Weihan Gao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Weihan Gao has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Dixian Zhao
Southeast University
3 shared publications - Peng Gu
Southeast University
2 shared publications - Hengzhi Wan
National Mobile Communications Research Laboratory, School of Information Science and Engineering, Southeast University, Nanjing, China
1 shared publication - Huiqi Liu
Chengdu Xphased Technology Company Ltd., Chengdu, China
1 shared publication Jiajun Zhang
National Mobile Communication Research Laboratory, School of Information Science and Engineering, Southeast University, Nanjing, China
1 shared publicationKe Li
Purple Mountain Laboratories, Nanjing, China
1 shared publication
Latest Publications
- 27 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 73 (11) , 9632-9644
A 4.5–18-GHz CMOS Vector-Modulated Phase Shifter With Single-Stage Tunable Polyphase Filter and Built-In Automatic IQ-Vector Calibration Loop
This article presents a frequency-tunable CMOS vector-modulated phase shifter (VMPS) from 4.5 to 18 GHz. The design uses a single-stage tunable polyphase filter (PPF) with a built-in automatic calibration loop (BIACL), which adjusts the PPF resistance based on the detected amplitudes of the in-phase and quadrature (IQ) vectors to achieve center frequency calibration. The structurally optimized BIACL consists of amplitude detectors, a comparator, autocontrol logic, and a resistance digital-to-analog converter (RDAC). The amplitude detector, based on a Gilbert cell, achieves a 23-dB detection range with wide bandwidth and high sensitivity, offering enhanced performance in amplitude detection. For phase control, two independent cascode variable-gain amplifiers (VGAs) with tail-current switches are used for vector modulation. The VMPS is implemented in 65-nm CMOS technology, occupying a core chip area of 1.08 mm2. It demonstrates a wideband 6-bit 360° phase-shifting capability across 4.5–18 GHz with a calibration range from −14 to 2 dBm and achieves <2.3° rms phase error and <1.3-dB maximum gain error.
- 27 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 73 (11) , 9632-9644
A 4.5–18-GHz CMOS Vector-Modulated Phase Shifter With Single-Stage Tunable Polyphase Filter and Built-In Automatic IQ-Vector Calibration Loop
This article presents a frequency-tunable CMOS vector-modulated phase shifter (VMPS) from 4.5 to 18 GHz. The design uses a single-stage tunable polyphase filter (PPF) with a built-in automatic calibration loop (BIACL), which adjusts the PPF resistance based on the detected amplitudes of the in-phase and quadrature (IQ) vectors to achieve center frequency calibration. The structurally optimized BIACL consists of amplitude detectors, a comparator, autocontrol logic, and a resistance digital-to-analog converter (RDAC). The amplitude detector, based on a Gilbert cell, achieves a 23-dB detection range with wide bandwidth and high sensitivity, offering enhanced performance in amplitude detection. For phase control, two independent cascode variable-gain amplifiers (VGAs) with tail-current switches are used for vector modulation. The VMPS is implemented in 65-nm CMOS technology, occupying a core chip area of 1.08 mm2. It demonstrates a wideband 6-bit 360° phase-shifting capability across 4.5–18 GHz with a calibration range from −14 to 2 dBm and achieves <2.3° rms phase error and <1.3-dB maximum gain error.
- 5 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 72 (2) , 776-789
Q/V-Band CMOS Beamforming ICs and Integrated Phased-Array Antennas
This paper presents 256-element transmitter (TX) and receiver (RX) phased arrays for satellite fixed communication at the Q and V bands, which integrate the phased-array antennas with eight-channel beamforming ICs. Wideband vector-modulated phase shifters (VGPS) and combinations of variable gain amplifier (VGA) and attenuators (ATT) are applied in the TX/RX beamforming ICs to achieve phase and gain tunings with large range and high precision. Based on the proposed beamforming ICs, the TX/RX phased arrays are realized with stacked aperture-coupled microstrip antennas on a cost-effective multi-layer PCB. Each array contains 32 TX/RX beamforming ICs, 256 antennas, and a 1-to-32 Wilkinson power divider/combiner networks. Fabricated in 65-nm CMOS technology, the packaged TX IC achieves an RMS gain error of 0.58 dB and an RMS phase error of 4.5 $^{\circ}$ with 78.5-mW dc power per channel, while the $\text{OP}_\text{1dB}$ is 9.6 dBm at 50.5 GHz. The packaged RX IC realizes a 5.3-dB NF, 0.47-dB RMS gain error, and 1.7 $^{\circ}$ RMS phase error with 24.2-mW dc power per channel. The Q/V-band phased arrays are capable of scanning $\pm$ 60 $^{\circ}$ , while the 256-element TX phased array achieves an EIRP of 63.5 dBm. Modulated signal measurements with 200-and 400-MHz QPSK, 16-QAM and 64-QAM are also provided.
