Etibar Ismailov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Etibar Ismailov has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Sevinj N. Osmanova
Institute of Catalysis and Inorganic Chemistry named after academician M. Naghiyev, Baku, Azerbaijan
2 shared publications Aleskerova Zuleyxa Fikret
The Institute of Catalysis and Inorganic Chemistry, Azerbaijan National Academy of Sciences, Baku, Azerbaijan
1 shared publication- Azimova Gunel Ramiz
Chemistry Institute, Baku, Azerbaijan
1 shared publication - Dilgam Babir Tagiyev
Ministry of Science and Education, Republic of Azerbaijan Institute of Chemistry Baku Azerbaijan
1 shared publication - Natavan Gadimova
Azerbaijan State University of Economics (UNEC)
1 shared publication - Nazilya Akhundova
Azerbaijan State University of Economics (UNEC)
1 shared publication
Latest Publications
- Open Access
- 29 February 2024
- Published by Gazi University Journal of Science in Gazi University Journal of Science
- p. 1
Structural And Mechanical Properties Of Oils From The Muradkhanly And Sangachal-Deniz Fields Of Azerbaijan
In the range of 278-293 K, the structural-mechanical properties of high-viscosity asphaltene-resinous and highly solidifying paraffinic oils of the Muradkhanly and Sangachal-deniz fields of Azerbaijan, which exhibit abnormal viscosity at various shear rates and are characterized by non-Newtonian, viscoplastic and thixotropic properties, have been studied. According to the Eyring-Frenkel equation, the activation energies of the viscous flow Ea and the change in the entropy ΔS of these oils are calculated for the indicated temperature range. Various algorithms for estimating the thermodynamic parameters of the flow ΔH and ΔS published in the literature are analyzed, and the scatter of the values of the estimates of parallel calculations is shown. It is shown that with a decrease in temperature, phase transitions in oils are activated, in particular, for the highly solidifying paraffin oil Sangachal-deniz, it originates from 297 K. For the oils under consideration for the selected shear rate of 64 s-1, the values of the temperature of the beginning of structure formation, static and limiting dynamic shear stresses were determined: for Muradkhanly oil T = 282.83 K, Sangachal-deniz - T = 297.23 K. The results obtained can be used to predict the behavior of oils.
- 29 February 2024
- Published by Gazi University Journal of Science in Gazi University Journal of Science
- p. 1
Open AccessStructural And Mechanical Properties Of Oils From The Muradkhanly And Sangachal-Deniz Fields Of Azerbaijan
In the range of 278-293 K, the structural-mechanical properties of high-viscosity asphaltene-resinous and highly solidifying paraffinic oils of the Muradkhanly and Sangachal-deniz fields of Azerbaijan, which exhibit abnormal viscosity at various shear rates and are characterized by non-Newtonian, viscoplastic and thixotropic properties, have been studied. According to the Eyring-Frenkel equation, the activation energies of the viscous flow Ea and the change in the entropy ΔS of these oils are calculated for the indicated temperature range. Various algorithms for estimating the thermodynamic parameters of the flow ΔH and ΔS published in the literature are analyzed, and the scatter of the values of the estimates of parallel calculations is shown. It is shown that with a decrease in temperature, phase transitions in oils are activated, in particular, for the highly solidifying paraffin oil Sangachal-deniz, it originates from 297 K. For the oils under consideration for the selected shear rate of 64 s-1, the values of the temperature of the beginning of structure formation, static and limiting dynamic shear stresses were determined: for Muradkhanly oil T = 282.83 K, Sangachal-deniz - T = 297.23 K. The results obtained can be used to predict the behavior of oils.
- Open Access
- 30 December 2022
- Published by Private Company Technology Center in Eastern-European Journal of Enterprise Technologies
- Vol. 6 (11 (120)) , 24-33
Chemical composition, thermal stability of pomegranate peel and seed powders and their application in food production
Pomegranate seed and peel powders are suitable for the production of pectin, oil, proteins and as biologically active additives for food enrichment. Knowledge of the chemical composition and thermal changes of powders allows to control the technological regimes, yield and quality of the final product. As a result of the studies, the chemical composition and thermal properties of a finely dispersed pomegranate peel and seed powder subjected to heat treatment by X-ray diffractometry, IR-, EPR spectroscopy and thermal analysis (TG/DTG/DSC) have been carried out. X-ray diffractometry showed that the crystal structures present in the original samples, when heated in air at 110 °C for 30 min. are destroyed and in all cases the samples pass into the amorphous state, a noticeable difference is found in the position and intensity of the observed bands in the spectra in the initial and heat-treated samples. IR spectroscopy data show that drying the samples at 105 °C in air for 30 min leads to a significant change in the chemical composition of the powders. EPR spectroscopy showed the presence of paramagnetism in the samples and identified organic radicals and paramagnetic centers from Fe3+ ions. The features of the change in the chemical composition during drying of samples, which are characteristic of drying processes, namely, are the result by dehydration, dehydroxylation and denaturation of protein compounds that make up this process, have been established. Temperature intervals (54.2–147.9 and 71.7–95.4 °C, 147.9–343.7 and 343.7–466 °C) associated with changes in the composition of organic compounds, contained in the powders were determined.
