RFRongpeng Fu

Rongpeng Fu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Rongpeng Fu has a total of 21 co-authors. Here are the top co-authors by number of shared publications:

  • Aidong Shen

    Department of Electrical Engineering, The City College of New York, New York, NY, USA

    5 shared publications
  • Bingsheng Li

    State Key Laboratory of Integrated Optoelectronics, and Key Laboratory of UV Light Emitting Materials and Technology of Ministry of Education, School of Physics, Northeast Normal University 1 , Changchun 130024

    5 shared publications
  • Weizhe Cui

    State Key Laboratory of Integrated Optoelectronics, and Key Laboratory of UV Light Emitting Materials and Technology of Ministry of Education, School of Physics, Northeast Normal University 1 , Changchun 130024

    4 shared publications
  • Yichun Liu

    State Key Laboratory of Integrated Optoelectronics, and Key Laboratory of UV Light Emitting Materials and Technology of Ministry of Education, School of Physics, Northeast Normal University 1 , Changchun 130024

    4 shared publications
  • Yurui Han

    State Key Laboratory of Integrated Optoelectronics, and Key Laboratory of UV Light Emitting Materials and Technology of Ministry of Education, School of Physics, Northeast Normal University 1 , Changchun 130024

    4 shared publications
  • Chong Gao

    Jilin Provincial Key Laboratory of Wide Bandgap Semiconductor Material Growth and Device Applications, Jilin Normal University 3 , Changchun 130103

    3 shared publications

Latest Publications

  • MOCVD growth of (AlxGa1−x)2O3 (x = 0–0.77) alloyed films for deep UV photodetection applications

    by Xinjian Ma, Yurui Han, Yuefei Wang, Weizhe Cui, Youheng Song, Rongpeng Fu, Jiale Zhang, Zijin Lu, Yujie Wang, Bingsheng Li, et al.

    (AlxGa1−x)2O3 alloy thin films with the tuning bandgap in a range of 4.95–6.26 eV have been achieved by adjusting the Al composition (x ≈ 0–0.77) grown on a c-plane sapphire substrate via metal-organic chemical vapor deposition. With the increase in the bandgap, the fabricated metal–semiconductor–metal (MSM) photodetectors exhibit a gradual blueshift of the spectral response wavelengths from 250 to 198 nm. X-ray diffraction characterization results indicated that the crystal structure of the films transformed from a single monoclinic β-phase (x ≤ 0.57) to a β/γ dual-phase coexistence state (x ∼ 0.67–0.77) with increasing Al composition. The optimal surface morphology and crystalline quality of the films were obtained at an Al composition of 0.20. Combined with the valence-band x-ray photoelectron spectroscopy and bandgap analysis results, it is found that the introduction of Al causes an upward shift of the conduction band minimum relative to the Fermi level, which is consistent with the observed increase in the optical bandgap and blueshift of the spectral response edge. Oxygen vacancy (VO) analysis demonstrates that the VO defect concentration first decreases and then increases with increasing Al composition. Based on these results, the evolution mechanism of VO defects is elucidated, and their intrinsic correlations with lattice strain, phase transition, and thin-film crystalline quality are discussed. The fabricated MSM photodetectors exhibited an excellent comprehensive performance at a bias of 10 V, with the dark current below 10 fA, the specific detectivity of 6.58 × 1014 Jones, and the UV-visible rejection ratio as high as 9.07 × 107. Under 185 nm illumination, the photocurrent to dark current ratio of the device with a high Al composition (x = 0.77) still remains around 1.18 × 102, indicating its excellent detection sensitivity and anti-interference capability in the deep ultraviolet to vacuum ultraviolet wavebands.

  • MOCVD-grown α-Ga2O3 with increased growth rate and improved crystal quality for deep UV optoelectronics application

    by Yujie Wang, Rongpeng Fu, Yurui Han, Youheng Song, Weizhe Cui, Chong Gao, Zhe Wu, Yuefei Wang, Bingsheng Li, Aidong Shen, et al.

