Shuai Yuan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Shuai Yuan has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Zhixiang Zou
Southeast University
3 shared publications Chen Qi
China Electric Power Research Institute, Beijing, China
1 shared publicationDawei Chen
Fujian Electric Power Research Institute, Fuzhou, China
1 shared publication- Giampaolo Buticchi
Faculty of Science and Engineering, University of Nottingham Ningbo China, Ningbo, China
1 shared publication - Jian Tang
School of Electrical Engineering, Southeast University, Nanjing, China
1 shared publication Jinyu Chen
Fujian Electric Power Research Institute, Fuzhou, China
1 shared publication
Latest Publications
- 13 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Systems
- Vol. 40 (6) , 5499-5502
Self-Sustained Oscillation Analysis of Grid-Interfaced Converters by Frequency-Domain Method Considering Harmonic Balance Principle
This letter presents a frequency-domain framework for the synchronization stability research of grid-following (GFL) converters in the case of disturbances such as phase-jumps and voltage-sags. It is revealed that a closed orbit around the stable equilibrium point, namely limit cycle (LC), may be emerged due to the operating conditions of GFL converters, which determines the stable boundary. A practical guideline, which covers model construction and stability criterion formulation within the developed framework, is detailed. It can be utilized for identification of LC parameters and system stability margins. The theoretical findings are corroborated by numerical and experimental tests.
- 13 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Systems
- Vol. 40 (6) , 5499-5502
Self-Sustained Oscillation Analysis of Grid-Interfaced Converters by Frequency-Domain Method Considering Harmonic Balance Principle
This letter presents a frequency-domain framework for the synchronization stability research of grid-following (GFL) converters in the case of disturbances such as phase-jumps and voltage-sags. It is revealed that a closed orbit around the stable equilibrium point, namely limit cycle (LC), may be emerged due to the operating conditions of GFL converters, which determines the stable boundary. A practical guideline, which covers model construction and stability criterion formulation within the developed framework, is detailed. It can be utilized for identification of LC parameters and system stability margins. The theoretical findings are corroborated by numerical and experimental tests.
- 7 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 13 (2) , 2258-2269
A Generalized Design Criterion of Filter-Based Stabilizing Control of ST-Fed LV Grid
Despite the Smart Transformer’s (ST) significant advantages in addressing system-level challenges, control-level issues, especially stability issues arising from the increasing penetration of inverter-based renewables, remain crucial. Existing methods, like filter-based active damping and virtual impedance, have been explored in literature to improve the stability of low voltage (LV) ST-fed grids. However, most of these approaches are tailored to specific stability concerns, lacking the generality needed for comprehensive designs. To bridge this gap, this paper proposes a generalized filter-based stabilizing control for the ST LV converter, using the biquadratic filter. A general design criterion is proposed, grounded in pole-zero compensation within a multi-input multi-output (MIMO) system framework. This design criterion aims to determine an optimal stability region for parameter design, with the potential to be applied to a broader range of second-order filters with poles and zeros. Both theoretical analysis and testing validate the effectiveness of the proposed control strategy and design criterion.
- 7 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 13 (2) , 2258-2269
A Generalized Design Criterion of Filter-Based Stabilizing Control of ST-Fed LV Grid
Despite the Smart Transformer’s (ST) significant advantages in addressing system-level challenges, control-level issues, especially stability issues arising from the increasing penetration of inverter-based renewables, remain crucial. Existing methods, like filter-based active damping and virtual impedance, have been explored in literature to improve the stability of low voltage (LV) ST-fed grids. However, most of these approaches are tailored to specific stability concerns, lacking the generality needed for comprehensive designs. To bridge this gap, this paper proposes a generalized filter-based stabilizing control for the ST LV converter, using the biquadratic filter. A general design criterion is proposed, grounded in pole-zero compensation within a multi-input multi-output (MIMO) system framework. This design criterion aims to determine an optimal stability region for parameter design, with the potential to be applied to a broader range of second-order filters with poles and zeros. Both theoretical analysis and testing validate the effectiveness of the proposed control strategy and design criterion.
- Open Access
- 21 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Power Electronics
- Vol. 5, 1697-1708
A Model Predictive Control With Grid-Forming Capability for Back-to-Back Converters in Wind Turbine Systems
With the increasing penetration of wind turbine (WT) systems with permanent magnet synchronous generators (PMSGs) into the power grids, the back-to-back converter (BTB) has become the key element interfacing wind sources and power grids. Compared to the grid-following voltage source converter (GFL-VSC), the grid-forming VSC (GFM-VSC) shows voltage and frequency support capabilities, which meets the requirement of grid codes for WT systems. Usually, the linear regulator is employed to realize the tracking of voltage and current of GFM-VSCs, but it has limitations of complex parameter design and dynamic performance. Recently, the model predictive control (MPC) is a promising alternative controller due to the easy adoption and fast control response. This paper proposes a novel MPC method for BTB to achieve grid-forming function. The model-based control concept of the MPC effectively overcomes the complex parameter-tuning process of the cascaded linear regulators. In addition, the overshoot in the step-response of the active power of GFM-VSCs during transient process is effectively improved by using a new multi-objective cost function. The reduced power overshoot is beneficial for fully utilizing the overload capacity of the converter, avoiding damage to semiconductor devices and causing system blocking. Finally, the simulation and experiments have confirmed the feasibility of the proposed MPC method.
- 21 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Power Electronics
- Vol. 5, 1697-1708
Open AccessA Model Predictive Control With Grid-Forming Capability for Back-to-Back Converters in Wind Turbine Systems
With the increasing penetration of wind turbine (WT) systems with permanent magnet synchronous generators (PMSGs) into the power grids, the back-to-back converter (BTB) has become the key element interfacing wind sources and power grids. Compared to the grid-following voltage source converter (GFL-VSC), the grid-forming VSC (GFM-VSC) shows voltage and frequency support capabilities, which meets the requirement of grid codes for WT systems. Usually, the linear regulator is employed to realize the tracking of voltage and current of GFM-VSCs, but it has limitations of complex parameter design and dynamic performance. Recently, the model predictive control (MPC) is a promising alternative controller due to the easy adoption and fast control response. This paper proposes a novel MPC method for BTB to achieve grid-forming function. The model-based control concept of the MPC effectively overcomes the complex parameter-tuning process of the cascaded linear regulators. In addition, the overshoot in the step-response of the active power of GFM-VSCs during transient process is effectively improved by using a new multi-objective cost function. The reduced power overshoot is beneficial for fully utilizing the overload capacity of the converter, avoiding damage to semiconductor devices and causing system blocking. Finally, the simulation and experiments have confirmed the feasibility of the proposed MPC method.