A. O. Orazymbetova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
A. O. Orazymbetova has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- A. S. Sidikov
Branch of the Russian State University of oil and gas named after I. M. Gubkin
3 shared publications - Saule A. Sakibayeva
M. Auezov South Kazakhstan University
3 shared publications - Гузалия Фаритовна Сагитова
M. Auezov South Kazakhstan University
3 shared publications - A. Zh. Suigenbayeva
M. Auezov South Kazakhstan University
2 shared publications - A. B. Issa
M. Auezov South Kazakhstan University
1 shared publication А. Ж. Суйгенбаева
Южно-Казахстанский университет им. М.Ауэзова
1 shared publication
Latest Publications
- Open Access
- 25 May 2026
- Published by Shakarim University in Bulletin of Shakarim University. Technical Sciences
- Vol. 1 (1(21)) , 776-788
APPLICATION OF ZEOLITES FROM THE CHANKANAI DEPOSIT IN RUBBER PRODUCTION
This article presents the results of a study of natural and activated zeolite from the Chankanai deposit as a filler for rubber compounds. The results of extensive scientific research aimed at analyzing the effect of mineral additives on the properties of elastomers confirm the high potential and future prospects for this area of research. The introduction of mineral additives into the rubber matrix under standard conditions improves its performance characteristics, reducing the cost of the material, improving its elastic and strength properties, and optimizing its processing properties. The goal of this work is to replace expensive fillers with more affordable alternatives while maintaining all the required properties of rubber compounds. Maintaining strength, elasticity, wear resistance, and other key performance indicators is a top priority when searching for and implementing replacements, allowing for cost reductions without compromising product quality. Therefore, the proposed ingredients must provide the same or improved properties to ensure the finished product meets standards and operating requirements. The study focuses on zeolites from the Chankanai deposit and rubbers used to produce dielectric mats, which must possess high electrical insulating properties and mechanical strength. Energy-dispersive spectroscopy was used to obtain data on the elemental composition of the zeolite powder samples studied. This information is critical, as it allows us to assess the effectiveness of zeolites as fillers in rubber production. Experimental studies have shown that vulcanizates obtained by partially replacing 40 parts by weight of white carbon with activated zeolite from the Chankanai deposit exhibit satisfactory physical and mechanical properties. This opens up new prospects for the use of natural and activated zeolites in the rubber industry, contributing to both cost reduction and improved vulcanizate quality.
- 25 May 2026
- Published by Shakarim University in Bulletin of Shakarim University. Technical Sciences
- Vol. 1 (1(21)) , 776-788
Open AccessAPPLICATION OF ZEOLITES FROM THE CHANKANAI DEPOSIT IN RUBBER PRODUCTION
This article presents the results of a study of natural and activated zeolite from the Chankanai deposit as a filler for rubber compounds. The results of extensive scientific research aimed at analyzing the effect of mineral additives on the properties of elastomers confirm the high potential and future prospects for this area of research. The introduction of mineral additives into the rubber matrix under standard conditions improves its performance characteristics, reducing the cost of the material, improving its elastic and strength properties, and optimizing its processing properties. The goal of this work is to replace expensive fillers with more affordable alternatives while maintaining all the required properties of rubber compounds. Maintaining strength, elasticity, wear resistance, and other key performance indicators is a top priority when searching for and implementing replacements, allowing for cost reductions without compromising product quality. Therefore, the proposed ingredients must provide the same or improved properties to ensure the finished product meets standards and operating requirements. The study focuses on zeolites from the Chankanai deposit and rubbers used to produce dielectric mats, which must possess high electrical insulating properties and mechanical strength. Energy-dispersive spectroscopy was used to obtain data on the elemental composition of the zeolite powder samples studied. This information is critical, as it allows us to assess the effectiveness of zeolites as fillers in rubber production. Experimental studies have shown that vulcanizates obtained by partially replacing 40 parts by weight of white carbon with activated zeolite from the Chankanai deposit exhibit satisfactory physical and mechanical properties. This opens up new prospects for the use of natural and activated zeolites in the rubber industry, contributing to both cost reduction and improved vulcanizate quality.
- Open Access
- 8 July 2025
- Published by Shakarim University in Bulletin of Shakarim University. Technical Sciences
- No. 2(18),p. 459-469
PHYSICAL AND CHEMICAL MODIFICATION OF NATURAL MINERAL OF CHANKANAY DEPOSIT
The development of domestic rubber adhesion promoters based on mineral raw materials is a pressing task. The formation of a bond with high and stable strength in the elastomer-metal system always remains the focus of attention when creating new formulations and new ingredients. The introduction of nickel salts into the rubber mixture significantly increases the stability of the bond strength in the rubber-metal cord system under the influence of moisture, elevated temperature and sodium chloride, since in their presence the formation of weak boundary layers of ZnO/Zn(OH)2 is delayed.Interest in zeolites as fillers and adhesion promoters is caused by their ability not only to reduce costs, but also to impart qualitatively new useful properties to materials and products, and the ability to set or adjust these properties. The properties of any mineral raw material can be adjusted through modification. Thermal and chemical treatment of zeolites with solutions of acids, alkalis and salts allows modifying zeolites and purposefully changing their properties in relation to solving a particular problem. In this work, physical and chemical modification of zeolite from the Chankanai deposit was carried out. The cation exchange properties of natural zeolite Chankanai were studied. The ion exchange of the initial calcium cation was carried out with nickel cationite. The results of experimental and physicochemical analysis methods confirm the penetration of nickel ions onto the surface of the zeolite, which has a microhard structure. It was found that the degree of exchange of the Ca cation contained in the initial zeolite for Ni cations is insignificant.