    α-Ga2O3 films with a more than threefold increase in growth rate were epitaxially grown on m-Al2O3 at 530 °C by employing a 700 °C high-temperature buffer layer (HTBL) in metal–organic chemical vapor deposition growth. The underlying mechanism of the enhanced growth was understood experimentally by the surface analysis and theoretically by a model based on Gibbs–Thomson equation and first-principles calculations. With HTBL, the crystal quality of the α-Ga2O3 was also significantly improved, as evidenced by the decreased x-ray diffraction rocking curve linewidth of the (303¯0) peak. The linewidth is down to 0.387°, which is significantly narrower than 0.592° from sample without HTBL. The surface morphology of HTBL features larger, more sparsely distributed islands, resulting in a lower chemical potential on the surface, which promotes the adsorption of Ga2O3-clusters by reducing the desorption and thus increases the growth. x-ray photoelectron spectroscopy showed more oxygen vacancies (Vo) on the HTBL surface. First-principles calculations indicated that Vo in the (303¯0)-surface reduced the adsorption energy from −5.48 to −6.61 eV, thereby promoting cluster adsorption. A solar-blind ultraviolet photodetector based-on α-Ga2O3 exhibited an ultra-low dark current of 0.1 pA at 10 V, a high light-to-dark current ratio of 106, a responsivity of 0.54 A/W, and a detectivity of 5.5 × 1012 Jones.


  • Open Access

    Surface passivation enhanced β-Ga2O3-based solar-blind photodetector via introducing an Al2O3 ultrathin layer

    by Bin Yin, Shihao Fu, Weizhe Cui, Rongpeng Fu, Bingsheng Li, Aidong Shen

    The surface properties of semiconductor devices have a significant effect on the transport and recombination of charge carriers, especially for planar structures. In this work, Al2O3 ultrathin layers with varying thicknesses (3, 5, and 10 nm) were introduced into β-Ga2O3 thin films to passivate surface dangling bonds. The passivation effect of Al2O3 was verified through surface state analysis. By comparison, it was found that the photodetector (PD) with a 5 nm Al2O3 passivation layer exhibited a high light–dark current ratio of 1.36 × 106, which was 8.4 times higher than the PD on the bare surface. At the same time, it has a high responsivity of 0.38 A/W, a high detectivity of 3.21 × 1012 Jones, and a fast response speed of 1.88 ms/31.46 ms. Combined with simulation results, it was verified that the Al2O3 passivation layer can effectively improve the electric field distribution and current density. This study unravels the role of dangling bonds passivation in β-Ga2O for high-performance solar-blind PDs.


  • Solar blind avalanche photodetector based on a n-β-Ga2O3/n-Si heterojunction via an introduction of AlN buffer layer for interface lattice and band Engineering

    by Chong Gao, Yuefei Wang, Shihao Fu, Youheng Song, Yurui Han, Rongpeng Fu, Zhe Wu, Weizhe Cui, Jiangang Ma, Bingsheng Li, et al.


  • Open Access

    Performance optimization of self-powered deep ultraviolet photodetector based on PEDOT:PSS/SnO2 organic/inorganic p–n heterojunction by embedding a nitrogen-doped graphene

    by Shihao Fu, Renjing Song, YueFei Wang, RongPeng Fu, Yurui Han, Chong Gao, Jiangang Ma, Haiyang Xu, Bingsheng Li, Aidong Shen, et al.

    A self-powered organic–inorganic p–n heterojunction deep ultraviolet (DUV) photodetector (PD) was fabricated based on the polymer poly(3,4-ethylene-dioxythiophene):polystyrene sulfonate (PEDOT:PSS), with an in situ transferred composite film PEDOT:PSS-nitrogen-doped graphene (NGr)-coated SnO2 microwire. At 0 V bias, the responsivity spectra of these two heterojunction PDs both had a broadband response in the range of 200–400 nm. The introduction of NGr helped to reduce the surface state of SnO2 and improve the shortwave response, resulting in a blue shift of peak position from 280 to 250 nm. Compared with PEDOT:PSS/SnO2 PD, the light–dark current ratio of the PEDOT:PSS-NGr/SnO2 PD was improved three orders of magnitude from 24.76 to 2.51 × 104; the detectivity was increased by 40 times from 1.45 × 1011 to 5.85 × 1012 Jones; and the response speed was accelerated to less than 1 s (with rise and decay times of 0.35 and 0.14 s, respectively). The performance improvement was attributed to the intermediate layer NGr forming a heterojunction with SnO2, which broadened the depletion layer of PEDOT:PSS/SnO2 and increased the strength of the built-in electric field, thereby reducing carrier recombination and boosting the response speed. These findings indicate that introducing NGr is an effective way to modify detector performance.