Alexsandra Rospirski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Alexsandra Rospirski has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Fernando Marcos de Oliveira
Itaipu Parquetec, Foz do Iguaçu 85867-900, PR, Brazil
2 shared publications - Tales Gottlieb Jahn
Energy Management Center - GE.DT, Itaipu Parquetec, Foz do Iguaçu, Brazil
2 shared publications - Adalberto Teogenes Tavares Junior
PPGIES, UNILA, Foz do iguaçu, Brazil
1 shared publication - Cezar Antônio Rigo
Department of Electrical Engineering Federal University of Santa Catarina (UFSC) Florianópolis Brazil
1 shared publication - Daniel Augusto Cantane
Itaipu Parquetec, Foz do iguaçu, Brazil
1 shared publication - Ediane Karine Scherer Isernhagen
Itaipu Technology Park, Foz do Iguaçu 85867-000, PR, Brazil
1 shared publication
Latest Publications
- 26 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Enhanced Three-Phase Interleaving Phase-Shifted Full Bridge Converter with Active Clamp Using GaNFET for Green Hydrogen Production
This article presents the development of a Three-Phase Interleaving Phase-Shifted Full Bridge (PSFB) DC-DC converter for green hydrogen generation. The converter implements Zero Voltage Switching (ZVS) and GaNFETs in the primary side of the transformer, and incorporates an Active Clamp system with synchronous rectification in the secondary side. These features are designed to minimize switching losses and significantly improve the power conversion efficiency. Simulation results confirm the effectiveness of these design choices, showcasing improved waveforms and stable operation. This work contributes to the advancement of power electronics in the field of green hydrogen production, offering a promising solution to increase efficiency and enhance the overall power quality of hydrogen generation processes.
- 26 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Enhanced Three-Phase Interleaving Phase-Shifted Full Bridge Converter with Active Clamp Using GaNFET for Green Hydrogen Production
This article presents the development of a Three-Phase Interleaving Phase-Shifted Full Bridge (PSFB) DC-DC converter for green hydrogen generation. The converter implements Zero Voltage Switching (ZVS) and GaNFETs in the primary side of the transformer, and incorporates an Active Clamp system with synchronous rectification in the secondary side. These features are designed to minimize switching losses and significantly improve the power conversion efficiency. Simulation results confirm the effectiveness of these design choices, showcasing improved waveforms and stable operation. This work contributes to the advancement of power electronics in the field of green hydrogen production, offering a promising solution to increase efficiency and enhance the overall power quality of hydrogen generation processes.
- Open Access
FBM-CSoC Control and Management System for Multi-Port Converter Applied in Hybrid Energy Storage System Used in Microgrid
Several management and control techniques for hybrid energy storage systems (HESS) with batteries and supercapacitors are presented in the literature applied to microgrids (MGs). The filter-based control strategy for defining the control loop actuation is one of the most widely used approaches with satisfactory performance. Variations of the Filter-Based Method (FBM) method are proposed to improve the control efficiency of the HESS under load disturbance and intermittent generator sources. However, not enough attention has been paid to the impacts of MG on the operational performance of batteries, despite the fact that they represent a non-negligible percentage of the total cost of MGs. In this paper, a control strategy called FBM-CSoC is proposed that focuses primarily on mitigating battery safety and degradation issues. The control strategy proposes a distribution of the charging and discharging current in a weighted proportional way to the normalized rated capacity and current state of charge (SoC) of each battery in the MG. This control strategy favors both the reduction of the internal temperature variation of the cells and the possibility of them operating in overcharging or over-discharging conditions. A comparative case study between the traditional FBM method and the FBM-CSoC, by means of numerical simulations, demonstrated that the load distribution occurs satisfactorily in energy storage systems. Finally, the FBM-CSoC method can be flexibly used for different types of battery technology and/or batteries with different SoCs integrated with supercapacitors.
Open AccessFBM-CSoC Control and Management System for Multi-Port Converter Applied in Hybrid Energy Storage System Used in Microgrid
Several management and control techniques for hybrid energy storage systems (HESS) with batteries and supercapacitors are presented in the literature applied to microgrids (MGs). The filter-based control strategy for defining the control loop actuation is one of the most widely used approaches with satisfactory performance. Variations of the Filter-Based Method (FBM) method are proposed to improve the control efficiency of the HESS under load disturbance and intermittent generator sources. However, not enough attention has been paid to the impacts of MG on the operational performance of batteries, despite the fact that they represent a non-negligible percentage of the total cost of MGs. In this paper, a control strategy called FBM-CSoC is proposed that focuses primarily on mitigating battery safety and degradation issues. The control strategy proposes a distribution of the charging and discharging current in a weighted proportional way to the normalized rated capacity and current state of charge (SoC) of each battery in the MG. This control strategy favors both the reduction of the internal temperature variation of the cells and the possibility of them operating in overcharging or over-discharging conditions. A comparative case study between the traditional FBM method and the FBM-CSoC, by means of numerical simulations, demonstrated that the load distribution occurs satisfactorily in energy storage systems. Finally, the FBM-CSoC method can be flexibly used for different types of battery technology and/or batteries with different SoCs integrated with supercapacitors.