Celia Castro
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Celia Castro has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- François Vurpillot
Univ Rouen Normandie, INSA Rouen Normandie, CNRS, Normandie Univ, GPM UMR 6634 , Rouen F-76000
4 shared publications Antoine Normand
GPM UMR 6634, CNRS, Université de Rouen Normandie, INSA Rouen Normandie, Normandie Université , F-76000 Rouen
2 shared publicationsGerald Da Costa
Univ Rouen Normandie, INSA Rouen Normandie, CNRS, Normandie Univ, GPM UMR 6634 , Rouen F-76000
2 shared publications- Juan Macchi
Univ Rouen Normandie, INSA Rouen Normandie, CNRS, Normandie Univ, Rouen, France
2 shared publications - Mohammed Ilhami
Univ Rouen Normandie, INSA Rouen Normandie, CNRS, Normandie Univ, GPM UMR 6634 , Rouen F-76000
2 shared publications Williams Lefebvre
Univ Rouen Normandie, INSA Rouen Normandie, CNRS, Normandie Univ, GPM UMR 6634 , Rouen F-76000
2 shared publications
Latest Publications
- 1 July 2026
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 32 (4)
From Stable Expansion to Catastrophic Failure Under Extreme Hydrogen Loading in Ni and Ti Atom Probe Tomography Specimens
To better understand hydrogen (H) trapping kinetics at the nanoscale, we recently introduced an approach consisting of in situ H implantation inside an atom probe analysis chamber operated at cryogenic temperature. This method enables implantation of H2+ ions with energies up to 1 keV, allowing H to penetrate approximately 10 nm beneath the surface of an atom probe tomography (APT) specimen. Here, we investigate the expansion of APT samples following H implantation in two metallic systems: nickel (Ni) and titanium (Ti). In Ni, a significant expansion of ≈10–15% was observed by comparing transmission electron microscopy images acquired before and after implantation. In Ti, expansion could not be directly imaged due to specimen degradation caused by room-temperature transfer; however, APT analyses revealed a substantial shift in evaporation voltage (10–40%), consistent with pronounced Ti tip volume expansion.
- 1 July 2026
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 32 (4)
From Stable Expansion to Catastrophic Failure Under Extreme Hydrogen Loading in Ni and Ti Atom Probe Tomography Specimens
To better understand hydrogen (H) trapping kinetics at the nanoscale, we recently introduced an approach consisting of in situ H implantation inside an atom probe analysis chamber operated at cryogenic temperature. This method enables implantation of H2+ ions with energies up to 1 keV, allowing H to penetrate approximately 10 nm beneath the surface of an atom probe tomography (APT) specimen. Here, we investigate the expansion of APT samples following H implantation in two metallic systems: nickel (Ni) and titanium (Ti). In Ni, a significant expansion of ≈10–15% was observed by comparing transmission electron microscopy images acquired before and after implantation. In Ti, expansion could not be directly imaged due to specimen degradation caused by room-temperature transfer; however, APT analyses revealed a substantial shift in evaporation voltage (10–40%), consistent with pronounced Ti tip volume expansion.
- 1 July 2026
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 32 (4)
Using Detection Efficiency as an Indicator of Losses During Atom Probe Tomography Analysis of Oxygen-Rich Materials
Atom probe tomography (APT) enables atomic-scale compositional analysis in a wide range of materials; however, quantification in oxygen-rich materials remains challenging due to apparent oxygen losses during analysis. We present here a correlative method, combining transmission electron microscopy and analytical or numerical modeling, to estimate the APT analyzed volume and detection efficiency. Applied to CePO4 samples, the approach revealed that increasing laser pulse energy reduces detection efficiency, likely through enhanced neutral desorption. Analysis on pure aluminum confirmed the robustness of the method, while highlighting limitations in accurately determining the evaporated depth and compositional uncertainties. The results demonstrate consistent qualitative trends with known oxygen loss mechanisms in synthetic monazites. This work provides a foundation for developing a method to better understand the loss of neutral species during field evaporation and consequently the compositional biases observed in APT analyses. By linking morphological measurements with modeling of the analyzed volume, it opens the way to a more accurate interpretation of detection efficiency variations and elemental deficiencies in oxygen-rich materials.
- 1 July 2026
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 32 (4)
Using Detection Efficiency as an Indicator of Losses During Atom Probe Tomography Analysis of Oxygen-Rich Materials
Atom probe tomography (APT) enables atomic-scale compositional analysis in a wide range of materials; however, quantification in oxygen-rich materials remains challenging due to apparent oxygen losses during analysis. We present here a correlative method, combining transmission electron microscopy and analytical or numerical modeling, to estimate the APT analyzed volume and detection efficiency. Applied to CePO4 samples, the approach revealed that increasing laser pulse energy reduces detection efficiency, likely through enhanced neutral desorption. Analysis on pure aluminum confirmed the robustness of the method, while highlighting limitations in accurately determining the evaporated depth and compositional uncertainties. The results demonstrate consistent qualitative trends with known oxygen loss mechanisms in synthetic monazites. This work provides a foundation for developing a method to better understand the loss of neutral species during field evaporation and consequently the compositional biases observed in APT analyses. By linking morphological measurements with modeling of the analyzed volume, it opens the way to a more accurate interpretation of detection efficiency variations and elemental deficiencies in oxygen-rich materials.
