KKKirill Kislov

Kirill Kislov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Kirill Kislov has a total of 2 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Information properties of vibroacoustic emission in diagnostic systems for cutting tool wear

    by Vilor Zakovorotny, Valery Gvindjiliya, Kirill Kislov

    Introduction. This paper is devoted to the development of a methodology for diagnosing cutting tool wear based on the analysis of vibroacoustic emission signals. Two tasks are addressed. Firstly, the information feature space related to wear is constructed. Secondly, within this space, decision rules are defined that allow division into separate clusters according to wear levels. Since the construction of the information feature space (IFS) methods is of primary importance in these procedures, the purpose of this work is to determine the regularities of changes in the frequency characteristics of the dynamic cutting system caused by wear development and to construct, on this basis, a rational information space for diagnosing tool wear. Method and methodology. The study is based on mathematical modeling results of a perturbed dynamic cutting system to determine the information feature space representing tool wear. Methods for determining the parameters of information signal parameters (ISPs) are proposed, which provide high sensitivity to wear changes. All ISP parameters should be dimensionless and zeroed at zero wear. They must satisfy additional requirements, including noise immunity conditions. Results and discussion. The paper presents results of constructing ISP parameters for vibroacoustic emission analysis in two frequency ranges. In the low-frequency range, limited by the first natural frequencies of interacting subsystems (up to 1.0–1.5 kHz), vibration response parameters (VRP) are determined based on vibration sequences obtained analytically under power perturbations modeled as “white” noise. In the high-frequency range (above 2.0 kHz), information models based on random pulse sequences are proposed. It is shown that the applicability of a particular information feature depends on the conditions. Thus, the developed methodology, mathematical simulation, and digital and field experiments enabled the formation of a rational information space for wear diagnostics, in which known recognition methods can be used to construct decision rules for classifying information according to wear levels.


  • Information properties of frequency characteristics of dynamic cutting systems in the diagnosis of tool wear

    by Vilor Zakovorotny, Valery Gvindjiliya, Kirill Kislov

    Introduction. One of the directions for increasing the efficiency of cutting is related to the creation of tool wear diagnostic systems. Algorithms and devices have been developed that evaluate wear based on analysis of the vibroacoustic emission signal. These algorithms, as a rule, do not reveal the nature of its formation and the reasons for the change as wear develops. Subject. The paper is devoted to the analysis of the reasons for changes in vibration properties with the development of tool wear. The aim of the work is to study the changes in the frequency characteristics of a dynamic cutting system caused by the development of wear, and to build diagnostic information models on this basis, as well as its use in industry. Method and methodology. The results of mathematical simulation of a perturbed dynamic cutting system are presented, in which the observed vibration sequences are a consequence of disturbances transformed by a dynamic system, the parameters of which depend on wear. Two frequency ranges are considered. Results and discussions. The first range includes frequencies that lie within the bandwidth of the instrument subsystem. The second is outside of it. In the first frequency range, it has been analytically and experimentally proven that the development of wear leads to fundamental changes in the frequency properties of the cutting system as a converter of disturbances into tool vibrations. There is a shift in the natural frequencies of the oscillatory circuits formed by the cutting system, a decrease in its quality factor, and as wear develops, some identified features of the vibration spectra appear, including the ratio of the low-frequency and high-frequency parts of the spectrum, etc. In the second frequency range, a model of force emission in the form of a random pulse sequence is considered and wear is displayed in it. The results of studying the coherence function between the forces acting on the tool and vibrational displacement are presented. Information models of wear are proposed, an example of an information model of wear and the results of its use in industry are given.