- 8 July 2025
- Published by Shakarim University in Bulletin of Shakarim University. Technical Sciences
- No. 2(18),p. 459-469
Open AccessPHYSICAL AND CHEMICAL MODIFICATION OF NATURAL MINERAL OF CHANKANAY DEPOSIT
The development of domestic rubber adhesion promoters based on mineral raw materials is a pressing task. The formation of a bond with high and stable strength in the elastomer-metal system always remains the focus of attention when creating new formulations and new ingredients. The introduction of nickel salts into the rubber mixture significantly increases the stability of the bond strength in the rubber-metal cord system under the influence of moisture, elevated temperature and sodium chloride, since in their presence the formation of weak boundary layers of ZnO/Zn(OH)2 is delayed.Interest in zeolites as fillers and adhesion promoters is caused by their ability not only to reduce costs, but also to impart qualitatively new useful properties to materials and products, and the ability to set or adjust these properties. The properties of any mineral raw material can be adjusted through modification. Thermal and chemical treatment of zeolites with solutions of acids, alkalis and salts allows modifying zeolites and purposefully changing their properties in relation to solving a particular problem. In this work, physical and chemical modification of zeolite from the Chankanai deposit was carried out. The cation exchange properties of natural zeolite Chankanai were studied. The ion exchange of the initial calcium cation was carried out with nickel cationite. The results of experimental and physicochemical analysis methods confirm the penetration of nickel ions onto the surface of the zeolite, which has a microhard structure. It was found that the degree of exchange of the Ca cation contained in the initial zeolite for Ni cations is insignificant.
- Open Access
- 29 March 2025
- Published by Shakarim University in Bulletin of Shakarim University. Technical Sciences
- No. 1(17),p. 376-397
THE POSSIBILITIES OF USING ZEOLITES IN VARIOUS FIELDS (REVIEW)
Zeolites, due to their unique properties, have a wide range of applications. Fillers are one of the most important components of rubber compound formulations, allowing effective impact on the complex of chemical, technological, physical-mechanical and economic indicators of rubbers. Zeolite occupies a special place in this class of fillers. The purpose of this review is to analyze existing works on the study of the properties and application of zeolites for their further study as a promoting system. In recent years, active research has been carried out to create new types of promotional systems based on mineral raw materials. A characteristic feature of inorganic adhesion promoters is their ability to slowly release metal ions, which has a positive effect on the efficiency of fastening rubber to brass-plated metal during operation. This makes it possible to introduce metal salts in significant dosages without undesirable effects, especially mineral ones, which is caused mainly by the relative cheapness of the feedstock.In this aspect, zeolites have long attracted the attention of researchers as minerals with specific properties and structural features.Of all the more than 52 mineral species and varieties of zeolites known in nature, only a few meet the requirements for use for practical purposes, namely, they form large, almost monomineral concentrations and at the same time have the corresponding useful properties: high adsorption capacity, cation capacity, acid and heat resistance. Zeolites can be considered a multi-purpose raw material due to the diversity of material and chemical compositions, textural and structural characteristics, physical, mechanical and adsorption properties. And for the successful use of any mineral raw materials in various industries, a detailed study of their textural and structural characteristics is necessary, as well as a search for new ways to increase beneficial properties using modern technological methods and techniques.
- 29 March 2025
- Published by Shakarim University in Bulletin of Shakarim University. Technical Sciences
- No. 1(17),p. 376-397
Open AccessTHE POSSIBILITIES OF USING ZEOLITES IN VARIOUS FIELDS (REVIEW)
Zeolites, due to their unique properties, have a wide range of applications. Fillers are one of the most important components of rubber compound formulations, allowing effective impact on the complex of chemical, technological, physical-mechanical and economic indicators of rubbers. Zeolite occupies a special place in this class of fillers. The purpose of this review is to analyze existing works on the study of the properties and application of zeolites for their further study as a promoting system. In recent years, active research has been carried out to create new types of promotional systems based on mineral raw materials. A characteristic feature of inorganic adhesion promoters is their ability to slowly release metal ions, which has a positive effect on the efficiency of fastening rubber to brass-plated metal during operation. This makes it possible to introduce metal salts in significant dosages without undesirable effects, especially mineral ones, which is caused mainly by the relative cheapness of the feedstock.In this aspect, zeolites have long attracted the attention of researchers as minerals with specific properties and structural features.Of all the more than 52 mineral species and varieties of zeolites known in nature, only a few meet the requirements for use for practical purposes, namely, they form large, almost monomineral concentrations and at the same time have the corresponding useful properties: high adsorption capacity, cation capacity, acid and heat resistance. Zeolites can be considered a multi-purpose raw material due to the diversity of material and chemical compositions, textural and structural characteristics, physical, mechanical and adsorption properties. And for the successful use of any mineral raw materials in various industries, a detailed study of their textural and structural characteristics is necessary, as well as a search for new ways to increase beneficial properties using modern technological methods and techniques.