A. Zh. Suigenbayeva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
A. Zh. Suigenbayeva has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Saule A. Sakibayeva
M. Auezov South Kazakhstan University
3 shared publications - A. O. Orazymbetova
M. Auezov South Kazakhstan University
2 shared publications - A. S. Sidikov
Branch of the Russian State University of oil and gas named after I. M. Gubkin
2 shared publications - Гузалия Фаритовна Сагитова
M. Auezov South Kazakhstan University
2 shared publications - A. B. Issa
M. Auezov South Kazakhstan University
1 shared publication G. A. Kambarova
M. Auezov South Kazakhstan State University, Shymkent, Kazakhstan
1 shared publication
Latest Publications
- Open Access
- 25 May 2026
- Published by Shakarim University in Bulletin of Shakarim University. Technical Sciences
- Vol. 1 (1(21)) , 776-788
APPLICATION OF ZEOLITES FROM THE CHANKANAI DEPOSIT IN RUBBER PRODUCTION
This article presents the results of a study of natural and activated zeolite from the Chankanai deposit as a filler for rubber compounds. The results of extensive scientific research aimed at analyzing the effect of mineral additives on the properties of elastomers confirm the high potential and future prospects for this area of research. The introduction of mineral additives into the rubber matrix under standard conditions improves its performance characteristics, reducing the cost of the material, improving its elastic and strength properties, and optimizing its processing properties. The goal of this work is to replace expensive fillers with more affordable alternatives while maintaining all the required properties of rubber compounds. Maintaining strength, elasticity, wear resistance, and other key performance indicators is a top priority when searching for and implementing replacements, allowing for cost reductions without compromising product quality. Therefore, the proposed ingredients must provide the same or improved properties to ensure the finished product meets standards and operating requirements. The study focuses on zeolites from the Chankanai deposit and rubbers used to produce dielectric mats, which must possess high electrical insulating properties and mechanical strength. Energy-dispersive spectroscopy was used to obtain data on the elemental composition of the zeolite powder samples studied. This information is critical, as it allows us to assess the effectiveness of zeolites as fillers in rubber production. Experimental studies have shown that vulcanizates obtained by partially replacing 40 parts by weight of white carbon with activated zeolite from the Chankanai deposit exhibit satisfactory physical and mechanical properties. This opens up new prospects for the use of natural and activated zeolites in the rubber industry, contributing to both cost reduction and improved vulcanizate quality.
- 25 May 2026
- Published by Shakarim University in Bulletin of Shakarim University. Technical Sciences
- Vol. 1 (1(21)) , 776-788
Open AccessAPPLICATION OF ZEOLITES FROM THE CHANKANAI DEPOSIT IN RUBBER PRODUCTION
This article presents the results of a study of natural and activated zeolite from the Chankanai deposit as a filler for rubber compounds. The results of extensive scientific research aimed at analyzing the effect of mineral additives on the properties of elastomers confirm the high potential and future prospects for this area of research. The introduction of mineral additives into the rubber matrix under standard conditions improves its performance characteristics, reducing the cost of the material, improving its elastic and strength properties, and optimizing its processing properties. The goal of this work is to replace expensive fillers with more affordable alternatives while maintaining all the required properties of rubber compounds. Maintaining strength, elasticity, wear resistance, and other key performance indicators is a top priority when searching for and implementing replacements, allowing for cost reductions without compromising product quality. Therefore, the proposed ingredients must provide the same or improved properties to ensure the finished product meets standards and operating requirements. The study focuses on zeolites from the Chankanai deposit and rubbers used to produce dielectric mats, which must possess high electrical insulating properties and mechanical strength. Energy-dispersive spectroscopy was used to obtain data on the elemental composition of the zeolite powder samples studied. This information is critical, as it allows us to assess the effectiveness of zeolites as fillers in rubber production. Experimental studies have shown that vulcanizates obtained by partially replacing 40 parts by weight of white carbon with activated zeolite from the Chankanai deposit exhibit satisfactory physical and mechanical properties. This opens up new prospects for the use of natural and activated zeolites in the rubber industry, contributing to both cost reduction and improved vulcanizate quality.
- Open Access
- 8 July 2025
- Published by Shakarim University in Bulletin of Shakarim University. Technical Sciences
- No. 2(18),p. 459-469
PHYSICAL AND CHEMICAL MODIFICATION OF NATURAL MINERAL OF CHANKANAY DEPOSIT
The development of domestic rubber adhesion promoters based on mineral raw materials is a pressing task. The formation of a bond with high and stable strength in the elastomer-metal system always remains the focus of attention when creating new formulations and new ingredients. The introduction of nickel salts into the rubber mixture significantly increases the stability of the bond strength in the rubber-metal cord system under the influence of moisture, elevated temperature and sodium chloride, since in their presence the formation of weak boundary layers of ZnO/Zn(OH)2 is delayed.Interest in zeolites as fillers and adhesion promoters is caused by their ability not only to reduce costs, but also to impart qualitatively new useful properties to materials and products, and the ability to set or adjust these properties. The properties of any mineral raw material can be adjusted through modification. Thermal and chemical treatment of zeolites with solutions of acids, alkalis and salts allows modifying zeolites and purposefully changing their properties in relation to solving a particular problem. In this work, physical and chemical modification of zeolite from the Chankanai deposit was carried out. The cation exchange properties of natural zeolite Chankanai were studied. The ion exchange of the initial calcium cation was carried out with nickel cationite. The results of experimental and physicochemical analysis methods confirm the penetration of nickel ions onto the surface of the zeolite, which has a microhard structure. It was found that the degree of exchange of the Ca cation contained in the initial zeolite for Ni cations is insignificant.
