Barbora Martiníková
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Barbora Martiníková has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Adam Nevrlý
Faculty of Electrical Engineering and Computer Science, VŠB-Technical University of Ostrava, 17. listopadu 15/2172, 708 00 Ostrava-Poruba, Czech Republic
2 shared publications - David Kiča
Public Health Institute Ostrava, Partyzánské Náměstí 2633/7, Moravská Ostrava, 702 00 Ostrava, Czech Republic
2 shared publications - Hana Chaloupecká
Institute of Thermomechanics, Czech Academy of Sciences, 182 00 Prague, Czech Republic
2 shared publications - Jan Suchánek
Heyrovský Institute, Czech Academy of Sciences, 182 00 Prague, Czech Republic
2 shared publications - Jan Wild
Department of Geoecology, Institute of Botany of the Czech Academy of Sciences, Průhonice, 252 43 Czech Republic
2 shared publications - Jiří Sléžka
Faculty of Safety Engineering, VSB-Technical University of Ostrava, Lumírova 630/13, 700 30 Ostrava-Výškovice, Czech Republic
2 shared publications
Latest Publications
- Open Access
- 3 November 2024
- Published by MDPI AG in Atmosphere
- Vol. 15 (11) , 1326
Varying Performance of Low-Cost Sensors During Seasonal Smog Events in Moravian-Silesian Region
Air pollution monitoring in industrial regions like Moravia-Silesia faces challenges due to complex environmental conditions. Low-cost sensors offer a promising, cost-effective alternative for supplementing data from regulatory-grade air quality monitoring stations. This study evaluates the accuracy and reliability of a prototype node containing low-cost sensors for carbon monoxide (CO) and particulate matter (PM), specifically tailored for the local conditions of the Moravian-Silesian Region during winter and spring periods. An analysis of the reference data observed during the winter evaluation period showed a strong positive correlation between PM, CO, and concentrations, attributable to common pollution sources under low ambient temperature conditions and increased local heating activity. The Sensirion SPS30 sensor exhibited high linearity during the winter period but showed a systematic positive bias in readings during Polish smog episodes, likely due to fine particles from domestic heating. Conversely, during Saharan dust storm episodes, the sensor showed a negative bias, underestimating levels due to the prevalence of coarse particles. Calibration adjustments, based on the ratio derived from Alphasense OPC-N3 data, were initially explored to reduce these biases. For the first time, this study quantifies the influence of particle size distribution on the SPS30 sensor’s response during smog episodes of varying origin, under the given local and seasonal conditions. In addition to sensor evaluation, we analyzed the potential use of data from the Copernicus Atmospheric Monitoring Service (CAMS) as an alternative to increasing sensor complexity. Our findings suggest that, with appropriate calibration, selected low-cost sensors can provide reliable data for monitoring air pollution episodes in the Moravian-Silesian Region and may also be used for future adjustments of CAMS model predictions.- 3 November 2024
- Published by MDPI AG in Atmosphere
- Vol. 15 (11) , 1326
Open AccessVarying Performance of Low-Cost Sensors During Seasonal Smog Events in Moravian-Silesian Region
Air pollution monitoring in industrial regions like Moravia-Silesia faces challenges due to complex environmental conditions. Low-cost sensors offer a promising, cost-effective alternative for supplementing data from regulatory-grade air quality monitoring stations. This study evaluates the accuracy and reliability of a prototype node containing low-cost sensors for carbon monoxide (CO) and particulate matter (PM), specifically tailored for the local conditions of the Moravian-Silesian Region during winter and spring periods. An analysis of the reference data observed during the winter evaluation period showed a strong positive correlation between PM, CO, and concentrations, attributable to common pollution sources under low ambient temperature conditions and increased local heating activity. The Sensirion SPS30 sensor exhibited high linearity during the winter period but showed a systematic positive bias in readings during Polish smog episodes, likely due to fine particles from domestic heating. Conversely, during Saharan dust storm episodes, the sensor showed a negative bias, underestimating levels due to the prevalence of coarse particles. Calibration adjustments, based on the ratio derived from Alphasense OPC-N3 data, were initially explored to reduce these biases. For the first time, this study quantifies the influence of particle size distribution on the SPS30 sensor’s response during smog episodes of varying origin, under the given local and seasonal conditions. In addition to sensor evaluation, we analyzed the potential use of data from the Copernicus Atmospheric Monitoring Service (CAMS) as an alternative to increasing sensor complexity. Our findings suggest that, with appropriate calibration, selected low-cost sensors can provide reliable data for monitoring air pollution episodes in the Moravian-Silesian Region and may also be used for future adjustments of CAMS model predictions. - Open Access
- 3 October 2024
- Published by MDPI AG in Preprints.org
Varying Performance of Low-Cost Sensors During Seasonal Smog Events in Moravian-Silesian Region
This study examines the varying performance of low-cost sensors during seasonal smog events, particularly those resulting from solid fuel combustion linked to residential or industrial heating and other pollution sources. A prototype low-cost sensor node developed within this work was collocated for several months with reference equipment at an air quality monitoring station in the city of Ostrava (Moravian-Silesian region, Czech Republic). Deterioration of air quality during a pair of smog alert events, namely wintertime "Polish smog" episode and springtime "Saharan dust storm", which occurred through the extended period of co-location, was characterized quantitatively based on particulate matter and carbon monoxide concentrations measured by the low-cost sensors. These datasets were compared with reference data and model predictions provided by the Copernicus Atmospheric Monitoring Service. Selected low-cost sensors demonstrated linear response during Polish smog episode with highly correlated time series of carbon monoxide and particulate matter concentrations. However, when compared to reference data, the Sensirion SPS30 sensor is found to overestimate coarse particle (PM10) concentrations by the factor of two during winter evaluation period. On the other hand, oppositely biased PM10 response (underestimation by the factor of five) was determined from co-location measurement during Saharan dust storm event. This observation was attributed to combination of specific detection efficiency of the given low-cost sensor and shifts in particle size distribution due to seasonal change of ambient conditions.
