PHPaul Hayden

Paul Hayden

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Paul Hayden has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Passive scalar transport in a cross-ventilating flow with upstream source: wind and water tunnel measurements

    by Subhajit Biswas, Paul Hayden, Matteo Carpentieri, Christina Vanderwel

    In urban environments, pollutant ingress from outdoor sources poses a significant challenge to indoor air quality. Cross-ventilation, while essential for passive cooling and natural airflow, can also facilitate the entry of outdoor contaminants into indoor spaces. To investigate the dynamics of outdoor-to-indoor pollutant transport, the present study employs an idealized configuration, namely, a hollow cube representing a scaled-down model building with window openings in the upstream and downstream faces, subjected to an upstream passive scalar source within an atmospheric boundary layer. The experiments are conducted in two distinct facilities: a water tunnel using Rhodamine dye as the scalar, and a wind tunnel using propane gas, all performed at a specified flow Reynolds number of $$ \text{Re} = U_{{{\text{Ref}}}} H/\nu \approx 50,000 $$ Re = U Ref H / ν ≈ 50 , 000 for a fixed boundary layer-to-cube height ratio of about 3; here, $$ U_{{{\text{Ref}}}} $$ U Ref is the streamwise velocity at cube’s height ( H ) measured without the cube. The scalar, released from a ground-level upstream source, is predominantly transported by a streamwise advective flux, while relatively weaker wall-normal advective and turbulent fluxes contribute to vertical dispersion and local mixing. A fraction of the oncoming scalar enters the cube intermittently, through the upstream window. Inside, a central jet-like flow carries the scalar parcels primarily by streamwise advective flux, while also interacting with the upper and lower recirculation regions, enabling scalar exchange across these zones through wall-normal advective and turbulent fluxes. While the time-averaged concentration field inside the cube is nearly uniform, suggesting effective mixing, instantaneous concentration traces exhibit strong intermittency, with sporadic peak events, highlighting the risk of transient peak exposures. The indoor concentration exponentially decays over time once the source is turned off, with a slower decay in the upper recirculation region, implying relatively prolonged exposure near the ceiling region. Both experimental setups produce closely matching values and consistent trends in the spatio-temporal dynamics of scalar concentration, and also highlight their complementary nature, with each offering distinct advantages. The present findings will deepen our understanding of pollutant ingress and mixing in buildings in cross-ventilated flows and also offer valuable insights to future modeling of pollutant exposure in urban indoor spaces.


  • Open Access

    Passive scalar transport in a cross-ventilating flow with upstream source: Wind and Water tunnel measurements

    by Subhajit Biswas, Paul Hayden, Matteo Carpentieri, Christina Vanderwel

    In urban environments, pollutant ingress from outdoor sources poses a significant challenge to indoor air quality. Cross-ventilation, while essential for passive cooling and natural airflow, can also facilitate the entry of outdoor contaminants into indoor spaces. To investigate the dynamics of outdoor-to-indoor pollutant transport, the present study employs an idealised configuration, namely a hollow cube representing a scaled-down model building with window openings in the upstream and downstream faces, subjected to an upstream passive scalar source within an atmospheric boundary layer. The experiments are conducted in two distinct facilities: a water tunnel using Rhodamine dye as the scalar, and a wind tunnel using propane gas, all performed at a specified flow Reynolds number of Re = U Ref H/ν ≈ 50, 000 for a fixed boundary layer-to-cube height ratio of about 3; here, U Ref is the streamwise velocity at cube’s height (H) measured without the cube. The scalar, released from a ground-level upstream source, is predominantly transported by a streamwise advective flux, while relatively weaker wall-normal advective and turbulent fluxes contribute to vertical dispersion and local mixing. A fraction of the oncoming scalar enters the cube intermittently, through the upstream window. Inside, a central jet-like flow carries the scalar parcels primarily by streamwise advective flux, while also interacting with the upper and lower recirculation regions, enabling scalar exchange across these zones through wall-normal advective and turbulent fluxes. While the time-averaged concentration field inside the cube is nearly uniform, suggesting effective mixing, instantaneous concentration traces exhibit strong intermittency, with sporadic peak events, highlighting the risk of transient peak exposures. The indoor concentration exponentially decays over time once the source is turned off, with a slower decay in the upper recirculation region, implying relatively prolonged exposure near the ceiling region. Both experimental setups produce closely matching values and consistent trends in the spatio-temporal dynamics of scalar concentration, and also highlight their complementary nature, with each offering distinct advantages. The present findings will deepen our understanding of pollutant ingress and mixing in buildings in cross-ventilated flows and also offer valuable insights to future modelling of pollutant exposure in urban indoor spaces.

  • Open Access

    Dynamic calibration of a high-resolution wind tunnel model for ultra-low-range fluctuating surface pressure measurement

    by Joy Schmeer, Paul Hayden, David M Birch

    Measuring surface pressures in a low-speed wind tunnel which are well-resolved in both space and time can be particularly challenging. A technique has therefore been developed for the simultaneous dynamic calibration of large numbers of pressure tappings on a wind tunnel model. A portable, variable-volume plenum is used to calibrate the model in situ. A forcing function consisting of sequential sinusoids at varying frequencies is used to obtain the spectral responses, with feedback control implemented to ensure consistent amplitudes independent of the plenum’s own dynamics. This discrete calibration technique is shown to significantly reduce uncertainty propagation compared to white noise, chirp or step functions. The effectiveness of the dynamic calibration is validated against laser diagnostics in turbulent flow. As a demonstration of the capability of this technique, spatially-resolved surface pressure statistics are then presented for the five wetted faces of a cube in an atmospheric wind tunnel turbulent boundary layer.