- 8 July 2025
- Published by Shakarim University in Bulletin of Shakarim University. Technical Sciences
- No. 2(18),p. 459-469
Open AccessPHYSICAL AND CHEMICAL MODIFICATION OF NATURAL MINERAL OF CHANKANAY DEPOSIT
The development of domestic rubber adhesion promoters based on mineral raw materials is a pressing task. The formation of a bond with high and stable strength in the elastomer-metal system always remains the focus of attention when creating new formulations and new ingredients. The introduction of nickel salts into the rubber mixture significantly increases the stability of the bond strength in the rubber-metal cord system under the influence of moisture, elevated temperature and sodium chloride, since in their presence the formation of weak boundary layers of ZnO/Zn(OH)2 is delayed.Interest in zeolites as fillers and adhesion promoters is caused by their ability not only to reduce costs, but also to impart qualitatively new useful properties to materials and products, and the ability to set or adjust these properties. The properties of any mineral raw material can be adjusted through modification. Thermal and chemical treatment of zeolites with solutions of acids, alkalis and salts allows modifying zeolites and purposefully changing their properties in relation to solving a particular problem. In this work, physical and chemical modification of zeolite from the Chankanai deposit was carried out. The cation exchange properties of natural zeolite Chankanai were studied. The ion exchange of the initial calcium cation was carried out with nickel cationite. The results of experimental and physicochemical analysis methods confirm the penetration of nickel ions onto the surface of the zeolite, which has a microhard structure. It was found that the degree of exchange of the Ca cation contained in the initial zeolite for Ni cations is insignificant.
- 30 August 2024
- Published by Oil Research and Engineering Center of the National Engineering Academy of the Republic of Kazakhstan in Neft i Gaz
- No. 4,p. 153-162
The effect of a polyacrylamide-based composite polymer on oil displacement
Ducts. The produced oil is highly paraffinic, highly emulsified and low-sulfur. In this regard, to increase oil recovery from oil and gas fields, it is necessary to select available raw materials, as well as new technologies based on the use of effective modified polymer reagents. А technology has been developed for the production of new composite surfactant polymers of the MPAA series based on polyacrylamide by hydrolysis with sodium hydroxide followed by modification in the presence of formaldehyde and fatty acids of gossypol resin, at a temperature of 353-363 K, time 4.0-4.5 hours, the ratio of reagents is 1:0.8, resistant to aggressive environments and high temperatures. As a result of the modification, the ability to regulate the surface-active properties of composite polymers in the presence of fatty acids of gossypol resin has been achieved. The surface tension of the modified PAA was σ=43.6 N/m. Mathematical optimization of the main parameters of the process of obtaining composite surfactant polymers based on hydrolyzed and modified PAA. Mathematical optimization of the main parameters of the process of obtaining composite surfactant polymers based on hydrolyzed and modified polyacrylamide was carried out.
- 30 August 2024
- Published by Oil Research and Engineering Center of the National Engineering Academy of the Republic of Kazakhstan in Neft i Gaz
- No. 4,p. 153-162
The effect of a polyacrylamide-based composite polymer on oil displacement
Ducts. The produced oil is highly paraffinic, highly emulsified and low-sulfur. In this regard, to increase oil recovery from oil and gas fields, it is necessary to select available raw materials, as well as new technologies based on the use of effective modified polymer reagents. А technology has been developed for the production of new composite surfactant polymers of the MPAA series based on polyacrylamide by hydrolysis with sodium hydroxide followed by modification in the presence of formaldehyde and fatty acids of gossypol resin, at a temperature of 353-363 K, time 4.0-4.5 hours, the ratio of reagents is 1:0.8, resistant to aggressive environments and high temperatures. As a result of the modification, the ability to regulate the surface-active properties of composite polymers in the presence of fatty acids of gossypol resin has been achieved. The surface tension of the modified PAA was σ=43.6 N/m. Mathematical optimization of the main parameters of the process of obtaining composite surfactant polymers based on hydrolyzed and modified PAA. Mathematical optimization of the main parameters of the process of obtaining composite surfactant polymers based on hydrolyzed and modified polyacrylamide was carried out.
- Open Access
- 25 June 2018
- Published by Oriental Scientific Publishing Company in Oriental Journal of Chemistry
- Vol. 34 (3) , 1317-1322
Method for Introducing Non-metallic Particles into Composite Coatings
Oriental Journal of Chemistry is a peer reviewed quarterly research journal of pure and applied chemistry. It publishes standard research papers in almost all thrust areas of current chemistry of academic and commercial importance. It provides a platform for rapid publication of quality research papers, reviews and chemistry letters. Oriental Journal of Chemistry is abstracted and indexed in almost all reputed National and International agencies.
- 25 June 2018
- Published by Oriental Scientific Publishing Company in Oriental Journal of Chemistry
- Vol. 34 (3) , 1317-1322
Open AccessMethod for Introducing Non-metallic Particles into Composite Coatings
Oriental Journal of Chemistry is a peer reviewed quarterly research journal of pure and applied chemistry. It publishes standard research papers in almost all thrust areas of current chemistry of academic and commercial importance. It provides a platform for rapid publication of quality research papers, reviews and chemistry letters. Oriental Journal of Chemistry is abstracted and indexed in almost all reputed National and International agencies.