MAMert Altintas

Mert Altintas

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Mert Altintas has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Maintaining Synchronous Operation of a Damperless Dual-Port Tooth-Coil-Winding PMSG

    by Hüseyin Tayyer Canseven, Mert Altıntaş, Ali Bakbak, Murat Ayaz, Erkan Meşe, Juha Pyrhönen

    The stability of a wind turbine-rotated synchronous generator must be maintained during a sudden change in wind speed or direction. In integral slot winding machines this task is taken care of by rotor damper windings. Tooth-coil permanent magnet generators cannot, however, have a damper winding in the rotor because of the high harmonic content of the air gap. In this paper, we study a possibility to stabilize PMSG damperless synchronous operation by dividing the generator stator winding into two parts - power winding (PW) and control winding (CW). We call this machine a dual-port PMSG (DPPMSG). The PW is directly connected to the grid. Therefore, the generator rotates, in average, at a fixed speed. On the other hand, the CW is connected to the grid through a four-quadrant power converter. The CW has three different tasks: It is responsible for the startup process, damping of speed oscillations and, of course, power generation. Electrical and magnetic decoupling of the winding sets is ensured by concentrated wound coils. The number of stator coils allocated to a winding set determines its power level. Different power levels of winding sets are analytically analyzed for wind gust speeds according to the IEC 61 400 standard. The results are verified by experimental tests.


  • Maximizing Energy Extraction from Direct Grid Coupled PMSG For Wind Energy Conversion Systems

    by Ali Bakbak, Huseyin Tayyer Canseven, Murat Ayaz, Mert Altintas, Erkan Mese

    Direct grid coupling of permanent magnet synchronous generators (PMSG) for wind energy conversion systems provides certain advantages with the penalties of maximum power point tracking (MPPT) and reactive power control. This article proposes a novel PMSG design philosophy such that optimizing PMSG design at the initial stage would compensate for the drawbacks arising from the lack of an MPPT algorithm. Also, the ability to maintain a high PF across a wide range of operating power levels is investigated by considering reactive power in the design process. In this article, optimization of slot/pole combination is described for direct grid coupled PMSGs to extract as much energy as possible according to wind data. A new benchmark, adequacy factor, is presented to determine the slot/pole combination. Variation of the reactive power is theoretically analyzed. A relationship is established between induced electromotive force, synchronous inductance values of machines, and the PF. Fixed and variable speed operations of PMSGs are compared in terms of annual energy yield. Finally, theoretical analyses are validated through laboratory testing of prototype generators.


  • Open Access

    PMSG-Based Dual-Port Wind-Energy Conversion System With Reduced Converter Size

    by Ali Bakbak, Mert Altintas, Murat Ayaz, Huseyin Tayyer Canseven, Mutlu Boztepe, Ozkan Akin, Erkan Mese

    In this study, a dual-port wind-energy conversion system has been proposed. A double-fed permanent-magnet synchronous generator (DFPMSG) forms the central part of the system, where the concentrated single-layer winding configuration of the generator enables electric and magnetic isolation between the ports. DFPMSG has two three-phase terminals out of the stator; one is connected directly to the grid, whereas the other is tied to the grid through a back-to-back converter. This study investigates design issues caused by the DFPMSG port with a direct grid connection. The unique design issues of the proposed system include determining the slot/pole combination using wind data and determining the minimum reactive power requirement for the port with a direct grid connection. Next, the load-sharing capability among the ports of the proposed system is presented through a detailed investigation of three schemes. Experimental work is presented for a 5-kW prototype DFPMSG system to illustrate the isolation among the ports, minimized reactive power demand on the port with direct grid connection, and load-sharing ability among the ports for different control schemes.