YWYin Wang

Yin Wang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yin Wang has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Variations in Oil Occurrence State and Properties during High-Speed Stirring Treatment of Oily Sludge

    by Yuwei Bao, Yimin Zhu, Yang Liu, Jiao Zhao, Xiaojia Tang, Tie Li, Yin Wang, Xianmeng Liu, Hao Zhang

    Oily sludge (OS) has long been regarded as a hazardous waste, and improper disposal may lead to serious environmental concerns and human health risks. Despite various methods having been proposed and applied to the treatment of OS, the oil occurrence states and properties in sludge are rarely characterized, which may directly link to the selection and effectiveness of treatment methods. Here, confocal laser scanning microscopy (CLSM), X-ray diffraction (XRD), gas chromatography (GC), and four components (SARA) analysis were utilized to characterize the changes in the oil occurrence states and compositions in OS samples before and after high-speed stirring (HSS) treatment. Our results show a substantial reduction in the oil concentration of OS after HSS treatment (from 32.98% to 1.65%), while SARA analysis reveals a similar oil composition before and after treatment, suggesting the broad applicability of HSS in removing oil and its insignificant selectivity towards various hydrocarbon components. This is further supported by the total petroleum hydrocarbon (TPH) analysis results, which show that the separated oil phase has a hydrocarbon composition similar to that of the original OS sample. The CLSM and fluorescence analysis suggest a homogeneous distribution of oil in the sludge, with relatively light components more concentrated in the pore systems between coarse mineral particles, whereas relatively heavy components tend to coexist with clay minerals. After HSS cleaning, both light and heavy components are removed to varying degrees, but light components are preferentially removed while heavy components tend to be retained in the sludge due to adsorption by clay minerals. This is consistent with TPH analysis, where a significant decrease in n-alkanes with lower carbon numbers (n-C14 to n-C20) was observed in the residual sample. Our findings demonstrate the dynamic response of oil occurrence states and compositions to the OS treatment process and highlight the importance of characterizing these fundamental properties prior to the selection of OS treatment methods.


  • Open Access

    Simulation Study on the Process of Cleaning Oily Sludge with High-speed Stirring Rotor

    by Yin Wang, Keqing Li, Jiao Zhao, Xiaojia Tang, Tie Li, Xianmeng Liu, Hao Zhang, Yimin Zhu

    In this paper, COMSOL Multiphysics software was used to simulate and analyze the process of cleaning oily sludge by high-speed stirring rotor. The physical phenomena such as velocity field, pressure field, heat dissipation and cavitation generated by the rotor during the process of the oily sludge cleaning were analyzed. The results showed that in the process of cleaning the oily sludge by high-speed stirring rotor, the shear force, heat dissipation and pressure increased with the enhance in the rotor speed. Cavitation occurs in the impeller area of the rotor because of the change of pressure, so the cavitation bubbles were formed. Shear force, heat dissipation and cavitation contributed to the separation of oil phase in oily sludge. Meanwhile, the simulation results were verified by experiments.

  • Open Access

    Highly Efficient Treatment of Oily Sludge by a Novel High-Speed Stirring Method at Room Temperature

    by Yimin Zhu, Keqing Li, Yin Wang, Jiao Zhao, Xiaojia Tang, Tie Li, Chenming Zhang

    Oily sludge is one of the main hazardous wastes which seriously endangers the ecological environment and human health. In this paper, in order to effectively treat oily sludge, a novel high-speed stirring (HSS) method was proposed to clean oily sludge, and the main parameters affecting the residual oil rate of oily sludge were studied experimentally. Firstly, the cleaning time and stirring speed were optimized in the one-stage HSS cleaning, and then the optimal cleaning time of two-stage HSS cleaning was determined by the response surface method. The results suggested that the oil can be efficiently separated by high-speed stirring at room temperature, and that the two-stage cleaning with a circular-hole outlet (Rotor-C) followed by a vertical hole-outlet (Rotor-V) presented the best effect. The optimal stirring speed was 6000 r/min, and the optimal cleaning times of the two-stage cleaning were 7 min and 8 min, respectively. After cleaning, the residual oil rate of the treated oily sludge was 1.65%, and the removal rate of the petroleum hydrocarbons was 84.3%.