HLHao Li

Hao Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Hao Li has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Microstructure and Tribological Properties of Fe-Based-Al2O3-B4C Composite Coatings Prepared by High-Velocity Arc Spraying

    by Hao Li, Fang Huang, Jinran Lin, Min Kang, Joseph Ndiithi Ndumia, Jitao Liu

    Fe-based-Al2O3-B4C coating was prepared on the low-carbon steel substrates using high-velocity arc spraying. The effects of voltage, current, and distance on the porosity and microhardness of the coating were studied by an orthogonal test, and the optimum spraying parameters were determined. The microstructure and properties of Fe-based-Al2O3-B4C coatings prepared under optimum process parameters were characterized by X-ray diffractometer (XRD), scanning electron microscopy (SEM), energy dispersive spectrometry (EDS), microhardness and friction wear tester. The results showed that the optimum process parameters were a spraying voltage of 41 V, a spraying current of 200 A, and a spraying distance of 150 mm. The porosity was 2.24 ± 0.32%, and the microhardness was 1543 ± 145 Hv0.1, which was 8 times that of the substrate. Under the same load of 4.2 N and varying sliding speeds of 500 t/min, 750 t/min, and 1000 t/min, the coefficient of friction of the coating was less than that of the low-carbon steel, and the wear rate of the coating was 65%, 70%, and 63% lower than that of the low-carbon steel, respectively. The main wear mechanism of the coating was material spalling, accompanied by slight oxidative wear and abrasive wear.


  • Open Access

    Influence of Heat Treatment on the Microstructure and Wear Properties of Arc-Sprayed FeCrAl/Al Coating

    by Joseph Ndiithi Ndumia, Min Kang, Jinran Lin, Jitao Liu, Hao Li

    Intermetallic compounds formed during heat treatment of alloy coatings affect the coating structure and properties. In order to determine the phase changes and coating performance, FeCrAl (Fe Bal., Cr 26 wt.%, Al 6 wt.%) and Al (99.9 wt.%) coating was sprayed onto low carbon steel substrates and subsequently heat-treated at different temperatures. The effects of heat treatment on the microstructure, phase composition, tensile bonding strength, microhardness, and wear properties of the coatings were analyzed. The as-sprayed coating had a dense, layered structure with an average porosity of 3.6%. The microhardness of the as-sprayed coating was comprised of hard FeCrAl splats and ductile Al splats with an average microhardness value of 494 HV0.1. The coating at 300 °C had the highest tensile strength of 37.5 MPa. At 500 °C, FeAl intermetallic compounds formed at the phase boundaries due to the diffusion of elements. The coating microhardness and wear resistance were affected by the uniform coating structure and the precipitation of FeAl intermetallic compounds. Compared with the annealed coatings, the as-sprayed coating had the lowest wear rate.