FMFrank Machalett

Frank Machalett

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Frank Machalett has a total of 21 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • High Inductance Cryogenic Current Comparators for Beamlines

    by V. Tympel, F. Machalett, T. Stöhlker, L. Crescimbeni, T. Schönau, D. Haider, T. Sieber, M. Schwickert, F. Schmidl, P. Seidel, et al.

    The Cryogenic Current Comparator (CCC) for beamlines is designed for the non-destructive, highly sensitive, and absolute measurement of bunched (AC) and un-bunched (DC) beam current of charged particle in the nA range using the external magnetic field of the beam. Niobium based CCCs are running at the CERN-Antiproton Decelerator (beamline diameter of 100 mm) and are tested at the CRYRING@ESR. CCCs of the xD-series (extended dimension) can support the new facility for antiproton and ion research (FAIR) at GSI (Gesellschaft für Schwerionenforschung) in Darmstadt with a 150 mm beamline diameter. The large FAIR-Nb-CCC-xD has an inductance of 80 µH. An effective way to increase the sensitivity is to increase the inductance of the pickup coils. The two first CCCs of the new Sm-series (smart & small) have overall inductances of 200 and 300 µH. This work describes the individual development steps, starting with the superconducting pickup coils. For CCCs with a flux concentrating core in the pickup coil, the subsequent current noise of the CCC is determined by the cores parameter. On the basis of low-temperature L s R s -measurements on pickup coils, it is shown how the fluctuation–dissipation theorem (FDT) can be used to infer the current noise of the CCC. For the first time a white noise of 1 pA rms /√Hz could be achieved. A superconducting, meandering shield filters the circular magnetic field and suppresses interference fields. Through step-by-step setup and measurements, it follows how this affects CCC system parameters. Finally, it was possible to measure current impulses below 1 nA pp in the laboratory.

  • Open Access

    Experimental study of the laser-induced ionization of heavy metal and metalloid ions: Au+ and Si2+ in intense and sculpted femtosecond laser fields

    by Bo Ying, Frank Machalett, Vanessa Huth, Matthias Kübel, A Max Sayler, Thomas Stöhlker, Gerhard G Paulus, Philipp Wustelt


  • Influence of Varying Gold Nanoparticle Distributions on Structural and Superconducting Properties of Thin YBCO Films

    by Sabine Kellner, Oliver Ruger, Carmen Voigt, Frank Machalett, Frank Schmidl

    Artificial pinning centers based on crystalline gold nanoparticles inside a YBCO matrix are rarely researched so far. Nonetheless we obtained quite promising results by incorporating such particles in superconducting films. Critical current densities of 10 MA/cm2 at 77 K were observed by using small amounts of pinning material (less than 10 vol.%). Generation of gold nanoparticle ensemble inside a YBCO layer is a self-organized process. It takes place while superconductor deposition on a prior deposited gold seed layer. Particle sizes smaller 10 nm as well as some particles around 100 nm were observed. The positive effect on superconducting properties is known from previous investigations but especially the increase in critical current density observed so far is subject to greater fluctuations. In this work various nanoparticle ensembles were investigated directly by use of focus ion beam technique (FIB), scanning electron microscopy (SEM) and energy dispersive x-ray spectroscopy (EDX) in well-defined areas with known local current density. This investigation provides a direct link between gold distribution and the resulting enhancement, which can be utilized to optimise process conditions in direction of favourable particle ensembles.