- 1 July 2026
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 32 (4)
Determination of Electric Field in the Vicinity of Polarized Atom Probe Tomography Specimens Using Scanning Transmission Electron Microscopy
Determination of electrostatic field distribution at the nanometer scale at the vicinity of a polarized specimen is of great interest for solving the reconstruction issue in atom probe tomography. In this work, we present a method based on the Rutherford scattering theory to quantify the electric field maps obtained by scanning an electron beam across a needle-like specimen submitted to a high voltage in a transmission electron microscope. After a validation of the geometrical model on simulated datasets, electron beam-deflection maps were acquired in scanning mode using a holder developed to perform atom probe tomography experiments in transmission electron microscopes. The experimental results show that the determined electric field asymmetry is consistent with the local crystallographic configuration at the vicinity of a pure tungsten specimen. The methodology presented, which does not depend on the thickness of the sample, is anticipated to serve as an additional input for present and future atom probe reconstruction methods.
- 1 July 2026
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 32 (4)
Determination of Electric Field in the Vicinity of Polarized Atom Probe Tomography Specimens Using Scanning Transmission Electron Microscopy
Determination of electrostatic field distribution at the nanometer scale at the vicinity of a polarized specimen is of great interest for solving the reconstruction issue in atom probe tomography. In this work, we present a method based on the Rutherford scattering theory to quantify the electric field maps obtained by scanning an electron beam across a needle-like specimen submitted to a high voltage in a transmission electron microscope. After a validation of the geometrical model on simulated datasets, electron beam-deflection maps were acquired in scanning mode using a holder developed to perform atom probe tomography experiments in transmission electron microscopes. The experimental results show that the determined electric field asymmetry is consistent with the local crystallographic configuration at the vicinity of a pure tungsten specimen. The methodology presented, which does not depend on the thickness of the sample, is anticipated to serve as an additional input for present and future atom probe reconstruction methods.
- Open Access
- 14 November 2024
- Published by Springer Nature in Nature Communications
- Vol. 15 (1) , 1-7
Bringing atom probe tomography to transmission electron microscopes
For the purpose of enhancing the structural insights within the three-dimensional composition fields revealed by atom probe tomography, correlative microscopy approaches, combining (scanning) transmission electron microscopy with atom probe tomography, have emerged and demonstrated their relevance. To push the boundaries further and facilitate a more comprehensive analysis of nanoscale matter by coupling numerous two- or three-dimensional datasets, there is an increasing interest in combining transmission electron microscopy and atom probe tomography into a unified instrument. This study presents the tangible outcome of an instrumental endeavour aimed at integrating atom probe tomography into a commercial transmission electron microscope. The resulting instrument demonstrates the feasibility of combining in situ 3D reconstructions of composition fields with the detailed structural analysis afforded by transmission electron microscopy. This study shows a promising approach for converging these two important nanoscale microscopy techniques.
- 14 November 2024
- Published by Springer Nature in Nature Communications
- Vol. 15 (1) , 1-7
Open AccessBringing atom probe tomography to transmission electron microscopes
For the purpose of enhancing the structural insights within the three-dimensional composition fields revealed by atom probe tomography, correlative microscopy approaches, combining (scanning) transmission electron microscopy with atom probe tomography, have emerged and demonstrated their relevance. To push the boundaries further and facilitate a more comprehensive analysis of nanoscale matter by coupling numerous two- or three-dimensional datasets, there is an increasing interest in combining transmission electron microscopy and atom probe tomography into a unified instrument. This study presents the tangible outcome of an instrumental endeavour aimed at integrating atom probe tomography into a commercial transmission electron microscope. The resulting instrument demonstrates the feasibility of combining in situ 3D reconstructions of composition fields with the detailed structural analysis afforded by transmission electron microscopy. This study shows a promising approach for converging these two important nanoscale microscopy techniques.
- Open Access
- 6 July 2024
- Published by Elsevier in Scripta Materialia
- Vol. 252
Microstructural design by combining nanograins and spinodal decomposition in a Fe-Cr alloy
- 6 July 2024
- Published by Elsevier in Scripta Materialia
- Vol. 252
Open AccessMicrostructural design by combining nanograins and spinodal decomposition in a Fe-Cr alloy
- 1 April 2022
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 899, 163273
Investigation of Sn-containing precursors for in-plane GeSn nanowire growth
- 1 April 2022
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 899, 163273
Investigation of Sn-containing precursors for in-plane GeSn nanowire growth