Roop Singh Lodhi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Roop Singh Lodhi has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Paramita Das
Department of Chemical Engineering, Indian Institute of Science Education and Research Bhopal, Bhopal Bypass Road, Bhopal 462066, Madhya Pradesh, India
4 shared publications - Manas Mandal
Department of Chemical Engineering Indian Institute of Science Education and Research Bhopal Bhopal Bypass Road Bhopal Madhya Pradesh 462066 India
2 shared publications - Anjali Soni
Department of Chemical Engineering, Indian Institute of Science Education and Research Bhopal, Bhopal Bypass Road, Bhopal, Madhya Pradesh 462066, India
1 shared publication Ankit Rathaur
Department of Chemical Engineering, Indian Institute of Science Education and Research Bhopal, Bhopal Bypass Road, Bhopal, Madhya Pradesh 462066, India
1 shared publicationArathi A
Department of Chemical Engineering Indian Institute of Science Education and Research Bhopal Bhopal Bypass Road Bhopal Madhya Pradesh 462066 India
1 shared publicationShivangi Chourasia
Department of Chemical Engineering Indian Institute of Science Education and Research Bhopal Bhopal 462066, Madhya Pradesh India
1 shared publication
Latest Publications
- 11 April 2025
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 226 (13)
Efficient Removal of Cationic Dye Using Rice Straw‐Derived Cellulose Nanocrystal‐Based Adsorptive Nanocomposite Membranes
This work demonstrates the development of adsorptive nanocomposite membranes for the efficient removal of cationic dye from water. The bio‐based adsorptive membrane is prepared using polyvinyl alcohol (PVA) and polydopamine (PDA)‐modified cellulose nanocrystals (PDA@CNCs) supported on a Whatman filter paper via vacuum filtration. The structural characterizations, surface morphology, effects of different operational parameters on methylene blue (MB) dye adsorption by the PVA/PDA@CNC membranes are evaluated. The synthesized membrane with PVA to PDA@CNC feed ratio at 50/50 (PVA/PDA@CNC‐50/50) achieved 98.2% removal efficiency and 1.18 mg g −1 adsorption capacity in 48 h. under the optimized conditions. The adsorption study under shaking at 150 RPM speed further enhanced the membrane performance, exhibiting 93.2% removal efficiency within 8 h of contact time. Regeneration studies demonstrated that the PVA/PDA@CNC = 50/50 membrane maintained over 95% removal efficiency even after five adsorption‐desorption cycles. The pseudo second‐order model best described the kinetics of the adsorption process of the nanocomposite membranes. The experimental data also fitted well with the Freundlich isotherm model predicting that the adsorbent has multilayer adsorption sites on its heterogeneous surface. The nanocomposite membrane also shows good removal performance for Janus Green B, thus displaying its versatility in adsorbing different cationic dyes from water.
- 11 April 2025
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 226 (13)
Efficient Removal of Cationic Dye Using Rice Straw‐Derived Cellulose Nanocrystal‐Based Adsorptive Nanocomposite Membranes
This work demonstrates the development of adsorptive nanocomposite membranes for the efficient removal of cationic dye from water. The bio‐based adsorptive membrane is prepared using polyvinyl alcohol (PVA) and polydopamine (PDA)‐modified cellulose nanocrystals (PDA@CNCs) supported on a Whatman filter paper via vacuum filtration. The structural characterizations, surface morphology, effects of different operational parameters on methylene blue (MB) dye adsorption by the PVA/PDA@CNC membranes are evaluated. The synthesized membrane with PVA to PDA@CNC feed ratio at 50/50 (PVA/PDA@CNC‐50/50) achieved 98.2% removal efficiency and 1.18 mg g −1 adsorption capacity in 48 h. under the optimized conditions. The adsorption study under shaking at 150 RPM speed further enhanced the membrane performance, exhibiting 93.2% removal efficiency within 8 h of contact time. Regeneration studies demonstrated that the PVA/PDA@CNC = 50/50 membrane maintained over 95% removal efficiency even after five adsorption‐desorption cycles. The pseudo second‐order model best described the kinetics of the adsorption process of the nanocomposite membranes. The experimental data also fitted well with the Freundlich isotherm model predicting that the adsorbent has multilayer adsorption sites on its heterogeneous surface. The nanocomposite membrane also shows good removal performance for Janus Green B, thus displaying its versatility in adsorbing different cationic dyes from water.
