Aleksandar Rajčić
Research Subjects
Aleksandar Rajčić has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Bojana Zeković
University of Belgrade , Faculty of Architecture , Republic of Serbia
2 shared publications - Dušan Ignjatović
Department of Architectural Technologies, Faculty of Architecture, University of Belgrade, 11000 Belgrade, Serbia
2 shared publications - Ljiljana Đukanović
University of Belgrade
2 shared publications - Nataša Ćuković Ignjatović
University of Belgrade — Faculty of Architecture
2 shared publications - Ana Radivojević
University of Belgrade
1 shared publication - Andrej Josifovski
Faculty of Architecture, University of Belgrade, 11000 Belgrade, Serbia
1 shared publication
Latest Publications
- Open Access
- 1 June 2025
- Published by Faculty of Civil Engineering and Architecture, University of Nis in Journal of the Faculty of Civil Engineering and Architecture
- Vol. 40 (1) , 49-58
SOME DEEP FREEZE STORAGE HEAT TRANSFER PROBLEMS
The paper discusses the specific problems that occur with deep freeze storages, from the aspect of building physics. A special review is given of the phenomenon of soil stability, i.e. soil bearing capacity, in the context of soil freezing, deformations of the floor structure, and functional disorders in the interior of deep freeze stores.A case from practice was presented, in which serious problems occurred in the process of exploitation, which led to the fact that the existing floor structure with all layers had to be completely demolished, a new one constructed with newly designed layers, as well as to improve the connection with existing facade construction.An analysis of the causes and a proposal for a solution for that building are presented. The focus of the work is on the design concept of the relevant wall and floor structures, the calculation of the temperature in the ground under the building, considering conditions of operation that are specific and include a very low interior temperature of -27°C, a low winter design temperature of the external air -15°C, with an emphasis on the necessity of application of an adequate heat system of under-slab structure. The paper provides recommendations that engineers can use in similar cases.
- 1 June 2025
- Published by Faculty of Civil Engineering and Architecture, University of Nis in Journal of the Faculty of Civil Engineering and Architecture
- Vol. 40 (1) , 49-58
Open AccessSOME DEEP FREEZE STORAGE HEAT TRANSFER PROBLEMS
The paper discusses the specific problems that occur with deep freeze storages, from the aspect of building physics. A special review is given of the phenomenon of soil stability, i.e. soil bearing capacity, in the context of soil freezing, deformations of the floor structure, and functional disorders in the interior of deep freeze stores.A case from practice was presented, in which serious problems occurred in the process of exploitation, which led to the fact that the existing floor structure with all layers had to be completely demolished, a new one constructed with newly designed layers, as well as to improve the connection with existing facade construction.An analysis of the causes and a proposal for a solution for that building are presented. The focus of the work is on the design concept of the relevant wall and floor structures, the calculation of the temperature in the ground under the building, considering conditions of operation that are specific and include a very low interior temperature of -27°C, a low winter design temperature of the external air -15°C, with an emphasis on the necessity of application of an adequate heat system of under-slab structure. The paper provides recommendations that engineers can use in similar cases.
- Open Access
- 1 January 2024
- Published by Centre for Evaluation in Education and Science (CEON/CEES)
- No. Invited pa,p. 3-12
The most important position in the thermal envelope of the building: Heat transfer aspect
When considering the positions of the thermal envelope of buildings, we usually talk about facade walls first. The situation is similar in the education process - the principles of building physics are taught precisely on facade walls, while other positions in contact with outside or unheated air are given less or no attention. This paper presents a statistical analysis conducted on a sample of personally designed and realized new buildings, residential (over 246,000 m2 ) and business functions (over 116,000 m2 ), which aims to provide an answer to the dilemma of which position of the thermal envelope is the most significant with aspects of heat losses and gains. The text analyses the percentage share of different positions of the thermal envelope in transmission heat losses. The results unequivocally show that the dominant heat transmission takes place through transparent positions, over 50% of all heat losses, even up to 85%, and the same is true when solar heat gains are considered. It can be concluded that it is necessary to pay more attention to the characteristics of transparent positions of the thermal envelope.
