UCUrmimala Chatterjee

Urmimala Chatterjee

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Urmimala Chatterjee has a total of 31 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Poole–Frenkel emission and bulk charge trapping in AlON deposited on GaN and comparison to Al2O3

    by Walter Gonçalez Filho, Matteo Borga, Karen Geens, Arif Khan, Deepthi Cingu, Urmimala Chatterjee, Stefaan Decoutere, Werner Knaepen, Seda Kizir, Panagiota Arnou, et al.

    The leakage conduction mechanisms in AlON dielectric deposited on GaN are identified and compared to the findings for Al2O3. Poole–Frenkel emission from similar trap energy levels was identified in both atomic layer deposited AlON and Al2O3¸ despite at different electric field ranges, while Fowler–Nordheim tunneling dominated the leakage current characteristics for Al2O3 at average electric field values. It is concluded that the differences observed in the leakage characteristics for these dielectrics are likely a result of the slightly larger conduction band offset between AlON and GaN. The identification of the same trap state energy level responsible for Poole–Frenkel emission in AlON and Al2O3 means that this trap state does not originate from the presence of nitrogen in the dielectric and is related to AlOx compounds and the deposition method. Bulk charge trapping is shown to play a major role in the leakage characteristics of AlON from average to high electric fields, which shifts the transfer characteristics from a certain electric field onward and causes hysteresis. These results provide valuable insights into the development of insulated gate architectures on GaN using the promising dielectric material AlON as the gate oxide.


  • 1200-V Dual-Gate p-GaN Bidirectional Switches on 200-mm Engineered Substrates

    by G. Baratella, U. Chatterjee, S. Kumar, M. Borga, K. Geens, A. Vohra, S. Decoutere, B. Bakeroot

    In this article, we present dual-gate bidirectional switches (BDSs) rated for 1200-V operation in both positive and negative biases, fabricated on 200-mm GaN-on-QST1 engineered substrates. The switches are p-GaN gate enhancement-mode (E-mode) high-electron-mobility transistors (HEMTs) that can conduct the current and block the voltage in both directions (drain to source or source to drain). The switches are fabricated with different design variations in the channel length and field-plates (FPs) configuration and are tested in all four conduction modes (on-state, forward and reverse diode modes, and off-state). In addition, a hard breakdown of the device well above the rated voltage is demonstrated, along with initial reliability tests that demonstrate promising performance of the devices.


  • Monolithically Integrated Bootstrapped Gate Driver With a 200-V GaN Power Switch

    by Katia Samperi, Urmimala Chatterjee, Stefaan Decoutere, Salvatore Pennisi

    This paper presents the design and experimental measurement of a fully integrated gate driver fabricated together with a 200-V GaN power switch in a GaN-on-SOI technology. The driver exploits 20-V low-voltage enhancement-mode HEMTs (E-HEMTs), Metal-Insulator-Metal (MIM) bootstrap capacitors and two-dimensional electron gas (2DEG) resistors. To overcome the inherent lack of p-channel devices in the GaN technology, the design employs the bootstrapping approach which allows for full turn-on of the 200-V power GaN switch while minimizing static power consumption. Furthermore, the relatively high breakdown voltage (20 V) of the low-power E-HEMTs allows them to withstand the high voltages generated during bootstrapping. Static power consumption is further reduced by minimizing the number of ratioed logic inverters and implementing an anti-cross-conduction network to eliminate cross-conduction switching losses. The design also leverages the third quadrant of the HEMTs’ IDS-VDS characteristic to emulate the diode behavior, potentially reducing external component requirements. Measured performance reveals an average gate driver current consumption ranging from 370 μA at -40 ∘C to 150 μA at 150 ∘C. Additionally, the rise and fall times when driving the power switch with 365-mΩ on-resistance are respectively 6.5 ns and 3.5 ns at room temperature.


  • Open Access

    60-dB 70-V/ μ s Three-Stage Op-Amp With Dual Single-Miller Frequency Compensation in GaN-IC Technology

    by Katia Samperi, Urmimala Chatterjee, Salvatore Pennisi

    Modern high-performance electronics is pushing Si technology to its limits. Gallium Nitride (GaN) emerges as a promising alternative due to its superior properties in high-frequency and high-power applications. To fully utilize the fast-switching ability of the GaN technology, monolithic integration is a key. A monolithically integrated GaN power IC (Integrated Circuit) reduces the inductive parasitic enabling a fast efficient switching operation. However, GaN basic building blocks, particularly operational amplifiers (Op-Amps), face severe challenges due to the limitations of the GaN technology. This paper presents the first three-stage Op-Amp for high-performance feedback circuits realized in the IMEC’s 200-V GaN-IC technology on a GaN-on-SOI (Silicon on Insulator) substrate. The design utilizes a cascade of three differential stages resistively loaded to achieve a nearly 60-dB DC gain and 25-MHz gain-bandwidth and implements a novel dual single-Miller frequency compensation technique to provide closed-loop stability. The Op-Amp offers a Slew Rate exceeding 70 V/μs with 1% settling time of about 120 ns at room temperature. The correct circuit functionality from −40 °C to 150 °C was demonstrated through simulations and experimental test.