- 5 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 72 (2) , 776-789
Q/V-Band CMOS Beamforming ICs and Integrated Phased-Array Antennas
This paper presents 256-element transmitter (TX) and receiver (RX) phased arrays for satellite fixed communication at the Q and V bands, which integrate the phased-array antennas with eight-channel beamforming ICs. Wideband vector-modulated phase shifters (VGPS) and combinations of variable gain amplifier (VGA) and attenuators (ATT) are applied in the TX/RX beamforming ICs to achieve phase and gain tunings with large range and high precision. Based on the proposed beamforming ICs, the TX/RX phased arrays are realized with stacked aperture-coupled microstrip antennas on a cost-effective multi-layer PCB. Each array contains 32 TX/RX beamforming ICs, 256 antennas, and a 1-to-32 Wilkinson power divider/combiner networks. Fabricated in 65-nm CMOS technology, the packaged TX IC achieves an RMS gain error of 0.58 dB and an RMS phase error of 4.5 $^{\circ}$ with 78.5-mW dc power per channel, while the $\text{OP}_\text{1dB}$ is 9.6 dBm at 50.5 GHz. The packaged RX IC realizes a 5.3-dB NF, 0.47-dB RMS gain error, and 1.7 $^{\circ}$ RMS phase error with 24.2-mW dc power per channel. The Q/V-band phased arrays are capable of scanning $\pm$ 60 $^{\circ}$ , while the 256-element TX phased array achieves an EIRP of 63.5 dBm. Modulated signal measurements with 200-and 400-MHz QPSK, 16-QAM and 64-QAM are also provided.
- 1 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 70 (9) , 3253-3257
A DC-87.8-GHz Switched-Type Attenuator With Switched Capacitor Branch in 40-nm CMOS
This paper presents a 5-bit switched-type attenuator (STA) working from DC to 87.8 GHz. In addition to T-type and Π-type attenuation cells with capacitive compensation technique in shunt branch, a new Π-type-based compensation method with switched capacitor branch is proposed, which effectively reduces phase errors at high frequencies without compromising the amplitude errors. The STA in this work is fabricated in 40-nm CMOS technology and the active core area is 0.019 mm, which demonstrates 15.5-dB attenuation range with 0.5-dB tuning step. Across the operational band, the insertion loss of reference state is 1.4-5.3 dB and the return loss is better than 9 dB for all states. From DC to 87.8 GHz, the RMS amplitude and phase errors are below 0.5 dB and 5.4∘ respectively.
- 1 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 70 (9) , 3253-3257
A DC-87.8-GHz Switched-Type Attenuator With Switched Capacitor Branch in 40-nm CMOS
This paper presents a 5-bit switched-type attenuator (STA) working from DC to 87.8 GHz. In addition to T-type and Π-type attenuation cells with capacitive compensation technique in shunt branch, a new Π-type-based compensation method with switched capacitor branch is proposed, which effectively reduces phase errors at high frequencies without compromising the amplitude errors. The STA in this work is fabricated in 40-nm CMOS technology and the active core area is 0.019 mm, which demonstrates 15.5-dB attenuation range with 0.5-dB tuning step. Across the operational band, the insertion loss of reference state is 1.4-5.3 dB and the return loss is better than 9 dB for all states. From DC to 87.8 GHz, the RMS amplitude and phase errors are below 0.5 dB and 5.4∘ respectively.