Cole D. Westrick
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Cole D. Westrick has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Alexander Spens
The Ohio State University Aerospace Research Center, Department of Mechanical and Aerospace Engineering 2300 W Case Road, Columbus, OH 43235
1 shared publication - Evan J. McFadden
The Ohio State University Aerospace Research Center, Department of Mechanical and Aerospace Engineering 2300 W Case Road, Columbus, OH 43235
1 shared publication - Jeffrey P. Bons
Aerospace Research Center, Department of Mechanical and Aerospace Engineering, The Ohio State University, Columbus, OH 43235
1 shared publication
Latest Publications
- 15 October 2024
- Published by Wiley in Journal of Turbomachinery
- Vol. 147 (3) , 1-32
A Simplified Injection Model for Variable Area Turbine Fluidic Throttling
Previous studies have demonstrated the effectiveness of using fluidic actuators to throttle the flow through a nozzle guide vane, enabling a variable area turbine (VAT) with no moving parts. A simplified model was developed to assess the driving design factors that influence the blocked flow fraction and throttling effectiveness of the actuators. The model approximates slot injection using a simplified stream tube analysis, neglecting mixing with the primary passage flow. Throttling performance is predicted for fluidic actuators with different widths, orientations, streamwise locations, and pressure ratios. This simplified model evaluates these actuators in a constant width straight duct and a variable width duct. Two-dimensional CFD of injection in the nozzle guide vane passage reported strong agreement with the results of the simple model using the variable width duct. Higher injection pressure ratios result in more injected mass flow but not significantly higher throttling effectiveness. Wider slots retain the effectiveness and block much more primary flow. Upstream oriented injection proves best for both effectiveness and blockage capabilities. Finally, there is an optimal injection location relative to the passage throat, which is extracted by both the model and CFD. This model has potential application for optimizing fluidic VAT throttling designs while saving on the cost of high-fidelity testing and production of these configurations.
- 15 October 2024
- Published by Wiley in Journal of Turbomachinery
- Vol. 147 (3) , 1-32
A Simplified Injection Model for Variable Area Turbine Fluidic Throttling
Previous studies have demonstrated the effectiveness of using fluidic actuators to throttle the flow through a nozzle guide vane, enabling a variable area turbine (VAT) with no moving parts. A simplified model was developed to assess the driving design factors that influence the blocked flow fraction and throttling effectiveness of the actuators. The model approximates slot injection using a simplified stream tube analysis, neglecting mixing with the primary passage flow. Throttling performance is predicted for fluidic actuators with different widths, orientations, streamwise locations, and pressure ratios. This simplified model evaluates these actuators in a constant width straight duct and a variable width duct. Two-dimensional CFD of injection in the nozzle guide vane passage reported strong agreement with the results of the simple model using the variable width duct. Higher injection pressure ratios result in more injected mass flow but not significantly higher throttling effectiveness. Wider slots retain the effectiveness and block much more primary flow. Upstream oriented injection proves best for both effectiveness and blockage capabilities. Finally, there is an optimal injection location relative to the passage throat, which is extracted by both the model and CFD. This model has potential application for optimizing fluidic VAT throttling designs while saving on the cost of high-fidelity testing and production of these configurations.