- 1 January 2024
- Published by Centre for Evaluation in Education and Science (CEON/CEES)
- No. Invited pa,p. 3-12
Open AccessThe most important position in the thermal envelope of the building: Heat transfer aspect
When considering the positions of the thermal envelope of buildings, we usually talk about facade walls first. The situation is similar in the education process - the principles of building physics are taught precisely on facade walls, while other positions in contact with outside or unheated air are given less or no attention. This paper presents a statistical analysis conducted on a sample of personally designed and realized new buildings, residential (over 246,000 m2 ) and business functions (over 116,000 m2 ), which aims to provide an answer to the dilemma of which position of the thermal envelope is the most significant with aspects of heat losses and gains. The text analyses the percentage share of different positions of the thermal envelope in transmission heat losses. The results unequivocally show that the dominant heat transmission takes place through transparent positions, over 50% of all heat losses, even up to 85%, and the same is true when solar heat gains are considered. It can be concluded that it is necessary to pay more attention to the characteristics of transparent positions of the thermal envelope.
- Open Access
An Approach to In Situ Evaluation of Timber Structures Based on Equalization of Non-Destructive and Mechanical Test Parameters
This paper addresses the challenges in evaluating the structural performance of built structures using non-destructive methods and in situ tests. Such an examination of structural properties, without their sampling, is a diagnostic improvement, especially for historical heritage buildings, where it is not allowed to violate their physical integrity. Therefore, the research proposes a non-destructive testing method based on the equalization of the mechanically and non-destructively determined parameters of the strength of built-in timber. The research included three phases: (1) a preliminary examination; (2) a calibration procedure of the non-destructive method, and (3) in situ application of the established non-destructive method. The preliminary examination involved testing specimens using X-rays and ultrasonic waves by directing them, analogous to mechanical testing, in the fibers’ longitudinal, radial, and tangential directions. In the second phase, it was shown that equalizing the parameters of mechanical and non-destructive testing using ultrasound and X-rays of timber was feasible. Furthermore, mechanical calibration was conducted to establish an applicable non-destructive in situ method. Finally, in the third phase, an in situ assessment of timber architectural elements confirms the effectiveness of the suggested non-destructive approach in diagnosing architectural structures.
Open AccessAn Approach to In Situ Evaluation of Timber Structures Based on Equalization of Non-Destructive and Mechanical Test Parameters
This paper addresses the challenges in evaluating the structural performance of built structures using non-destructive methods and in situ tests. Such an examination of structural properties, without their sampling, is a diagnostic improvement, especially for historical heritage buildings, where it is not allowed to violate their physical integrity. Therefore, the research proposes a non-destructive testing method based on the equalization of the mechanically and non-destructively determined parameters of the strength of built-in timber. The research included three phases: (1) a preliminary examination; (2) a calibration procedure of the non-destructive method, and (3) in situ application of the established non-destructive method. The preliminary examination involved testing specimens using X-rays and ultrasonic waves by directing them, analogous to mechanical testing, in the fibers’ longitudinal, radial, and tangential directions. In the second phase, it was shown that equalizing the parameters of mechanical and non-destructive testing using ultrasound and X-rays of timber was feasible. Furthermore, mechanical calibration was conducted to establish an applicable non-destructive in situ method. Finally, in the third phase, an in situ assessment of timber architectural elements confirms the effectiveness of the suggested non-destructive approach in diagnosing architectural structures.
- Open Access
- 30 March 2022
- Published by MDPI AG in Sustainability
- Vol. 14 (7) , 4074
Energy Refurbishment of Serbian School Building Stock—A Typology Tool Methodology Development
Energy refurbishment of school buildings is a priority regarding both energy consumption in buildings and improving comfort conditions for sensitive young occupants. During 2016–18, a group of teachers and associates from the Faculty of Architecture, Mechanical Engineering, and Electrical Engineering from the University in Belgrade participated in the project “Energy efficiency in public buildings” in cooperation with GIZ (Deutsche Gesellschaft für Internationale Zusammenarbeit), University of Belgrade, Faculty of Architecture and Ministry of Mining and Energy of the Republic of Serbia. During 2016 and 2017, a comprehensive survey and database of public buildings were conducted by the local community. The focus of the research was the facilities of children’s institutions, and detailed data were collected to determine the current building stock conditions, energy consumption, and possible improvements. This paper presents the methodology of the project based on defining the typology of buildings, determining the representatives of the characteristic periods of construction, and analyzing their energy performance. Five possible scenarios were considered: designed condition, existing state, and three levels of a building improvement. The main goal of this project was to ascertain the entire fund for school buildings, indicate the potential for energy savings of this type of public building at the national level, and use this as a starting point for developing strategic decisions and further energy efficiency policies. This paper presents the complete results of the research on school buildings in Serbia, their energy performance, and possible energy savings. Key findings show that a great majority of schools are in a poor state in terms of their energy efficiency, but at the same time, there is a large potential for improvement of building envelope, HVAC, and lighting systems, which can cut the current energy need for heating to up to 80%.
