Dmitry Smalchenko
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dmitry Smalchenko has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Olga Evgenievna Lebedeva
Belgorod State National Research University
3 shared publications - Evgeniy S. Seliverstov
Belgorod State National Research University
1 shared publication - Igor Yu. Goncharov
Joint Research Center “Technology and Materials”, Belgorod State National Research University, 308015 Belgorod, Russia
1 shared publication - Lyubov Furda
Institute of Pharmacy, Chemistry and Biology, Department of General Chemistry, Belgorod State National Research University, 308015 Belgorod, Russia
1 shared publication - Maksim N. Yapryntsev
Belgorod State National Research University
1 shared publication - Polina Kozhevnikova1 shared publication
Latest Publications
- 20 November 2025
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 349
Multication and high-entropy layered double hydroxides: thermal (non)stability and rehydration structure (non)recovery
- 20 November 2025
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 349
Multication and high-entropy layered double hydroxides: thermal (non)stability and rehydration structure (non)recovery
- 1 July 2023
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 63 (7) , 814-819
Textural and Adsorption Properties of Silica Doped with Iron Cations
The paper describes the textural properties and adsorption capacity of a number of silica samples doped with Fe3+ cations at concentrations of 1.5, 2.3, and 3.8 mol %. These silica samples were synthesized by hydrolysis of tetraethoxysilane at various pH values, specifically 1.5, 2.5, 5.0, and 7.0. It was found that both the pH of hydrolysis and the content of doping cations have a major effect on the specific surface area, pore volume, and pore size distribution. The micro–mesoporous silicas synthesized at pH 2.5 exhibited a weak sieve effect: the adsorption of methylene blue on their surface was lower than on the samples produced at the other pH values, whereas the adsorption of aniline was comparable for all samples. Increasing the content of iron ions in the samples enhanced the adsorption of the cationic dye due to a decrease in the electrokinetic potential of the surface.
- 1 July 2023
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 63 (7) , 814-819
Textural and Adsorption Properties of Silica Doped with Iron Cations
The paper describes the textural properties and adsorption capacity of a number of silica samples doped with Fe3+ cations at concentrations of 1.5, 2.3, and 3.8 mol %. These silica samples were synthesized by hydrolysis of tetraethoxysilane at various pH values, specifically 1.5, 2.5, 5.0, and 7.0. It was found that both the pH of hydrolysis and the content of doping cations have a major effect on the specific surface area, pore volume, and pore size distribution. The micro–mesoporous silicas synthesized at pH 2.5 exhibited a weak sieve effect: the adsorption of methylene blue on their surface was lower than on the samples produced at the other pH values, whereas the adsorption of aniline was comparable for all samples. Increasing the content of iron ions in the samples enhanced the adsorption of the cationic dye due to a decrease in the electrokinetic potential of the surface.
- Open Access
- 18 March 2022
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 62 (3) , 310-315
Catalytic Conversion of Polyolefins in the Presence of MCM-41 Type Mesoporous Materials
The catalytic activities of mesoporous H–MCM-41 aluminosilicates of different compositions in degradation of polypropylene and a polypropylene-polyethylene mixture into gasoline-range fraction hydrocarbons were compared. A higher yield of the target products (86 wt %) was observed for the sample with a lower aluminum content. Using the results of chromatographic analysis of the catalyzate for the content of the gasoline-range fraction, both saturated and unsaturated hydrocarbons, dominated by products with cyclic structure, were identified in all the samples studied. In the presence of the H–MCM-41 sample with a lower silica modulus, a larger amount of condensation products with a higher calorific value arose from polypropylene degradation. Mesoporous aluminosilicates H–MCM-41 can be regarded as effective catalysts for thermocatalytic conversion of polypropylene to produce the gasoline-range fraction.
- 18 March 2022
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 62 (3) , 310-315
Open AccessCatalytic Conversion of Polyolefins in the Presence of MCM-41 Type Mesoporous Materials
The catalytic activities of mesoporous H–MCM-41 aluminosilicates of different compositions in degradation of polypropylene and a polypropylene-polyethylene mixture into gasoline-range fraction hydrocarbons were compared. A higher yield of the target products (86 wt %) was observed for the sample with a lower aluminum content. Using the results of chromatographic analysis of the catalyzate for the content of the gasoline-range fraction, both saturated and unsaturated hydrocarbons, dominated by products with cyclic structure, were identified in all the samples studied. In the presence of the H–MCM-41 sample with a lower silica modulus, a larger amount of condensation products with a higher calorific value arose from polypropylene degradation. Mesoporous aluminosilicates H–MCM-41 can be regarded as effective catalysts for thermocatalytic conversion of polypropylene to produce the gasoline-range fraction.