- 3 October 2024
- Published by MDPI AG in Preprints.org
Open AccessVarying Performance of Low-Cost Sensors During Seasonal Smog Events in Moravian-Silesian Region
This study examines the varying performance of low-cost sensors during seasonal smog events, particularly those resulting from solid fuel combustion linked to residential or industrial heating and other pollution sources. A prototype low-cost sensor node developed within this work was collocated for several months with reference equipment at an air quality monitoring station in the city of Ostrava (Moravian-Silesian region, Czech Republic). Deterioration of air quality during a pair of smog alert events, namely wintertime "Polish smog" episode and springtime "Saharan dust storm", which occurred through the extended period of co-location, was characterized quantitatively based on particulate matter and carbon monoxide concentrations measured by the low-cost sensors. These datasets were compared with reference data and model predictions provided by the Copernicus Atmospheric Monitoring Service. Selected low-cost sensors demonstrated linear response during Polish smog episode with highly correlated time series of carbon monoxide and particulate matter concentrations. However, when compared to reference data, the Sensirion SPS30 sensor is found to overestimate coarse particle (PM10) concentrations by the factor of two during winter evaluation period. On the other hand, oppositely biased PM10 response (underestimation by the factor of five) was determined from co-location measurement during Saharan dust storm event. This observation was attributed to combination of specific detection efficiency of the given low-cost sensor and shifts in particle size distribution due to seasonal change of ambient conditions.
- 20 December 2022
- Published by SGEM World Science
- Vol. 9, 177-182
TOWARDS A NEW CZECH APPROACH TO THE INVESTIGATION OF INDUSTRIAL ACCIDENTS CAUSES
Industrial accidents, including major accidents involving hazardous chemicals, continue to occur around the world, and the trend, for example according to European Commission statistics, is not particularly downward. It is well known that the consequences of industrial accidents on human health and life, property and environmental components can be devastating. What may not always be identified, however, are the potential causes and possibly the culprits. It should be good practice for the process of identifying the causes and culprits of industrial accidents to involve the interaction and cooperation, not competition, of several stakeholders and institutions (police, fire brigade, occupational safety inspectorate, industrial enterprises, invited experts), depending on the specific legal and national environment. This paper deals with the authors' previous practice and cooperation with the Police of the Czech Republic in the field of investigation, proposing a new systematic approach to the investigation of the causes of industrial accidents involving hazardous substances, trying to cover potential gaps in the existing process, including the necessary annexes and supporting materials. In cooperation with selected commissioners of the Police of the Czech Republic, a new methodology for determining the causes and investigation of industrial accidents was proposed, respecting the current new knowledge and techniques in the field of criminalistics and expert activities. The draft methodology was also created in accordance with traditional Czech criminalistic practice and methodology, the Czech Criminal Procedure Code (no. 141/1961 Coll.), the Criminal Code (no. 40/2009 Coll.) and last but not least the relatively new Czech Act on Experts (no. 254/2019 Coll.).
- 20 December 2022
- Published by SGEM World Science
- Vol. 9, 177-182
TOWARDS A NEW CZECH APPROACH TO THE INVESTIGATION OF INDUSTRIAL ACCIDENTS CAUSES
Industrial accidents, including major accidents involving hazardous chemicals, continue to occur around the world, and the trend, for example according to European Commission statistics, is not particularly downward. It is well known that the consequences of industrial accidents on human health and life, property and environmental components can be devastating. What may not always be identified, however, are the potential causes and possibly the culprits. It should be good practice for the process of identifying the causes and culprits of industrial accidents to involve the interaction and cooperation, not competition, of several stakeholders and institutions (police, fire brigade, occupational safety inspectorate, industrial enterprises, invited experts), depending on the specific legal and national environment. This paper deals with the authors' previous practice and cooperation with the Police of the Czech Republic in the field of investigation, proposing a new systematic approach to the investigation of the causes of industrial accidents involving hazardous substances, trying to cover potential gaps in the existing process, including the necessary annexes and supporting materials. In cooperation with selected commissioners of the Police of the Czech Republic, a new methodology for determining the causes and investigation of industrial accidents was proposed, respecting the current new knowledge and techniques in the field of criminalistics and expert activities. The draft methodology was also created in accordance with traditional Czech criminalistic practice and methodology, the Czech Criminal Procedure Code (no. 141/1961 Coll.), the Criminal Code (no. 40/2009 Coll.) and last but not least the relatively new Czech Act on Experts (no. 254/2019 Coll.).