SNSeiya Nitta

Seiya Nitta

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Seiya Nitta has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Development of Laser Ultrasonic Robotic System for In Situ Internal Defect Detection

    by Seiya Nitta, Keiji Kadota, Kazufumi Nomura, Tetsuo Era, Satoru Asai

    Assurance of the integrity of every weld joint is highly desirable, and defect detection methods that can be applied to welds at high temperatures immediately after welding are required. The laser ultrasonic (LU) method, which generates ultrasonic waves in the target via pulsed laser irradiation, is a well-known technique for non-contact defect detection during welding. Ultrasonic waves excited in ablation mode exhibit large amplitudes and predominantly surface-normal propagation, which has driven extensive research into their application for weld inspection. However, owing to the size and weight of conventional equipment, such systems have largely been limited to bench-top experimental setups. To address this, we developed an LU robotic system incorporating a compact, lightweight laser source and an improved signal-processing system. We conducted experiments to measure signals and to detect backside slits in flat plates and blowholes in lap-fillet welds. Additionally, a method to improve the sensitivity of laser interferometers was investigated and demonstrated on smut-covered areas near weld beads.

  • Open Access

    Study on Detecting Method of Internal Defects by Laser Ultrasonics in Lap Joint Welding of Galvanized Steel Sheet and Finite Element Analysis of Its Detectability

    by Norimitsu Okuyama, Kazufumi Nomura, Tomokazu Sano, Keiji Kadota, Seiya Nitta, Tetsuo Era, Satoru Asai

    Blowholes caused by vaporization of the galvanized layer are a problem with galvanized steel sheets, which use lap joint welding. The laser ultrasonic method is the possible solution to realize the desirable 100% inspection instead of the conventional sampling inspection. We have previously proposed a method to detect blowholes by capturing the reduction in ultrasonic intensity when it passes through internal defects through signal processing. However, there was a problem that the detection indicator devised varied. In this study, we investigated the causes and trends of detectability using finite element analysis. To efficiently calculate the results obtained by scanning measurement, we proposed and established a method to reproduce the results by taking the results from static measurements, which were shifted in the direction of the weld line little by little. As a result, it was found that one of the reasons for the detection indicator variation with scanning by the lasers is the three-dimensional positional relationship between the blowhole and the scanning measurement line. In addition, it was possible to propose the performance required for the ultrasonic generation laser such as the traveling speed and the repetition frequency by back-calculating the spatial resolution from the rate of detection needed.