CGCarrel da Gomez

Carrel da Gomez

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Carrel da Gomez has a total of 45 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Validation of a Low-Permittivity PCB Substrate for Compact 28-GHz Phased Array Antennas

    by Carrel da Gomez, Weichu Chen, Dongwon You, Xi Fu, Ibrahim Abdo, Shimpei Yakuwa, Naoki Nagaoka, Yasuto Ishimaru, Atsushi Shirane, Kenichi Okada

    This letter presents the validation of a low-permittivity (εr = 1.88) PCB substrate for compact, 28-GHz phased-array antennas. A grounded-coplanar-waveguide(CPWG) feed and a three-layer stack-upwere verified using a TRL calibration board, confirming stable performance up to 60 GHz. A single via-fed patch antenna on the new laminate achieved 7.1 dBi gain, 3.2 dB higher than that on Megtron6 (εr = 3.7). A 1 × 4 array was implemented on the same stack-up achieved 9.2 dBi broadside gain and up to 0.8 dB lower scan loss at 60° compared with Megtron6. These results demonstrate the importance of substrate selection and highlight the potential of this laminate for PCB-based millimeter-wave antennas.

  • Open Access

    A 52 Gb/s 8.9-dBm EIRP 300-GHz-Band Amplifier-Last Outphasing Transmitter With Path Mismatch Calibration in 65-nm CMOS

    by Chun Wang, Olivia Angel Yong, Hans Herdian, Wenqian Wang, Abanob Shehata, Carrel da Gomez, Chenxin Liu, Yudai Yamazaki, Kazuaki Kunihiro, Hiroyuki Sakai, et al.

    This article presents a 300-GHz-band amplifier-last outphasing phased-array transmitter with path mismatch calibration in a 65-nm CMOS technology. Calibration is essential for mitigating impairments in outphasing systems used for wideband communication. The transmitter integrates two independent sub-THz LO generation chains to calibrate the phase mismatch between two paths and configure the phase delay between different phased-array elements. An integrated RF outphasing amplifier calibrates the amplitude mismatch and improves the transmitter’s effective isotropic radiated power (EIRP). After calibration, the transmitter exhibits a 3.3-dB improvement in error vector magnitude and supports 16 QAM modulation at 52 Gb/s over a distance of 9 cm. It achieves a peak EIRP of 8.9 dBm at 246 GHz, with a minimum EIRP of 5.0 dBm across the frequency range from 237 to 250 GHz. An 8×1 phased-array transmitter is implemented, demonstrating a main lobe scanning range of ±12° in the $E$ -plane.

  • Open Access

    A 300-GHz-Band 16.2-dBm EIRP Four-Element Amplifier-Last Phased-Array Transmitter With On-Chip Vivaldi Antenna in 65-nm CMOS

    by Chun Wang, Hans Herdian, Wenbin Zheng, Olivia Angel Yong, Chenxin Liu, Jill Mayeda, Yuxuan Liu, Wenqian Wang, Yuncheng Zhang, Carrel da Gomez, et al.


  • Open Access

    Experimental Testbed for Frequency-Division Multiplexed Joint Radar–Communication System Validation in D-Band Using a 65-nm CMOS Communication Transceiver

    by Carrel da Gomez, Chenxin Liu, Hans Herdian, Hiroyuki Sakai, Kazuaki Kunihiro, Kenichi Okada

    This paper introduces a testbed for joint radar-communication (JRC) utilizing frequency-division multiplexing (FDM) in the D-band (116–170 GHz). It employs a wideband 65 nm CMOS transceiver, originally designed for high-throughput communications. Utilizing external frequency-modulated continuous-wave (FMCW) chirps, it achieves a range resolution of 13.6mm and sub-millimeter accuracy in radar-only mode. In simultaneous JRC operation, it sustains a 24mm range resolution while supporting data rates up to 20 Gb/s using 16-QAM and 32-QAM modulation schemes. A single-transmitter, single-receiver (1T1R) configuration is used to demonstrate radar and communication coexistence within a shared spectrum, whereas an extended single-transmitter, two-receiver (1T2R) setup validates the simultaneous demodulation of both direct and reflected links, demonstrating multi-user capabilities. Doppler measurements are used to verify low-speed velocity sensing via segmented acquisition, illustrating how factors such as distance, radar cross section (RCS), and beam alignment together impact signal-to-noise ratio (SNR), radar visibility, and the quality of the communication link. This system-level validation marks the first experimental proof of a communication-focused architecture in the D-band, establishing the feasibility of scaling existing CMOS hardware for future integrated system-on-chip (SoC) solutions capable of simultaneous high-speed communication and fine-resolution sensing.


  • Open Access

    A Sub-THz Full-Duplex Phased-Array Transceiver With Self-Interference Cancellation and LO Feedthrough Suppression

    by Chun Wang, Ibrahim Abdo, Chenxin Liu, Carrel da Gomez, Jill Mayeda, Hans Herdian, Wenqian Wang, Xi Fu, Dongwon You, Abanob Shehata, et al.

    A sub-THz (88–136 GHz) full-duplex (FD) phased-array transceiver (TRX) integrating an RF self-interference (SI) canceller with differential feeding FD antennas is presented in this work. The LO phase generation chain controls differential transmitter outputs for the phased-array operation. The differential feeding FD antenna with differential pairs of chips achieves over 35-dB SI suppression. The SI suppression is improved by 20 dB when the SI canceller is turned on. Without any digital-domain SI cancellation (SIC), a total SI suppression of $>$ 60 dB is achieved over a 2-GHz bandwidth. The proposed neutralized mixer with over 20-dB LO feedthrough suppression and wideband RF amplifiers support a large data rate at sub-THz frequencies. This is the world’s first demonstrated sub-THz FD phased-array TRX. In the over-the-air (OTA) measurements for FD mode, the proposed FD TRX achieves 6 Gb/s in 8PSK and 4 Gb/s in 16QAM. It also achieves a 112-Gb/s data rate for OTA TX-to-RX.


  • Open Access

    A Ka-Band Deployable Active Phased Array Transmitter Fabricated on 4-Layer Liquid Crystal Polymer Substrate for Small-Satellite Mount

    by Dongwon You, Xiaolin Wang, Hans Herdian, Xi Fu, Hojun Lee, Michihiro Ide, Carrel Da Gomez, Zheng Li, Jill Mayeda, Daisuke Awaji, et al.

    Lightweight and deployable phased arrays are important in Small-Satellite (Small-Sat) constellation systems to reduce price and increase link distance. This article proposes a Ka-band deployable active phased-array TX on a 4-layer liquid crystal polymer (LCP) board for a lightweight and high stowage rate solution to break through the trade-off between high antenna aperture size and small form factor in phased arrays. This article describes detailed designs of the phased array and its building blocks with the proposed 4-layer LCP substrate structure. Assembled with the beamformer ICs (BFIC), a Ka-band 8×4-element deployable active phased-array TX on the 4-layer LCP substrate is fabricated. The proposed deployable phased-array TX can steer the beam from -50° to 50°. The phased-array TX can drive 32-APSK DVB-S2 signal with a -28.7 dB EVM as well, revealing that the deployable phased-array TX performs with high phased-array performance. Furthermore, the TX achieved the lightest and thinnest phased array with 0.96 kg/m 2 areal mass and 0.9 mm thickness. This groundbreaking research sets the stage for the realization of affordable and user-centric satellite communication (SATCOM) in low-earth orbit (LEO).