DZDaoda Zhang

Daoda Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Daoda Zhang has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Microstructure, Elevated-Temperature Tribological Properties and Electrochemical Behavior of HVOF-Sprayed Composite Coatings with Varied NiCr/Cr3C2 Ratios and CoCrFeNiMo Additions

    by Daoda Zhang, Longzhi Zhao, Wanglin Chen, Junjie Luo, Hongbo Zhou, Xiaoquan Wu, Xiaomin Zheng

    This study fabricated six types of NiCr–Cr3C2 composite coatings using high-velocity oxygen fuel (HVOF) spraying and systematically evaluated their tribological behavior at 350 °C and 500 °C, along with their electrochemical corrosion performance in 3.5 wt.% NaCl solution. The objective was to elucidate how compositional design regulates the coatings’ microstructure, mechanical properties, and service performance. Results indicate that the 75NiCr–25Cr3C2 coating (C) formed a stable oxide film under both temperatures, exhibiting oxidation-dominated wear and the lowest friction coefficient and wear rate. When the temperature increased from 350 °C to 500 °C, the wear rates of coatings C, B, E, and F decreased significantly. Notably, coatings E and F, which contained CoCrFeNiMo high-entropy alloy, showed more than a 50% reduction in wear rate, demonstrating the contribution of the high-entropy phase to high-temperature wear resistance. At 350 °C, coatings B, D, E, and F experienced primarily abrasive wear; at 500 °C, however, E and F shifted to oxidative wear as the dominant mechanism, leading to a marked improvement in wear resistance. Electrochemical measurements revealed that coating E exhibited the best corrosion resistance, while the NiCr coating (A) performed the worst. The findings highlight that optimizing Cr3C2 content and incorporating high-entropy alloy elements can synergistically enhance both high-temperature tribological properties and corrosion resistance.


  • Open Access

    Microstructure and Wear Properties of Laser Cladding WC/Ni-Based Composite Layer on Al–Si Alloy

    by Xiaoquan Wu, Daoda Zhang, Zhi Hu

    The microstructural and wear properties of laser-cladding WC/Ni-based layer on Al–Si alloy were investigated by scanning electron microscope (SEM), X-ray diffraction (XRD), energy dispersive spectrometer (EDS) and wear-testing. The results show that, compared with the original specimen, the microhardness and wear resistance of the cladding layer on an Al–Si alloy were remarkably improved, wherein the microhardness of the layer achieved 1100 HV and the average friction coefficient of the layer was barely 0.14. The mainly contributor to such significant improvement was the generation of a WC/Ni-composite layer of Al–Si alloy during laser cladding. Two types of carbides, identified as M7C3 and M23C6, were found in the layer. The wear rate of the layer first increased and then decreased with the increase in load; when the load was 20 N, 60 N and 80 N, the wear rate of layer was1.89 × 10−3 mm3·m−1, 3.73 × 10−3 mm3·m−1 and 2.63 × 10−3 mm3·m−1, respectively, and the average friction coefficient (0.14) was the smallest when the load was 60 N.