- 30 March 2022
- Published by MDPI AG in Sustainability
- Vol. 14 (7) , 4074
Open AccessEnergy Refurbishment of Serbian School Building Stock—A Typology Tool Methodology Development
Energy refurbishment of school buildings is a priority regarding both energy consumption in buildings and improving comfort conditions for sensitive young occupants. During 2016–18, a group of teachers and associates from the Faculty of Architecture, Mechanical Engineering, and Electrical Engineering from the University in Belgrade participated in the project “Energy efficiency in public buildings” in cooperation with GIZ (Deutsche Gesellschaft für Internationale Zusammenarbeit), University of Belgrade, Faculty of Architecture and Ministry of Mining and Energy of the Republic of Serbia. During 2016 and 2017, a comprehensive survey and database of public buildings were conducted by the local community. The focus of the research was the facilities of children’s institutions, and detailed data were collected to determine the current building stock conditions, energy consumption, and possible improvements. This paper presents the methodology of the project based on defining the typology of buildings, determining the representatives of the characteristic periods of construction, and analyzing their energy performance. Five possible scenarios were considered: designed condition, existing state, and three levels of a building improvement. The main goal of this project was to ascertain the entire fund for school buildings, indicate the potential for energy savings of this type of public building at the national level, and use this as a starting point for developing strategic decisions and further energy efficiency policies. This paper presents the complete results of the research on school buildings in Serbia, their energy performance, and possible energy savings. Key findings show that a great majority of schools are in a poor state in terms of their energy efficiency, but at the same time, there is a large potential for improvement of building envelope, HVAC, and lighting systems, which can cut the current energy need for heating to up to 80%.
- Open Access
- 12 April 2021
- Published by MDPI AG in Sustainability
- Vol. 13 (8) , 4262
Methodology for Residential Building Stock Refurbishment Planning—Development of Local Building Typologies
This paper presents the methodology for the implementation of building typology principles as a tool for the strategic planning of residential building stock energy retrofits on a municipal level in Serbia. Research was conducted under the IEE EPISCOPE (Intelligent Energy Europe EPISCOPE/TABULA project) project with the aim of developing an adequate tool for creating building stock energy retrofit management strategies on a local level. An approach that envisions the diversity and uneven spatial distribution of building stock in smaller scale municipalities and includes statistically relevant sampling of all relevant building types was developed and tested in the pilot project that focused on the city of Vršac. Two options for local typology development were formulated: a top-down approach, which relies on the data from the national typology or other available databases by reducing them to the local level, and a bottom-up approach, which represents a new data gathering and processing method. Both approaches were tested in the pilot project and the results are compared in this paper. From the conclusions of these analyses, a common methodology for the development of local building typologies has been defined. It can be used in the strategic planning of building stock, whether for the purpose of developing local energy action plans (LEAPs) or other purposes internationally.
- 12 April 2021
- Published by MDPI AG in Sustainability
- Vol. 13 (8) , 4262
Open AccessMethodology for Residential Building Stock Refurbishment Planning—Development of Local Building Typologies
This paper presents the methodology for the implementation of building typology principles as a tool for the strategic planning of residential building stock energy retrofits on a municipal level in Serbia. Research was conducted under the IEE EPISCOPE (Intelligent Energy Europe EPISCOPE/TABULA project) project with the aim of developing an adequate tool for creating building stock energy retrofit management strategies on a local level. An approach that envisions the diversity and uneven spatial distribution of building stock in smaller scale municipalities and includes statistically relevant sampling of all relevant building types was developed and tested in the pilot project that focused on the city of Vršac. Two options for local typology development were formulated: a top-down approach, which relies on the data from the national typology or other available databases by reducing them to the local level, and a bottom-up approach, which represents a new data gathering and processing method. Both approaches were tested in the pilot project and the results are compared in this paper. From the conclusions of these analyses, a common methodology for the development of local building typologies has been defined. It can be used in the strategic planning of building stock, whether for the purpose of developing local energy action plans (LEAPs) or other purposes internationally.