JKJinhyun Kim

Jinhyun Kim

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jinhyun Kim has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A Concurrent Dual-Band Power Amplifier With Diplexer Based on Asymmetric Load Coupler

    by Jinhyun Kim, Seongwoog Oh, Jungsuek Oh

    In this work, a concurrent dual band GaN power amplifier (PA) employing coupler based diplexer is presented for sub 6 GHz 5G applications. An asymmetrically loaded coupled line is analyzed using even-odd mode decomposition and exploited as an impedance transformer that also generates a frequency-selective virtual short at the low band, thereby providing high cross band isolation without additional rejection circuitry. The same coupler concept is applied to the output matching network, where geometric tuning of the coupler and an open stub steers the fundamental and harmonic impedances toward the load-pull optima at 3.48 and 4.93 GHz. The prototype PA uses a single CGHV1J006D GaN HEMT die mounted on a Rogers 5880 substrate and is characterized under concurrent dual band operation. The measured small-signal gains are 16.53 dB and 14.29 dB at the low and high bands, respectively, while the saturated output power is about 38 dBm for both bands. Peak power added efficiencies of 50.98% at 3.48 GHz and 42.4% at 4.93 GHz are achieved. Two-tone measurements with 10 MHz spacing demonstrate intermodulation products 21.97 dB and 25.56 dB below the fundamentals in the low and high bands, respectively. With a 20 MHz LTE 16-QAM signal, the adjacent channel power ratio improves from approximately -30 dBc to better than -45 dBc when digital predistortion is applied, confirming that the proposed architecture offers high efficiency, strong isolation, and good linearity for compact concurrent dual band transmitters.

  • A 2.5-Bit Polarization-Rotating Ultrawideband Transmit Array for 6G Communications

    by Jinhyun Kim, Seongwoog Oh, Jungsuek Oh

    In this paper, a 2.5-bit polarization-rotating transmit array is proposed for ultra-wideband 6G terahertz communications. The transmit array utilizes a unit-cell structure combining a polarization rotator and a polarizer, enabling broadband phase tuning and impedance matching with 2.5-bit phase control. By applying single- and dual-bar topologies to the rotator, a low Q-factor matching controller was implemented, enabling low-transmission loss and wideband performance. Six types of unit cells were designed to realize 2.5-bit discrete phase states with a 260° tuning range. Arrangement of the unit cell was optimized based on the reference phase to minimize quantization loss, enabling optimal array configuration for high-efficiency beamforming. The fabricated 30 × 30 transmit array achieved a peak gain of 28.6 dBi, an aperture efficiency of 31.8%, and a 3 dB gain bandwidth of 46.5 GHz, 32.1%. Furthermore, the communication distance range was experimentally evaluated using error vector magnitude measurements with modulated signals, demonstrating increases of 3 times compared with that of a standalone horn antenna. Consequently, the proposed transmit array achieved a data rate of 1.44 Gbps at a distance of 100 cm, as confirmed by modulated signal throughput measurements.

  • Open Access

    On the Synthesis of Aperiodic Multi-Atom 1-Bit Reconfigurable Passive EMSs at 140 GHz

    by Taeyoung Kim, Francesco Zardi, Sangmin Lee, Jinhyun Kim, Uichan Park, Jungsuek Oh, Sangjo Choi, Giacomo Oliveri

    An innovative reconfigurable passive electromagnetic skin (RP-EMS) architecture is proposed to support a single reflection beam while suppressing undesired beams, using 1-bit switching with minimal hardware complexity. The architecture is the first to simultaneously optimize the meta-atom arrangement and their 1-bit switching descriptors using the integer-coded evolutionary algorithm, supporting multiple reflection scenarios. The process yields one aperiodic meta-atom arrangement that effectively mitigates periodic phase quantization errors typical of 1-bit RP-EMS layouts, while changing reflection angles solely through 1-bit switching. An aperture-coupled patch-based meta-atom topology with well-separated and linearized phase responses is employed to enable 1-bit switching using a short/open connection. As a proof of concept, 30×30 RP-EMS prototypes with a 3.14×3.14 cm2 aperture and λ/2 periodicity at 140 GHz are designed and fabricated, demonstrating reflection at 15∘, 30∘, and 45∘ under normal incidence. The prototypes exhibited robust beam steering with QLL consistently below -10 dB and SLL up to -10 dB, confirming the effectiveness of the proposed MASB layout. In addition, the structures achieve 3-dB gain bandwidth exceeding 11% and high reflection efficiencies over 15%, referenced to a conductor surface of the same size. These results validate the potential of the proposed architecture for implementing multi-functional 1-bit RP-EMS with controlled sidelobes and no grating lobe near 140 GHz.

