Jiaxin Pan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jiaxin Pan has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Wanbo Wang
State Key Laboratory of Aerodynamics, China Aerodynamics Research and Development Center, Mianyang, China
2 shared publications - Jiao Sun
Department of Process Equipment and Control Engineering, Hebei University of Technology, Tianjin 300401, China
1 shared publication - Qixiang Sun
State Key Laboratory of Aerodynamics of China Aerodynamics Research and Development Center, Mianyang, China
1 shared publication - Wenyi Chen
Department of Process Equipment and Control Engineering, Hebei University of Technology, Tianjin 300130, China
1 shared publication - Xinhai Zhao
China Aerodynamics Research and Development Center
1 shared publication - Yan Shao
Department of Process Equipment and Control Engineering, School of Chemical Engineering, Hebei University of Technology, Tianjin 300401, China
1 shared publication
Latest Publications
- Open Access
Design of High-Efficiency Jet Lift Enhancement for Flaps Under Propeller Slipstream Influence
Both propeller slipstream and flap jet flow can significantly increase the aircraft lift coefficient. To establish design principles for efficient lift enhancement via jet flow under the influence of slipstream, wind tunnel experiments are conducted on a wing with propeller slipstream and jet flow. Force measurements using a balance and flow field measurements using hot-wire anemometry are employed to investigate the effects of different jet flow distribution methods on lift enhancement. The results indicate that the coupling of slipstream and jet flow effects can significantly increase wing lift. The stronger the slipstream effect, the more pronounced the lift enhancement under the same momentum coefficient. At the same thrust coefficient, a higher momentum coefficient is required in the slipstream-affected region to suppress airflow separation. Under the same jet flow rate, increasing the momentum coefficient in the slipstream-affected region can significantly improve lift enhancement. At the thrust coefficient of 0.46 and the momentum coefficient of 0.1, the optimized jet flow distribution method achieved a 52.6% greater lift enhancement compared to the spanwise uniform jet flow distribution method.
Open AccessDesign of High-Efficiency Jet Lift Enhancement for Flaps Under Propeller Slipstream Influence
Both propeller slipstream and flap jet flow can significantly increase the aircraft lift coefficient. To establish design principles for efficient lift enhancement via jet flow under the influence of slipstream, wind tunnel experiments are conducted on a wing with propeller slipstream and jet flow. Force measurements using a balance and flow field measurements using hot-wire anemometry are employed to investigate the effects of different jet flow distribution methods on lift enhancement. The results indicate that the coupling of slipstream and jet flow effects can significantly increase wing lift. The stronger the slipstream effect, the more pronounced the lift enhancement under the same momentum coefficient. At the same thrust coefficient, a higher momentum coefficient is required in the slipstream-affected region to suppress airflow separation. Under the same jet flow rate, increasing the momentum coefficient in the slipstream-affected region can significantly improve lift enhancement. At the thrust coefficient of 0.46 and the momentum coefficient of 0.1, the optimized jet flow distribution method achieved a 52.6% greater lift enhancement compared to the spanwise uniform jet flow distribution method.
- Open Access
PCA-Kriging-Based Oscillating Jet Actuator Optimization and Wing Separation Flow Control
In order to improve the separation control effect of an oscillating jet, the external flow field of the actuators and the wing wake are obtained via hot-wire measurements to optimize the actuator and achieve wing separation flow control. The optimization objectives are to improve the sweeping uniformity and range of the jet. In the present study, the PCA method is used for the modal decomposition of the velocity distribution. The modal-based actuator evaluation parameters are proposed, and the kriging surrogate models of the modal coefficients (principal components) on the actuator parameters are established. The multi-objective genetic algorithm was utilized to complete the optimization of the actuator, and the effect of flow separation control on the wing was verified. The results show that three patterns exist in the time-averaged velocity distribution of the external flow field: unimodal, broad and bimodal, from unimodal to bimodal, the degree of the jet sweeping uniformity gradually decreases, and the sweeping range gradually increases. The pattern of the velocity distribution modals affects the degree of jet sweeping uniformity, while the distance of the modal peaks affects the jet sweeping range. The two evaluation parameters are negatively correlated: insufficient sweeping range or poor sweeping uniformity of the jet are not conducive to wing separation flow control, and the two must be coordinated to achieve the optimal control effect.
Open AccessPCA-Kriging-Based Oscillating Jet Actuator Optimization and Wing Separation Flow Control
In order to improve the separation control effect of an oscillating jet, the external flow field of the actuators and the wing wake are obtained via hot-wire measurements to optimize the actuator and achieve wing separation flow control. The optimization objectives are to improve the sweeping uniformity and range of the jet. In the present study, the PCA method is used for the modal decomposition of the velocity distribution. The modal-based actuator evaluation parameters are proposed, and the kriging surrogate models of the modal coefficients (principal components) on the actuator parameters are established. The multi-objective genetic algorithm was utilized to complete the optimization of the actuator, and the effect of flow separation control on the wing was verified. The results show that three patterns exist in the time-averaged velocity distribution of the external flow field: unimodal, broad and bimodal, from unimodal to bimodal, the degree of the jet sweeping uniformity gradually decreases, and the sweeping range gradually increases. The pattern of the velocity distribution modals affects the degree of jet sweeping uniformity, while the distance of the modal peaks affects the jet sweeping range. The two evaluation parameters are negatively correlated: insufficient sweeping range or poor sweeping uniformity of the jet are not conducive to wing separation flow control, and the two must be coordinated to achieve the optimal control effect.