NMNathan Meulenbroek

Nathan Meulenbroek

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Nathan Meulenbroek has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Ultrasound computer tomography using single-element directivity measurements

    by Nathan Meulenbroek, Samuel Pichardo

    PurposeUltrasound computer tomography (UCT) is a promising medical imaging method for various applications such as the breast and brain. Current UCT image reconstruction methods fall broadly into two categories: time-of-flight (TOF)-based ray-tracing methods and full-waveform inversion (FWI) methods. Ray tracing methods are computationally efficient but often have blurred edges and low spatial resolution, whereas FWI methods demonstrate excellent image quality at high computational cost. To improve the image quality of ray-based methods without greatly increasing their computational cost, we propose bent-ray UCT reconstruction using direction of arrival (DOA) information rather than TOF information.ApproachDOA- and TOF-UCT methods are evaluated in silico using two-dimensional Shepp–Logan and breast tissue phantoms with speeds of sound ranging from 1460 to 1580 m/s. Both the Shepp–Logan and breast tissue phantoms were imaged with 128-element ring arrays with diameters of 38.5 and 21 cm, operating frequencies of 350 and 600 kHz, and resolutions of 0.71 and 0.41 mm, respectively. Initial measurements were derived from a finite-difference time-difference solution of the viscoelastic wave equation.ResultsWe demonstrate that DOA-UCT images have sharper edges and improved structural similarity to ground-truth images than conventional TOF-UCT. DOA-UCT reconstruction is also able to reconstruct images at multiple time points and with various window sizes, reducing the need to find an exact signal onset.ConclusionsTo the best of our knowledge, this is the first demonstration of a bent-ray UCT algorithm that uses only DOA information, without TOF information.

  • Ultrasound imaging using single-element biaxial beamforming

    by Nathan Meulenbroek, Laura Curiel, Adam Waspe, Samuel Pichardo

    PurposeDynamic focusing of received ultrasound signals, or beamforming, is foundational for ultrasound imaging. Conventionally, it requires arrays of ultrasound sensors to estimate where sound came from using time-of-flight (TOF) measurements. We demonstrate passive beamforming with a single biaxial sensor and accurate passive acoustic mapping with two biaxial sensors using only direction of arrival (DOA) information.ApproachWe introduce two single-element biaxial beamforming algorithms and four biaxial image reconstruction algorithms for a two-element biaxial piezoceramic transducer array. Imaging of a hemispherical acoustic source is characterized in an acoustic scanning tank within the region −30.29 mm ≤x≤ 29.94 mm and 50.11 mm ≤z≤ 90.45 mm relative to the center of the array. Imaging performance is contrasted with delay, sum, and integrate (DSAI) and delay, multiply, sum, and integrate (DMSAI) algorithms.ResultsSingle-element biaxial beamforming can identify DOA with a median error (± interquartile range) of 0.36±0.63 deg and median full-width half-prominence of 7.3±8.6 deg. Using both array elements, DOA-only images demonstrate overall median localization error of 6.41 mm (lateral: 1.02 mm, axial: 5.85 mm, signal-to-noise ratio (SNR): 15.37) and DOA + TOF images demonstrate overall median error of 6.91 mm (lateral: 1.69 mm, axial: 6.11 mm, SNR: 18.37).ConclusionsTo the best of our knowledge, we provide the first demonstration of single-element beamforming using a single stationary piezoceramic and the first demonstration of passive ultrasound imaging without the use of TOF information. These results enable simpler, smaller, more cost-effective arrays for passive ultrasound imaging.

  • Passive Directivity Detection Using Individual Biaxial Ultrasound Transducers

    by Nathan E. Meulenbroek, Sagid Delgado, Laura Curiel, Adam C. Waspe, Samuel Pichardo

    Biaxial transducers are an emerging technology that can steer generated ultrasound waves using a single piezoceramic component. Simulations have also shown that biaxial transducers can passively estimate the direction of arrival of sound waves when operating in receive mode. This research seeks to experimentally verify biaxial directivity estimates and establish directivity as an independent parameter detected by biaxial transducers. Three cuboid (3.84 mm x 3.84 mm x 5.92 mm) biaxial piezoceramics with two pairs of orthogonal electrodes (one pair applied laterally and one pair applied in the polling direction) were manufactured and characterized. Each transducer was placed in a water tank where an independent hemispherical source was attached to a moveable arm and operated at 250 kHz. Terminal voltages were recorded for eighty-one source positions in a plane parallel to the transducer’s front face and at a depth of approximately 9 cm. Collection was repeated three times per transducer to ensure reproducibility. In-silico results were compared with the experimental results. Two derived metrics were then calculated using both the forward and lateral terminal voltages: the phase difference and amplitude ratio. Biaxial transducers demonstrate an ability to estimate the direction of arrival of incident sound waves, independently of any time-of-flight information. The phase difference and amplitude ratio complement each other to provide statistically significant and repeatable estimates over a range of 48 degrees (from -24 degrees to +24 degrees). These results can be used to augment a variety of medical, geophysical, and industrial passive ultrasound imaging techniques.


  • Open Access

    Multiple Linear Regression Estimation of Onset Time Delay for Experimental Transcranial Narrowband Ultrasound Signals

    by Nathan Earl Meulenbroek, Samuel Pichardo

    Focused Ultrasound is an emerging medical technique for transcranial procedures and requires the precise modelling of ultrasound signal propagation through the skull. To verify models, the onset time delay between two signals measured at the same spatial location, with and without the presence of a skull in the path of the signal, is compared between simulations and experiments. Current methods to automatically identify onset time delay use correlation-based algorithms. However, these techniques suffer from poor results caused by signal distortion and low signal-to-noise ratios in experimental signals. In this study, we compare the effectiveness of machine learning (multiple linear regression) to three correlation-based time delay estimation techniques in estimating the onset time delay of a signal pair. A sample of 1643 signal pairs, with center frequencies of either 270 kHz or 836 kHz, had their delays manually identified as a benchmark. Density, thickness, incidence angle, frequency, and x and y offsets from center were used as predictors. We find that, compared to manual identification, machine learning is 80.4% more accurate than cross-correlation across all test signals, and is noise-independent through all noise bins. The median of the errors were less than 0.3 periods was observed for signals with frequency 270 kHz, and less than 1.1 periods for signals with frequency 836 kHz, with little estimate bias. Overall, linear multivariable regression is determined to provide the best estimate of the onset time delay of two signals.