  • Open Access

    The wake of a large wind turbine in stable atmospheric boundary layer flow, simulated in the EnFlo stratified-flow wind tunnel

    by Philip E. Hancock, Paul Hayden

    The EnFlo stratified-flow wind tunnel is described, and the parameterization of stable atmospheric boundary layers in the context of wind turbines and stability classification is given, as are the scaling constraints for stratified-flow wind tunnel experiments. Wake measurements of mean velocity, Reynolds stresses, and turbulent heat flux were made for three mild stable states, including overlying inversion, and the neutral state. The depth of the atmospheric boundary layer was kept constant, and so the results show the effect of change in stability alone, without the change in scale that would also arise in full scale measurements, an advantage provided by wind tunnel experiments. The simulated boundary-layer wind-speed profile is the same in each case, its height slightly exceeding the blade-tip top height, and the velocity deficit at the turbine is also the same in each, implying a constant thrust coefficient. In the near wake the momentum deficit rises more rapidly in the stable cases, and stays higher further downstream where it is subsequently reduced by turbulent mixing. The wake grows less rapidly in the vertical direction in the stable cases, both above and below the hub height, the height above growing still less rapidly with an imposed inversion, while the height below is unaffected by the inversion. The wake width is largely unaffected by stability. Stability reduces the Reynolds stresses in the wake over and above the reduction in the undisturbed flow; there is not a simple superposition. In the lower part of the wake the stresses are not affected by the inversion, while they are in the upper part. Turbulent heat flux is increased in the bulk of the wake, more so with an inversion, but is reduced to the surface and unaffected by an inversion.


  • Open Access

    Wind turbine wakes: experimental investigation of two-point correlations and the effect of stable thermal stability

    by Marco Placidi, Philip E. Hancock, Paul Hayden

    Wind tunnel experiments are performed in both neutral and stable boundary layers to study the effect of thermal stability on the wake of a single turbine and on the wakes of two axially aligned turbines, thereby also showing the influence of the second turbine on the impinging wake. In the undisturbed stable boundary layers, the turbulence length scales are significantly smaller in the vertical and longitudinal directions (up to 50 % and $\approx$ 40 %, respectively), compared with the neutral flow, while the lateral length scale is unaffected. The reductions are larger with the imposed inversion of a second stable case, except in the near-wall region. In the neutral case, the length scales in the wake flow of the single turbine are reduced both vertically and laterally (up to 50 % and nearly 40 %, respectively). While there is significant upstream influence of a second turbine (on mean and turbulence quantities), there is virtually no upstream effect on vertical length scales. However, curiously, the presence of the second turbine aids length-scale recovery in both directions. Longitudinally, each turbine contributes to successive reduction in coherence. The effect of stability on the turbulence length scales in the wake flows is non-trivial: at the top of the boundary layer, the reduction in the wall-normal length scale is dominated by the thermal effect, while closer to the wall, the wake processes strongly modulate this reduction. Laterally, the turbines’ rotation promotes asymmetry, while stability opposes this tendency. The longitudinal coherence, significantly reduced by the wake flows, is less affected by the boundary layer's thermal stability.


  • Open Access

    Mapping the effects of ozone pollution and mixing on floral odour plumes and their impact on plant-pollinator interactions

    by Ben Langford, James M.W. Ryalls, Neil J. Mullinger, Paul Hayden, Eiko Nemitz, Christian Pfrang, Alan Robins, Dalila Touhami, Lisa M. Bromfield, Robbie D. Girling


  • Open Access

    Wind-Tunnel Simulation of Weakly and Moderately Stable Atmospheric Boundary Layers

    by Philip E. Hancock, Paul Hayden

    The simulation of horizontally homogeneous boundary layers that have characteristics of weakly and moderately stable atmospheric flow is investigated, where the well-established wind engineering practice of using ‘flow generators’ to provide a deep boundary layer is employed. Primary attention is given to the flow above the surface layer, in the absence of an overlying inversion, as assessed from first- and second-order moments of velocity and temperature. A uniform inlet temperature profile ahead of a deep layer, allowing initially neutral flow, results in the upper part of the boundary layer remaining neutral. A non-uniform inlet temperature profile is required but needs careful specification if odd characteristics are to be avoided, attributed to long-lasting effects inherent of stability, and to a reduced level of turbulent mixing. The first part of the wind-tunnel floor must not be cooled if turbulence quantities are to vary smoothly with height. Closely horizontally homogeneous flow is demonstrated, where profiles are comparable or closely comparable with atmospheric data in terms of local similarity and functions of normalized height. The ratio of boundary-layer height to surface Obukhov length, and the surface heat flux, are functions of the bulk Richardson number, independent of horizontal homogeneity. Surface heat flux rises to a maximum and then decreases.