Piyush B. Miyani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Piyush B. Miyani has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Amit Vilas Sant
Department of Electrical Engineering, School of Energy Technology, Pandit Deendayal Energy University, Gandhinagar 382426, Gujarat, India
1 shared publication - Anilkumar Markana
Pandit Deendayal Energy University
1 shared publication - Lav Kumar Kaushik
Gujarat Technological University-Institute of Technology and Research, Gujarat, India
1 shared publication - Parth S. Thakar
Department of Electronics & Communication Engineering, Pandit Deendayal Energy University, Gandhinagar, India
1 shared publication - Sunita Deb
National Institute of Technology Andhra Pradesh, India
1 shared publication - Vivek Patel
GTU - Institute of Technology and Research, India
1 shared publication
Latest Publications
- 1 April 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (8) , 085514
Thermohydraulic investigation of rotating baffled solar air heater
The thermohydraulic behavior of Solar Air Heater (SAH) having spiral-shaped baffles has been experimentally investigated in the present study. The experimental work was performed in India (Mehsana latitude and longitude: 23.5880° N, 72.3693° E) between 8th October 2022 and 15th January 2023. The rotating baffles are employed to achieve the favorable turbulent heat transfer mechanism within the system. The geometrical variables of relative roughness height (e/H) and relative roughness pitch (P/e) were evaluated between the range of 0.4–1.0 and 4–10, respectively, for the Reynolds numbers ( R e ) values of 4000 to 12000. Temperature difference (T o -T i ), pressure drop (∆P d ), thermohydraulic performance parameter (THPP) and useful heat gain (Q u ) were investigated for the range of e/H and P/e. The e/H turned out to be favorable by its gradual increment from 0.4 to 0.8, thereafter depicting the converse effect. e/H-1 and R e -12,000 resulted in the highest pressure drop of 150 Pa. The positive impact was noted f o r T o -T i for the increasing range of P/e. P/e-4 and R e of 12000 demonstrated the maximum pressure drop of 145 Pa. The e/H-0.8, P/e-8, and R e -12000 has achieved the highest value of useful heat gain, 398.52 W. The increment of 6.84 times and 21.81 times was achieved for both the Nusselt number ( N u ) and friction factor ( f ), respectively, compared to the smooth design of SAH. The value of THPP recorded as 2.68, which is higher than the reported value of 2.26 in the existing literature. In conclusion, the introduction of rotating spiral-shaped baffles presents a promising enhancement for SAH performance. However, further comprehensive field studies are necessary to fully exploit its potential.
- 1 April 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (8) , 085514
Thermohydraulic investigation of rotating baffled solar air heater
The thermohydraulic behavior of Solar Air Heater (SAH) having spiral-shaped baffles has been experimentally investigated in the present study. The experimental work was performed in India (Mehsana latitude and longitude: 23.5880° N, 72.3693° E) between 8th October 2022 and 15th January 2023. The rotating baffles are employed to achieve the favorable turbulent heat transfer mechanism within the system. The geometrical variables of relative roughness height (e/H) and relative roughness pitch (P/e) were evaluated between the range of 0.4–1.0 and 4–10, respectively, for the Reynolds numbers ( R e ) values of 4000 to 12000. Temperature difference (T o -T i ), pressure drop (∆P d ), thermohydraulic performance parameter (THPP) and useful heat gain (Q u ) were investigated for the range of e/H and P/e. The e/H turned out to be favorable by its gradual increment from 0.4 to 0.8, thereafter depicting the converse effect. e/H-1 and R e -12,000 resulted in the highest pressure drop of 150 Pa. The positive impact was noted f o r T o -T i for the increasing range of P/e. P/e-4 and R e of 12000 demonstrated the maximum pressure drop of 145 Pa. The e/H-0.8, P/e-8, and R e -12000 has achieved the highest value of useful heat gain, 398.52 W. The increment of 6.84 times and 21.81 times was achieved for both the Nusselt number ( N u ) and friction factor ( f ), respectively, compared to the smooth design of SAH. The value of THPP recorded as 2.68, which is higher than the reported value of 2.26 in the existing literature. In conclusion, the introduction of rotating spiral-shaped baffles presents a promising enhancement for SAH performance. However, further comprehensive field studies are necessary to fully exploit its potential.
- 1 January 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (1) , 015315
Discrete sliding mode control for single board heater system with implementation using open source tools
In this paper, a new application of discrete sliding mode control (DSMC) is reported for a single board heater system (SBHS). The system model is identified using least-square optimization. A non-switching type stable DSMC is developed for an uncertain system. For this, exact and non-conservative stability boundaries are also identified. Additionally, a high-gain observer (HGO) strategy is embedded together through the zero-order hold (ZOH) based implementation scheme, for its realization with the controller. This study compares the set-point tracking performance of DSMC, tuned PID and pole placement control strategies in SBHS simulations, resulting DSMC to achieve the lowest ITAE and ITSE errors. Normally in the simulation the modeling errors and uncertainties especially for systems like SBHS, are not considered. They become prominent in the practical scenario where thermal inertia, delay in the output response, sampling errors, nonlinearities, drift in the system parameters play a significant role and hence the performance of the controller needs to be evaluated for practical implementation. The effectiveness of the suggested controller-observer scheme is experimentally validated on a real SBHS setup through the open source software tools like Scilab and Xcos. Moreover, the experimental results are demonstrated alongside their respective analysis. Some important observations and conclusions from the overall study are deduced.
- 1 January 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (1) , 015315
Discrete sliding mode control for single board heater system with implementation using open source tools
In this paper, a new application of discrete sliding mode control (DSMC) is reported for a single board heater system (SBHS). The system model is identified using least-square optimization. A non-switching type stable DSMC is developed for an uncertain system. For this, exact and non-conservative stability boundaries are also identified. Additionally, a high-gain observer (HGO) strategy is embedded together through the zero-order hold (ZOH) based implementation scheme, for its realization with the controller. This study compares the set-point tracking performance of DSMC, tuned PID and pole placement control strategies in SBHS simulations, resulting DSMC to achieve the lowest ITAE and ITSE errors. Normally in the simulation the modeling errors and uncertainties especially for systems like SBHS, are not considered. They become prominent in the practical scenario where thermal inertia, delay in the output response, sampling errors, nonlinearities, drift in the system parameters play a significant role and hence the performance of the controller needs to be evaluated for practical implementation. The effectiveness of the suggested controller-observer scheme is experimentally validated on a real SBHS setup through the open source software tools like Scilab and Xcos. Moreover, the experimental results are demonstrated alongside their respective analysis. Some important observations and conclusions from the overall study are deduced.
- 14 April 2022
- Published by Springer Nature
- p. 72-82
Control System Design for DC-Link Voltage Control of Quasi-Z Source Inverter Using Bode Diagram
- 14 April 2022
- Published by Springer Nature
- p. 72-82
Control System Design for DC-Link Voltage Control of Quasi-Z Source Inverter Using Bode Diagram