Fatma Sena Öztürk
Research Subjects
Research Interests
Fatma Sena Öztürk has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Abdullah Karaköse
Department of Motor Vehicles and Transportation Technologies Hilal Machine Inc 19030 Çorum Turkiye
1 shared publication - Eray Çaşin
Nevtec Ar-Ge, Tasarım Lojistik A.Ş.., Çorum, Türkiye
1 shared publication - Furkan Akbulut
Hitit Üniversitesi , Department of Motor Vehicles and Transportation Technology, Çorum, Türkiye
1 shared publication - Halil Kılıç
Department of Machine, Technical Sciences Vocational School Kırklareli University Kırklareli Turkey
1 shared publication - İbRahim Mutlu
Faculty of Technology, Afyon Kocatepe University, Afyonkarahisar, Türkiye
1 shared publication - Mustafa Seyrek
Vocational School of Technical Sciences, Hitit University, Corum 19169, Turkey
1 shared publication
Latest Publications
- Open Access
- 31 December 2023
- Published by International Journal of Automotive Science and Technology in International Journal of Automotive Science And Technology
- Vol. 7 (4) , 309-315
Investigation of Tribological Properties of Brake Friction Materials Developed from Industrial Waste Products
Various international initiatives on environmental issues and the need to protect the environment are promoting the use of industrial waste in a variety of applications, including automotive brake pads. These studies show that the reuse of industrial waste can help to reduce the environmental impact. The development of environmentally friendly and cost-effective composites for use in a variety of engineering applications is the need of the century. The use of industrial waste in composite production is a possible solution for both problems. In this study, the potential use of talc, quartz and ceramic waste FFC fracture as a friction modifier in brake friction materials and its performance properties in accordance with industry requirements were investigated. The tribological, physical and mechanical properties of the brake pads were measured, and the friction surface morphology was investigated by scanning electron microscopy. According to the results obtained, the highest specific wear rate was observed in the FM3 sample. The FM2 sample with the highest hardness and average friction coefficient showed the lowest wear. FM4, FM5 and FM6 samples with high talc and quartz content exhibited low coefficient of friction characteristics compared to other samples.
- 31 December 2023
- Published by International Journal of Automotive Science and Technology in International Journal of Automotive Science And Technology
- Vol. 7 (4) , 309-315
Open AccessInvestigation of Tribological Properties of Brake Friction Materials Developed from Industrial Waste Products
Various international initiatives on environmental issues and the need to protect the environment are promoting the use of industrial waste in a variety of applications, including automotive brake pads. These studies show that the reuse of industrial waste can help to reduce the environmental impact. The development of environmentally friendly and cost-effective composites for use in a variety of engineering applications is the need of the century. The use of industrial waste in composite production is a possible solution for both problems. In this study, the potential use of talc, quartz and ceramic waste FFC fracture as a friction modifier in brake friction materials and its performance properties in accordance with industry requirements were investigated. The tribological, physical and mechanical properties of the brake pads were measured, and the friction surface morphology was investigated by scanning electron microscopy. According to the results obtained, the highest specific wear rate was observed in the FM3 sample. The FM2 sample with the highest hardness and average friction coefficient showed the lowest wear. FM4, FM5 and FM6 samples with high talc and quartz content exhibited low coefficient of friction characteristics compared to other samples.