Luwei Zuo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Luwei Zuo has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Fujun Zheng
College of Electrical Engineering, Zhejiang University, Hangzhou, China
1 shared publication - Haoze Luo
Zhejiang University
1 shared publication - Hui Meng
State Key Laboratory of Reliability and Intelligence of Electrical Equipment, Hebei University of Technology, Tianjin, China
1 shared publication - Jianlong Kang
State Key Laboratory of Intelligent Power Distribution Equipment and System, Hebei University of Technology, Tianjin, China
1 shared publication - Letian Xiang
College of Electrical Engineering, Zhejiang University, Hangzhou, China
1 shared publication - Mohammad Rafiqul Haider
Department of Electrical Engineering and Computer Science University of Missouri 65211 Columbia MO
1 shared publication
Latest Publications
- Open Access
- 26 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Power Electronics
- Vol. 4, 561-566
A Highly Precise On-State Voltage Measurement Circuit With Dual Current Sources for Online Operation of SiC MOSFETs
This letter proposes an on-state drain-source voltage (Vds,on) measurement circuit for SiC MOSFETs. The proposed circuit effectively solves the problem of inconsistent diode volt-ampere characteristics through an additional current source. The voltage difference between the two diodes is compensated by adjusting the auxiliary current under the condition of a fixed first current. This circuit does not require diode pre-selection and significantly improves measurement accuracy. The circuit is implemented in a double-pulse test (DPT) of a SiC MOSFET (900 V/23 A, 25 °C). The results show that the circuit has a fast response speed with a delay time of 0.4μs. Even at the same current, the forward voltage difference between the two diodes reaches 3.32 mV. Compared to measurement results from a six-bit semi-digital multimeter, the measurement error of the proposed circuit is less than 1.5% at different currents and temperatures.
- 26 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Power Electronics
- Vol. 4, 561-566
Open AccessA Highly Precise On-State Voltage Measurement Circuit With Dual Current Sources for Online Operation of SiC MOSFETs
This letter proposes an on-state drain-source voltage (Vds,on) measurement circuit for SiC MOSFETs. The proposed circuit effectively solves the problem of inconsistent diode volt-ampere characteristics through an additional current source. The voltage difference between the two diodes is compensated by adjusting the auxiliary current under the condition of a fixed first current. This circuit does not require diode pre-selection and significantly improves measurement accuracy. The circuit is implemented in a double-pulse test (DPT) of a SiC MOSFET (900 V/23 A, 25 °C). The results show that the circuit has a fast response speed with a delay time of 0.4μs. Even at the same current, the forward voltage difference between the two diodes reaches 3.32 mV. Compared to measurement results from a six-bit semi-digital multimeter, the measurement error of the proposed circuit is less than 1.5% at different currents and temperatures.
- 15 October 2009
- Published by Institution of Engineering and Technology (IET) in IET Circuits, Devices & Systems
- Vol. 3 (5) , 259-267
Wideband injection-locked frequency divider based on a process and temperature compensated ring oscillator
The authors propose a ring-based injection-locked frequency divider (ILFD) incorporating a novel process and temperature compensation technique. The core of the ILFD consists of a process and temperature compensated ring oscillator based on modified symmetric load delay elements. Measurement results show that the natural frequency of oscillation of the ring oscillator varies only 4.4% across six different chips and for a temperature range of 0–80°C. The ILFD possesses a wide locking range over process corners as well as a wide temperature range because of the proposed compensation technique and the incorporation of the delay cell architecture in the design. A calibration circuitry can be used to further enhance the locking range. Measurement results show that the proposed ILFD functions as a divide-by-4 for an input frequency range of 1.8–3.2 GHz for an input power level as low as −3 dBm. The worst-case power consumption was approximately 2 mW from a 1.8 V power supply. The proposed ILFD can be used as a low-power prescaler for multi-band applications.
- 15 October 2009
- Published by Institution of Engineering and Technology (IET) in IET Circuits, Devices & Systems
- Vol. 3 (5) , 259-267
Wideband injection-locked frequency divider based on a process and temperature compensated ring oscillator
The authors propose a ring-based injection-locked frequency divider (ILFD) incorporating a novel process and temperature compensation technique. The core of the ILFD consists of a process and temperature compensated ring oscillator based on modified symmetric load delay elements. Measurement results show that the natural frequency of oscillation of the ring oscillator varies only 4.4% across six different chips and for a temperature range of 0–80°C. The ILFD possesses a wide locking range over process corners as well as a wide temperature range because of the proposed compensation technique and the incorporation of the delay cell architecture in the design. A calibration circuitry can be used to further enhance the locking range. Measurement results show that the proposed ILFD functions as a divide-by-4 for an input frequency range of 1.8–3.2 GHz for an input power level as low as −3 dBm. The worst-case power consumption was approximately 2 mW from a 1.8 V power supply. The proposed ILFD can be used as a low-power prescaler for multi-band applications.