  • Compact MIMO Antenna OTA Measurement System With Utilization of Metasurface for Wavefront Manipulator

    by Jinhyun Kim, Uichan Park, Haeseung Lee, Kyungho Yoo, Jungsuek Oh

    A novel application of the metasurface for minimizing the Sub-6 GHz MIMO antenna measurement system is proposed. To reduce measurement errors across frequencies and within the measurement system, an active transmit-type metasurface based on the PIN diode is adopted, enabling compensation for phase without amplitude variation. Moreover, the unit cell is designed with a size of 20 mm × 20 mm (0.25λ × 0.25λ) to reduce quantization loss. The Mean Square Error (MSE) of the E-field is calculated to verify wavefront uniformity. The paper introduces a measurement method that can determine quiet-zone generation instead of relying on antenna probe measurements. This method utilizes path loss changes per unit distance. Based on the path loss difference measurement results, the metasurface can form a quiet zone approximately 30% closer to the receiver antenna. Additionally, it is confirmed that the proposed system can minimize measurement error by reconfiguring the metasurface across frequency variations.


  • Pre-Phased 1-bit Reflective Passive Metasurface With Optimum Number of Pre-Phasing for Low QLL and SLL at 140 GHz

    by Taeyoung Kim, Sangmin Lee, Seongwoog Oh, Jinhyun Kim, Jungsuek Oh, Sangjo Choi

    Recent advancements introduced a pre-phased reflective metasurface (MS) using 1-bit control to suppress the quantization lobe (QL) inherent in a typical 1-bit MS under plane wave incidence, particularly in millimeter and sub-millimeter wave bands. However, the optimal method for pre-phasing using random phases has yet to be fully explored. This study investigates the optimal number of pre-phasing, which denotes the minimum number of discrete random phases for effective suppression of QLs and side lobes while ensuring low design complexity. The results indicate that employing four discrete phases, equally spaced at 45° intervals, is the optimal solution for both normal and oblique incidences. The random phases with a 45° separation are implemented into four pairs of unit cells with passive ON/OFF switching using multilayer PCBs at 140 GHz. Each unit cell consisted of a metallic patch coupled to a transmission (Tx) line through a slot, with embedded static ON/OFF switching in the Tx line to enable 1-bit reflection phase control. Finally, three MSs with 30 × 30 unit cells, each with fixed random pre-phases, are designed and fabricated to reflect normal incidence at reflection angles (θ r ) of 15°, 30°, and 45° at 140 GHz. The experiment results demonstrate peak reflected beams at 15°, 29°, and 45° with frequencies of 139.7 GHz, 139.1 GHz, and 135.9 GHz, respectively. In addition, significant reductions in QL to −20 dB were observed, along with reflection efficiency of 26%, and a 3 dB gain bandwidth exceeding 10%, on average, across all reflection angles in the 140 GHz band.


  • A Low-Profile High-Efficiency Transmitarray Antenna Reflecting Effective Phase Discontinuity With TE/TM Superimpose Analysis

    by Uichan Park, Jinhyun Kim, Taeyeong Yoon, Haeseung Lee, Kyungho Yoo, Jungsuek Oh

    In this study, we propose a high-efficiency, low-profile transmitarray (TA) antenna system and present an efficient design procedure by co-designing a multi-port sub-array antenna to perform as a feed source and the TA simultaneously. The proposed TA antenna supports dual slant polarization (SP). Furthermore, the concept of effective phase discontinuity (EPD) based on a mutual coupling coefficient is introduced for efficient TA design operation at short focal lengths to verify the effectiveness of the advanced unit cell (UC) arrangement with gain enhancement. A TE/TM superimposing method was applied to derive the UC response over the entire area of the aperture of the TA based on the response analysis of a rotated UC satisfying 90° rotational symmetry to TE/TM oblique incidence. The designed TA antenna exhibits a low profile of F/D ratio = 0.33 at a center frequency of 3.5 GHz and a high aperture efficiency of 37%. The measured results are also in good agreement with the simulation results, indicating that the proposed TA antenna system provides an effective design methodology for SP array antennas and low-profile high-gain systems.