- 30 December 2022
- Published by Private Company Technology Center in Eastern-European Journal of Enterprise Technologies
- Vol. 6 (11 (120)) , 24-33
Open AccessChemical composition, thermal stability of pomegranate peel and seed powders and their application in food production
Pomegranate seed and peel powders are suitable for the production of pectin, oil, proteins and as biologically active additives for food enrichment. Knowledge of the chemical composition and thermal changes of powders allows to control the technological regimes, yield and quality of the final product. As a result of the studies, the chemical composition and thermal properties of a finely dispersed pomegranate peel and seed powder subjected to heat treatment by X-ray diffractometry, IR-, EPR spectroscopy and thermal analysis (TG/DTG/DSC) have been carried out. X-ray diffractometry showed that the crystal structures present in the original samples, when heated in air at 110 °C for 30 min. are destroyed and in all cases the samples pass into the amorphous state, a noticeable difference is found in the position and intensity of the observed bands in the spectra in the initial and heat-treated samples. IR spectroscopy data show that drying the samples at 105 °C in air for 30 min leads to a significant change in the chemical composition of the powders. EPR spectroscopy showed the presence of paramagnetism in the samples and identified organic radicals and paramagnetic centers from Fe3+ ions. The features of the change in the chemical composition during drying of samples, which are characteristic of drying processes, namely, are the result by dehydration, dehydroxylation and denaturation of protein compounds that make up this process, have been established. Temperature intervals (54.2–147.9 and 71.7–95.4 °C, 147.9–343.7 and 343.7–466 °C) associated with changes in the composition of organic compounds, contained in the powders were determined.
- 1 April 2022
- Published by Bentham Science Publishers Ltd. in Current Microwave Chemistry
- Vol. 9 (1) , 37-46
Microwave Sol-gel Synthesis of Co, Ni, Cu, Mn Ferrites and the Investigation of Their Activity in the Oxidation Reaction of Carbon Monoxide
Background: The study effect of microwave radiation on the catalytic properties of transition metal ferrites synthesized by ceramic and sol-gel methods in the oxidation reaction of carbon monoxide into dioxide. Objective: This work aims to study the effect of microwave radiation on the production of cobalt, copper, nickel, and manganese ferrites by sol-gel combustion technology using various organic reagents and to study their catalytic activity in the oxidative conversion of carbon monoxide into dioxide. Methods: Microwave treatment was carried out on a setup based on an EM-G5593V microwave oven (Panasonic) with a magnetron power varying from 300 to 800 W with an operating frequency of 2450 MHz. X-ray phase analysis of the products was carried out on a Bruker D 2Phazer automatic diffractometer. The measurement of the specific surface area of the samples was determined by low-temperature nitrogen adsorption by the multipoint BET method on a SORBI-MS instrument (ZAO META, Russia). IR spectra were recorded using FT-IR LUMOS Bruker spectrometers. The micrographs of samples were analyzed on the Sigma VP (Carl Zeiss Jena) equipment. Results: It was determined that the most active catalysts for the oxidation of carbon monoxide to dioxide are ferrites obtained by the sol-gel combustion method using microwave radiation to "ignite" the gel. Conclusion: The use of microwave radiation in the preparation of ferrites by the sol-gel method with combustion can initiate a self-propagating exothermic combustion reaction in the entire volume of the sample in a very short time, measured in seconds. The catalytic activity in the oxidative conversion of carbon monoxide obtained by this method of ferrites is comparable to the activity of ferrites obtained by the sol-gel method with traditional combustion.
- 1 April 2022
- Published by Bentham Science Publishers Ltd. in Current Microwave Chemistry
- Vol. 9 (1) , 37-46
Microwave Sol-gel Synthesis of Co, Ni, Cu, Mn Ferrites and the Investigation of Their Activity in the Oxidation Reaction of Carbon Monoxide
Background: The study effect of microwave radiation on the catalytic properties of transition metal ferrites synthesized by ceramic and sol-gel methods in the oxidation reaction of carbon monoxide into dioxide. Objective: This work aims to study the effect of microwave radiation on the production of cobalt, copper, nickel, and manganese ferrites by sol-gel combustion technology using various organic reagents and to study their catalytic activity in the oxidative conversion of carbon monoxide into dioxide. Methods: Microwave treatment was carried out on a setup based on an EM-G5593V microwave oven (Panasonic) with a magnetron power varying from 300 to 800 W with an operating frequency of 2450 MHz. X-ray phase analysis of the products was carried out on a Bruker D 2Phazer automatic diffractometer. The measurement of the specific surface area of the samples was determined by low-temperature nitrogen adsorption by the multipoint BET method on a SORBI-MS instrument (ZAO META, Russia). IR spectra were recorded using FT-IR LUMOS Bruker spectrometers. The micrographs of samples were analyzed on the Sigma VP (Carl Zeiss Jena) equipment. Results: It was determined that the most active catalysts for the oxidation of carbon monoxide to dioxide are ferrites obtained by the sol-gel combustion method using microwave radiation to "ignite" the gel. Conclusion: The use of microwave radiation in the preparation of ferrites by the sol-gel method with combustion can initiate a self-propagating exothermic combustion reaction in the entire volume of the sample in a very short time, measured in seconds. The catalytic activity in the oxidative conversion of carbon monoxide obtained by this method of ferrites is comparable to the activity of ferrites obtained by the sol-gel method with traditional combustion.