Gokhan Apaydin

In this study, CeO₂ thin films were produced using the spin coting method, which is one of the sol–gel methods, in six different molarities. X-ray diffraction (XRD) patterns revealed the characteristic peaks of the films, while Field Emission Scanning Electron Microscopy (FESEM) confirmed their homogeneous structure. Then, radiation shielding parameters like linear absorption coefficient (LAC), mass absorption coefficient (MAC), tent value layer (TVL), mean free path (MFP), and half value layer (HVL) were thoroughly examined. The results showed that increasing molarity had a significant effect on the thickness values of thin films and the absorption parameters were found to improve with increasing molarity. Both LAC and MAC values decrease as the energy level increases, but the increase in CeO₂ molarity leads to a strong increase on these coefficients. The HVL value was also found to be 0.42 cm at the lowest energy of 14.957 keV and to be around 10 cm at the greatest energy of 59.543 keV (0.05 M). When the radiation energy applied to the material was raised from 14.957 keV to 59.543 keV, it was found that the MFP values of 0.05 M CeO₂ thin films grew gradually from 0.61 cm to 14.51 cm. High energy radiation of 59.543 keV and a low density (0.05 M) medium resulted in peak TVL values of 33.423 cm, allowing the radiation to pass through the material with minimal interaction.

The objective of this study was to analyze the metal content in the organs of Oncorhynchus mykiss, commonly known as rainbow trout, at 12 different locations within the cages located in Karacaören II Dam Lake. The metal contents in fish samples were analyzed using a PANalytical Epsilon5 energy dispersive X-ray fluorescence (EDXRF) spectrometer. We will analyze the findings by displaying the fluctuating metal concentrations in various internal organs over the seasons.

In this study, the seasonal metal pollution of sediment samples taken from twelve distinct notes of the Karacaören II Dam Lake was examined. The quantity of metal in soil samples was determined using energy dispersive X-ray fluorescence spectroscopy. The geoaccumulation index and enrichment factor expressions were created using the metal concentrations found in the sediments. Seasonal values at the local, state, and international levels were compared to the findings. The ratios of the elements copper, zinc, lead, arsenic, nickel, chromium, and mercury, measured in parts per million (ppm), were found to be 42-96, 53-78, 11-14, 4-7, 233-244, and 611-711, respectively. There is also discussion of the sediments' elemental composition and degree of pollution. In contrast, it was found that the Urbach energy increased from 0.246 eV to 0.630 eV with increasing levels of V2O5. These synthetic glasses' densities and molar volumes were also investigated and discussed.

In the present study, the concentration levels of heavy metals such as Mn, Fe, Ni, Cu, Zn, Cr, and Pb in sediment samples collected from 16 sampling locations in the Middle and Eastern Black Sea regions, Turkey, were measured using energy dispersive X-ray fluorescence spectroscopy (EDXRF). Various pollution parameters and methods, such as the enrichment factor (EF), geo-accumulation index (I_geo), contamination factor (CF), pollution load index (PLI), ecological risk index (RI), and geo-spatial distribution patterns, were used to assess the pollution status, ecological risks, and sources of metals in sediment in detail. The mean concentrations of Mn, Fe, Ni, Cu, Zn, Cr, and Pb were found to be 565.38, 46,000, 34.38, 104.06, 109.88, 87.31, and 32.31 mg/kg, respectively. Results showed that the mean concentrations of Cu, Zn, and Pb exceeded the crustal shale value, with the exception of Mn, Fe, Ni, and Cr. According to the calculated pollution parameters, although minimal or moderate pollution was detected in the area investigated, it was determined that there was a very low ecological risk. Multivariate statistical analysis results showed that Cu, Zn, and Pb levels in the investigated region were slightly influenced by anthropogenic inputs such as mining and agricultural practices. In addition, the geo-spatial distributions of Cu, Zn, Fe, and Pb were found to be higher in this region due to the mining activities carried out in the Eastern Black Sea region.

In the present study, the concentration levels of heavy metals such as Mn, Fe, Ni, Cu, Zn, Cr and Pb in sediment samples collected from 16 sampling locations in the Middle and Eastern Black Sea regions, Turkey was measured using energy dispersive X–ray fluorescence spectroscopy (EDXRF). Various pollution parameters and methods, such as the enrichment factor (EF), geo–accumulation index (I_geo), contamination factor (CF), pollution load index (PLI), ecological risk index (RI), and geo–spatial distribution patterns were used to assess in detail the pollution status, ecological risks and sources of metals in sediment. The mean concentrations of Mn, Fe, Ni, Cu, Zn, Cr and Pb were found to be 565.38, 46,000, 34.38, 104.06, 109.88, 87.31, and 32.31 mg/kg, respectively. Results showed that the mean concentrations of Cu, Zn and Pb exceeded the crustal shale value, with the exception of Mn, Fe, Ni and Cr. According to the calculated pollution parameters, although minimal or moderate pollution was detected in the area investigated, it was determined that there was a very low ecological risk. Multivariate statistical analysis results showed that Cu, Zn, and Pb levels in the investigated region were slightly influenced by anthropogenic inputs such as mining and agricultural practices. In addition, the geo–spatial distributions of Cu, Zn, Fe and Pb were found to be higher in this region due to the mining activities carried out in the Eastern Black Sea region.