Dengchao Tian
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Dengchao Tian has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Daorong Li
School of Environmental Engineering, Henan University of Technology, Zhengzhou 450001, China
1 shared publication - Huilin Li
Zhengzhou Institute of Emerging Industrial Technology, Zhengzhou 450003, China
1 shared publication - Ling Zhang
Institute of Process Engineering, Chinese Academy of Sciences, Beijing 100190, China
1 shared publication - Qiang Guo
Institute of Process Engineering, Chinese Academy of Science, Beijing, China
1 shared publication - Suhua Hu
School of Environmental Engineering, Henan University of Technology, Zhengzhou 450001, China
1 shared publication - Yongli Li
State Key Laboratory of Materials Low-Carbon Recycling, College of Materials Science and Engineering, Beijing University of Technology, Beijing 100124, China
1 shared publication
Latest Publications
- Open Access
Preparation of Foamed Ceramics from Graphite Tailings Using A Self-Foaming Method
Graphite tailings were used as the raw materials for the preparation of foamed ceramics via a high-temperature self-foaming method. The residual carbon in the tailings acted as the foaming agent and no additional foaming agents were required. The residual carbon reacted with Fe2O3 and produced gas that was wrapped by the liquid phase to form a porous structure. The effects of sintering temperature, holding time, carbon content, flux on the bulk density, water absorption, and mean pore size of the foamed ceramics were investigated. The bulk density, compressive strength, thermal conductivity, and water absorption of the foamed ceramic prepared using the optimal sample D100 (100 wt% graphite tailings) and sintered at 1200 °C for 20 min were 1.36 g/cm3, 0.35%, 12.03 MPa, and 0.51 W/(m·K), respectively. The raw material contained CaO, Fe2O3, and SiO2, which formed augite with a low fusibility point. In contrast, the molten decomposition products of potassium feldspar and CaSiO3 ions formed anorthite, which has a high fusibility point. Therefore, potassium feldspar is not recommended for use as a flux in tailing systems with high calcium content. Foamed ceramics were prepared using up to 100 wt% graphite tailings. This is a new approach for the economical disposal of graphite tailings.
Open AccessPreparation of Foamed Ceramics from Graphite Tailings Using A Self-Foaming Method
Graphite tailings were used as the raw materials for the preparation of foamed ceramics via a high-temperature self-foaming method. The residual carbon in the tailings acted as the foaming agent and no additional foaming agents were required. The residual carbon reacted with Fe2O3 and produced gas that was wrapped by the liquid phase to form a porous structure. The effects of sintering temperature, holding time, carbon content, flux on the bulk density, water absorption, and mean pore size of the foamed ceramics were investigated. The bulk density, compressive strength, thermal conductivity, and water absorption of the foamed ceramic prepared using the optimal sample D100 (100 wt% graphite tailings) and sintered at 1200 °C for 20 min were 1.36 g/cm3, 0.35%, 12.03 MPa, and 0.51 W/(m·K), respectively. The raw material contained CaO, Fe2O3, and SiO2, which formed augite with a low fusibility point. In contrast, the molten decomposition products of potassium feldspar and CaSiO3 ions formed anorthite, which has a high fusibility point. Therefore, potassium feldspar is not recommended for use as a flux in tailing systems with high calcium content. Foamed ceramics were prepared using up to 100 wt% graphite tailings. This is a new approach for the economical disposal of graphite tailings.