  • A Novel Switch-Less Active Bi-Directional Phase Shifter With In–Out Impedance Equalization via Staggered Structure for Ku-Band Applications

    by Uichan Park, Suk Hwangbo, Jinhyun Kim, Taeyeong Yoon, Jungsuek Oh

    In this article, a switch-less vector-sum active bi-directional phase shifter (VABPS) is proposed that operates in the $Ku$ -band and has low root-mean-square (rms) gain and phase errors with low power consumption. While conventional amplification structures address the varying input and output (IO) impedances in bi-directional operation by adding a reconfigurable matching network, this article presents the equivalent IO matching technique that eliminates the need for any additional variable matching network. The three-stack switch-less staggered structure is unveiled to facilitate identical IO impedances. This feature significantly enhances the reliability of bi-directional phase shift operations by mitigating both gain and phase errors. In addition, the optimized transformer-based hybrid coupler (HC) is adopted for generating accurate $I$ and $Q$ signals, followed by a biphase modulator (BM) that creates accurate 180 $^{\circ}$ phase inversion of $I$ and $Q$ signals by resolving the nonideal effect of the HC. The proposed VABPS supports a 6-bit resolution with a phase shift range of 360 $^{\circ}$ and has an rms phase error of less than 2.4 $^{\circ}$ and a gain error of less than 0.55 dB in 13–15 GHz. The suggested VABPS consumes about 15.8 mW. The chip is fabricated in a standard 28-nm CMOS process and the core area is 1.25 $\times$ 1.08 mm $^{2}$ including the pad.


  • Corrections to “A Low Phase Error Vector Modulator Using TEST Tunable I/Q Generator for mmWave Communication”

    by Jinhyun Kim, Seongwoog Oh, Jungsuek Oh

    In the above letter [1] , the title was written as: “A Low Phase Error Vector Modulator Using TEST Tunable I/Q Generator for mmWave Communication.” It should have been correctly written as: “A Low Phase Error Vector Modulator Using Tunable I/Q Generator for mmWave Communication.” The authors regret to notify the readers of IEEE Microwave and Wireless Technology Letters about this error and apologize.

  • A Low Phase Error Vector Modulator Using TEST Tunable I/Q Generator for mmWave Communication

    by Jinhyun Kim, Seongwoog Oh, Jungsuek Oh

    This letter presents a low phase error with a high gain vector modulator in a 28 nm CMOS process. It consists of an input balun network (IBN), a tunable I/Q generator, a variable gain amplifier (VGA), and an output balun network (OBN). The proposed I/Q generator uses two transformer-based couplers and a varactor. Through the control of the varactor, the I/Q generator can optimize the operation frequency at which the phase difference of each quadrature signal is 90 $^{\circ}$ . To implement the proposed I/Q generator, the IBN uses a cascode topology to isolate between the IBN and I/Q generator. The VGA utilizes the Gilbert cell design to control the amplitude of the quadrature signal. The proposed vector modulator achieved a phase shift of 22.5 $^{\circ}$ and had an average root-mean-square (rms) phase error of 2.89 $^{\circ}$ and an rms gain error of 1.57 dB at the 31–36 GHz band. The maximum average gain was $-$ 3.48 dB at 33 GHz, and the power consumption was 28.8 mW from a 1.8 V supply. The proposed vector modulator achieved a high gain with a low rms phase error based on the tunable I/Q generator in the $Ka$ -band.


  • W-Band Switch-Less Reconfigurable-Push Dual-Band VCO Using Clover-Shaped Inductor and Robust Triple Cores for 6G Communications

    by Seongwoog Oh, Jinhyun Kim, Jungsuek Oh

    This study proposes a switchless reconfigurable triple-push/push–push dual-band voltage-controlled oscillator (VCO) topology to design a W -band metal–oxide–semiconductor (CMOS) for 6G communications. The proposed clover-shaped inductor consists of three branch inductors, where each node had a symmetrical layout, connecting to each another and to the output pad. This topology was demonstrated in a W -band VCO using three cross-coupled cores with an ON/OFF-state control to achieve triple-push and push–push operations. An oscillating core based on a robust cross-coupled structure avoids the oscillation startup issue, while achieving a 120 $^\circ$ phase offset through a vector-sum-based method. The measured center frequencies of the bands were 91.04 and 102.33 GHz, with the tuning ranges of 10.4% and 14.1%, respectively. The proposed VCO with an independent core ON/OFF-state control enables a low parasitic switchless frequency band shift, resulting in a superior tuning range compared with those of conventional dual-/single-band VCOs. The effectiveness of this approach was demonstrated through fabrication in a 28-nm CMOS process, with a best FOM $_T$ value of $-$ 178.6 dBc/Hz for the full band.