inferred. This range agrees well with the latest modelling results of ELMs using the non-linear MHD code JOREK and shows that less than 0.3% of all fast ions are lost by ELMs.


  • Direct determination of midplane background neutral density profiles from neutral particle analyzers

    by Klara Bogar, Benedikt Geiger, Philip Adrian Schneider, Anton Jansen Vanvuuren, Ondrej Grover

    Here we present a new method that allows the determination of background neutral density profiles based on measurements from neutral particle analyzers (NPA). Bayesian optimization is used to obtain a reliable 5-parameter representation of the inferred profiles. The method has been benchmarked using forward modelling from FIDASIM against measured data. The systematic errors coming from assumptions made in the analysis were evaluated and they are lower than ≲5%. The new method has been tested using data from the ASDEX Upgrade tokamak. When using reconstructed neutral density profiles, good agreement is found between the measured NPA fluxes of neutralized fast ions with predictions based on TRANSP and FIDASIM. Moreover, a clear drop of neutral density is observed at the plasma boundary after edge localized mode (ELM) activity. As suggested by KN1D simulations, this drop is mainly due to an increase of scrape-off layer (SOL) ionization rate, resulting from higher SOL plasma densities and temperatures after the ELM crash. Moreover, the new method allows calculating the local plasma ionization source which will be important for future transport studies.