- Top Cited Papers
- 16 January 2025
- Published by Wiley in Chempluschem
- Vol. 90 (3) , e202400643
A Review on Sustainable Slow‐Release N, P, K Fertilizer Hydrogels for Smart Agriculture
The agricultural sector of any country plays a pivotal role in its economy. Irrigation and the provision of appropriate nutrient levels in soil are essential for optimizing plant growth and enhancing crop productivity. To support the increasing need for food due to the growing population worldwide, synthetic fertilizers have been widely used in the agricultural sector. These fertilizers could readily dissolve in the irrigation water or soil moisture, causing excessive release of the nutrients that plants cannot uptake from the root zone. The excess nutrients in the soil further harm the environment via surface run‐off, leaching, and volatilization. Thus, materials with high water absorption and retention capacity, and precise control over the prolonged fertilizer release offer a potential solution to address these issues. To meet these requirements, the development of slow‐release fertilizer hydrogels (SRFHs) represents a promising approach. SRFHs serve as natural agrochemicals to enhance crop growth and yield through controlled and self‐sustained delivery of water and nutrients. This review provides a comprehensive study on the recent advancements in SRFHs, including their preparation methods, properties, slow‐release behavior, and applications in smart agriculture. The response of soil microbial diversity to slow‐release fertilizers is briefly discussed, and the future potential of SRFHs is highlighted herein.
- 16 January 2025
- Published by Wiley in Chempluschem
- Vol. 90 (3) , e202400643
Top Cited PapersA Review on Sustainable Slow‐Release N, P, K Fertilizer Hydrogels for Smart Agriculture
The agricultural sector of any country plays a pivotal role in its economy. Irrigation and the provision of appropriate nutrient levels in soil are essential for optimizing plant growth and enhancing crop productivity. To support the increasing need for food due to the growing population worldwide, synthetic fertilizers have been widely used in the agricultural sector. These fertilizers could readily dissolve in the irrigation water or soil moisture, causing excessive release of the nutrients that plants cannot uptake from the root zone. The excess nutrients in the soil further harm the environment via surface run‐off, leaching, and volatilization. Thus, materials with high water absorption and retention capacity, and precise control over the prolonged fertilizer release offer a potential solution to address these issues. To meet these requirements, the development of slow‐release fertilizer hydrogels (SRFHs) represents a promising approach. SRFHs serve as natural agrochemicals to enhance crop growth and yield through controlled and self‐sustained delivery of water and nutrients. This review provides a comprehensive study on the recent advancements in SRFHs, including their preparation methods, properties, slow‐release behavior, and applications in smart agriculture. The response of soil microbial diversity to slow‐release fertilizers is briefly discussed, and the future potential of SRFHs is highlighted herein.
- 18 October 2024
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 6 (21) , 12947-12963
Poly(lactic acid)/Cellulose Nanocrystal-Based Compositional Gradient Nanocomposites with Higher Toughness: Potential for Flexible Packaging
- 18 October 2024
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 6 (21) , 12947-12963
Poly(lactic acid)/Cellulose Nanocrystal-Based Compositional Gradient Nanocomposites with Higher Toughness: Potential for Flexible Packaging
- 7 September 2023
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 6 (18) , 16580-16594
Bioinspired Nanocomposites of Sodium Carboxymethylcellulose and Polydopamine-Modified Cellulose Nanocrystals for UV-Protective Packaging
- 7 September 2023
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 6 (18) , 16580-16594
Bioinspired Nanocomposites of Sodium Carboxymethylcellulose and Polydopamine-Modified Cellulose Nanocrystals for UV-Protective Packaging