ANAnam Naz

Anam Naz

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Anam Naz has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • EFFECT OF FILM THICKNESS AND INFUSION PRESSURE ON INTERLAMINAR TOUGHENING OF CFRP LAMINATES TOUGHENED WITH MELT-INFUSED PA-6 FILM INTERLEAVES

    by Daniel Kipkirui Too, Anam Naz, Kyomoon Lee, Amutheesan Manikkavel, Yun-Hae Kim

    Carbon fiber reinforced polymers (CFRPs) are extensively employed in high-performance applications because of their exceptional strength-to-weight ratio. However, their maximum potential is restricted by their susceptibility to delamination, a critical issue. This study examines the efficacy of melt-infused Polyamide-6 (PA-6) film interleaves in improving the interlaminar fracture toughness of CFRPs. This study observed substantial enhancements in the durability of both Modes I and II fractures by methodically adjusting the infusion pressure and film thickness. For the S_1_60 configuration, [ ] increased by 568%, reaching 2573.2[ ]J/m2, while [ ] improved by 596%. For the S_1_60 configuration, [ ] increased by 352% to 1278.1[ ]J/m2, while [ ] improved by 363%. Detailed fractographic studies were conducted to analyze the underlying mechanisms, which include plastic deformation, fiber bridging, and fiber pull-out. These results offer valuable insights into the optimization of melt-infusion interleaving to customize the mechanical performance of CFRPs. By controlling the infusion pressure and film thickness, it is possible to develop composite materials that are more resistant to damage and more durable, thereby broadening their potential for use in critical engineering applications in aeronautical, automotive and marine engineering.


  • Flexural behavior of carbon/epoxy nanocomposite pipes with interleaved structure

    by Ye-Rim Park, Sanjay Kumar, Anam Naz, Yun-Hae Kim

    The filament winding process used in this study mainly produces pipe-shaped structures. In this structure, there is an intersection of fiber bundles, which makes the fiber bundles overlapping with other fiber bundles wavy. In that area, the concentration of stress and deformation appears. Therefore, halloysite nanotubes were applied among nanoparticles to supplement this through the study. In the utilization of nanoparticles, the control of agglomeration phenomena and the ease of dispersion are pivotal factors. In consideration of this, general halloysite nanotubes were heat-treated at 1000∘C to produce amorphous halloysite nanotubes to reduce the surface energy of particles, making it easier to control agglomeration phenomena and the ease of dispersion, and it was intended to supplement and improve mechanical properties in local applications through interleaved structure design. In this study, each stacked structure was analyzed through an axial pipe bending test. The fracture pattern for each structure was observed through an optical microscope. As a result, A3 reinforced with A-HNT for all layers had the highest load value (4207N), and the flexural strength was also measured high accordingly. It shows a small degree of fracture compared to other structures. Following that, E2A1, whose innermost layer was reinforced with A-HNT, had the second-highest load value (3864N), and accordingly, the second-highest flexural strength was measured. The observed surface of the pipe was the outermost layer (E), and it was observed that the degree of fracture was more advanced than that of A3.