  • Monolithic 650-V Dual-Gate p-GaN Bidirectional Switch

    by G. Baratella, U. Chatterjee, O. Syshchyk, M. Borga, E. Fabris, T. Cosnier, B. Bakeroot, S. Decoutere

    This article is about the study and characterization of a monolithically integrated dual-gate bidirectional switch (BDS) realized in a CMOS-compatible gallium nitride (GaN) pilot line. The switch is based on a p-GaN gate enhancement-mode (E-mode) high-electron-mobility transistor (HEMT) rated for 650 V and provides a symmetrical electrical operation in positive and negative bias conditions while achieving comparable performance to the traditional HEMT and, with respect to the implementation of conventional BDSs, the overall on-resistance is sensibly lower. Several layout variations are discussed both through the electrical measurements and technology CAD (TCAD) simulations, together with comparisons with the reference HEMT, providing valuable insights into the design optimization of dual-gate BDSs.


  • An Introduction to Wire-Bondless Discrete GaN Power Packages With Top-Side Cu Sinterconnects®

    by Kaneeze Noorul Ain, Guo Qi Zhang, Augusto Rodrigues, Nazmul Hasan, Dominik Holzmann, Karen Geens, Urmimala Chatterjee, Ali Roshanghias

    Power electronic modules have undergone a remarkable transition in terms of power density, temperature, and performance due to the shift from Si to WBG (Wide bandgap) semiconductors. WBG semiconductors with their high switching speed, high breakdown voltage and higher operation temperature outperform their Si counterparts. However, the current power packaging technologies are not sufficient to benefit from the superior properties of these WBG devices. For Si power electronic packaging, the traditional 500 µm Al wire bonding as top-side interconnection can carry a maximum current of 10 A which can be increased by parallel connections. However, the need for a higher current carrying capacity with a lower feature size is desirable for WBG devices. As a result, the conventional wire-bonding technology hinders these devices from reaching their full potential due to parasitics, heat dissipation, and reliability issues. To address these challenges, several wire bondless interconnection technologies have been proposed and developed. Among these technologies, a new alternative technology has been recently introduced by our group in which wire bonds are being replaced by printed Cu paste interconnects known as ‘Cu sinterconnects®’, So far, sinterconnects® have been only integrated into large IGBT power module packages where their efficiency has been proven. In this study, sinterconnects have been further optimized to be integrated into GaN-based discrete device discrete packages with fine feature sizes. The packaged GaN devices with fine-sinterconnects® were further characterized and compared with the standard wire-bonded GaN packages.


  • Mg activation anneal of the p-GaN body in trench gate MOSFETs and its effect on channel mobility and threshold voltage stability

    by Walter Gonçalez Filho, Matteo Borga, Karen Geens, Arif Khan, Deepthi Cingu, Urmimala Chatterjee, Anurag Vohra, Stefaan Decoutere, Benoit Bakeroot

    This work addresses the impact of the Mg activation anneal step and the resulting acceptor concentration on the channel mobility and VT stability of vertical MOSFETs. Increasing the annealing time with N2 only ambient and the annealing temperature with O2 in the ambient is shown to be effective in increasing the channel acceptor concentration. When the effective acceptor concentration is increased, the mobility is degraded due to a transition in the main scattering mechanism from Coulomb to surface roughness scattering. Degradation of the on-state current and maximum transconductance at high operating temperatures was linked to bulk mobility degradation of the drift layer due to lattice scattering. The two Mg activation annealing conditions considered here show different trends with regard to the threshold voltage stability, while N2 only ambient did not impact this parameter, including O2 increased threshold voltage instability. It is shown that increasing the Mg chemical concentration in the p-GaN layer degrades channel mobility and threshold voltage stability, irrespectively of the effective acceptor concentration, providing evidence for degradation of the channel/dielectric interface characteristics with higher Mg chemical concentration. This study shows that it is possible to achieve very low threshold voltage hysteresis and high channel mobility by reducing the Mg chemical concentration while maintaining high effective acceptor concentration. These results provide key insights for the development of vertical GaN FETs.


  • Open Access

    Substrate Network Modeling for Lateral p-GaN Gate HEMTs in a 200V GAN-IC Platform

    by Mojtaba Alaei, Herbert De Pauw, Urmimala Chatterjee, Stefaan Decoutere, Johan Lauwaert, Benoit Bakeroot

    In a monolithically integrated GaN-IC, the parasitic inductance, capacitance and resistance between the driver and the half-bridge is greatly reduced. In a GaN-IC platform on SOI combined with oxide filled deep trench isolation, the back-gating effect on the high-side power device is eliminated. Yet some issues related to the epitaxial stack and the substrate contact layer need to be addressed. In this paper, a substrate network concept is presented for 200V p-GaN gate HEMTs on SOI, and the impact of the epitaxial stack on device operation is investigated through modeling the epitaxial stack as a parallel R-C network. Double pulse tests were simulated and the impact on the substrate current was investigated. It is concluded that the substrate current peaks have a strong dependency on the epitaxial stack and the switching times, and that the peaks can be reduced by increasing the substrate layer resistivity.


  • A fully integrated half-bridge driver circuit in All-GaN GAN-IC technology

    by Urmimala Chatterjee, Herbert De Pauw, Olga Syshchyk, Thibault Cosnier, Anurag Vohra, Stefaan Decoutere


  • Characterization of Enhancement-Mode Asymmetrical GaN Transistor Half Bridge in High Frequency Operation

    by Wei-Ren Lin, Urmimala Chatterjee, Wilmar Martinez

    In this paper, an enhancement-mode asymmetrical GaN transistor half-bridge fabricated on 200mm GaN-on-SOI substrate is analysed, and the performance at 1 MHz and 2MHz switching frequency is evaluated. Comparisons with symmetrical commercial GaN transistor half-bridge under the same operation are made. The benefits of optimized selections of the high-side and low-side devices are discussed. By choosing an optimized high-side device, a higher slew rate with an acceptable overshoot voltage is achieved.