TJTongling Jing

Tongling Jing

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Tongling Jing has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Energy Variation Features during the Isothermal Adsorption of Coal under High-Temperature and High-Pressure Conditions

    by Tongling Jing, Chuanqi Tao, Yanbin Wang, Huan Miao, Mingyu Xi, Xingchen Zhao, Haiyang Fu

    This paper aims to describe methane adsorption in coal under the conditions of high temperature and high pressure, as well as quantitatively decipher the change rule of energy in the isothermal adsorption process. The isothermal adsorption test was carried out with four groups of middle-rank coals from the Linxing area with different degrees of metamorphism. The impacts of the degree of deterioration of coal, temperature, and pressure on adsorption were analyzed with regard to the adsorption amount, adsorption potential, and adsorption space. Additionally, the energy change during the adsorption of methane by the coal was considered. The results show that the coal adsorption capacity hinges on the degree of deterioration of the coal, as well as the pressure and temperature. Additionally, the impact of temperature upon coal methane adsorption under depth conditions is highlighted. Like the adsorption space, the adsorption potential is an important parameter used to quantitatively characterize the adsorption ease and adsorption capacity; furthermore, the adsorption potential of millipores exceeds that of mesopores, as they are capable of offering a larger specific surface area for adsorption. The total decrease in the surface free energy during adsorption increases as the pressure increases; simultaneously, the increase rate is fast and then slow. The total decrease in the above-described free energy diminishes as the temperature escalates. Under the same pressure, the total decrease in the aforementioned free energy increases as the reflectance of the specular body of the coal increases. The decrease in the aforementioned free energy at each point of pressure lessens as the pressure grows; notably, when the pressure is comparatively low, the reduction is very fast. As the pressure escalates continuously, the decrease speed is slow. Regarding the effect of pressure and temperature upon adsorption, the adsorption gas volume of coal exists in a conversion depth from 1200 m to 1500 m; at the same time, the impact of pressure upon adsorption is dominant up to this depth. Additionally, beyond this depth, temperature gradually comes to have the greatest impact on adsorption.


  • Open Access

    Characteristics of Deep Coal Reservoir and Key Control Factors of Coalbed Methane Accumulation in Linxing Area

    by Chuanqi Tao, Yong Li, Yanbin Wang, Xiaoming Ni, Xiang Wu, Shihu Zhao

    Deep coalbed methane (CBM, commonly accepted as >1500 m) has enormous exploration and development potential, whereas the commercial development of deep CBM exploration areas wordwide has been quite limited. The Linxing area, with coals buried approximately 2000 m deep, shows great development potential. Based on a basic geological analysis of structural and hydrodynamic conditions, combining field tests of reservoir temperature and pressure and indoor measurements of maceral composition, proximate analysis, thermal maturity, porosity and permeability, the factors controlling deep CBM accumulations were discussed. The results show that the present burial depth of the No. 8 + 9 coal seam, mainly between 1698 and 2158 m, exhibits a high reservoir temperature (45.0–64.0 °C) and pressure (15.6–18.8 MPa), except for the uplift area caused by the Zijinshan magma event (with coal depth approximately 1000 m). The maximum vitrinite reflectance (Ro,max) of the coal varies from 1.06% to 1.47%, while the magma-influenced areas reach 3.58% with a relatively high ash content of 31.3% (air-dry basis). The gas content calculated by field desorption tests shows a wide range from 7.18 to 21.64 m3/t. The key factors controlling methane accumulation are concluded from regional geological condition variations. The north area is mainly controlled by structural conditions and the high gas content area located in the syncline zones. The center area is dominated by the Zijinshan magma, with relatively high thermal maturity and a high gas content of as much as 14.5 m3/t. The south area is developed with gentle structural variations, and the gas content is mainly influenced by the regional faults. Furthermore, the groundwater activity in the eastern section is stronger than that in the west, and the hydrodynamic stagnant areas in the western are more beneficial for gas accumulation. The coals vary from 3.35% to 6.50% in porosity and 0.08 to 5.70 mD in permeability; thus, hydrofracturing considering high temperature and pressure should be applied carefully in future reservoir engineering, and the co-production of gas from adjacent tight sandstones also should be evaluated.