JXJing Xie

Jing Xie

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jing Xie has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Seismic Response Amplification Mechanisms and Base-Isolation Retrofit Evaluation of a 500 kV Three-Phase Transformer with Steel Supports

    by Yukun Du, Li Zhang, Jing Xie, Xiaoxuan Li, Wei Liu

    The effects of steel supports on the dynamic characteristics and seismic demands of large three-phase power transformers remain insufficiently quantified. A three-dimensional finite-element model of a 500 kV three-phase transformer was developed to compare configurations without steel support (NS) and with steel support (WS). Modal characteristics and seismic bushing responses were evaluated under seven three-component ground motions. Frequency-response characteristics and global tank rotations were then analyzed, and a double friction pendulum (DFP) base-isolation retrofit was assessed. The lowest natural frequency of the WS model was 1.47 Hz, lower than the 1.84 Hz obtained for the NS model. For the representative X-direction response of high-voltage bushing A, the dominant low-frequency peak of the frequency-response function shifted from approximately 1.89 to 1.64 Hz, while its magnitude increased from approximately 8 to 19. The mean peak maximum principal tensile stress at the root of bushing A increased by 83.1%. The WS model also exhibited greater tank rocking and torsional responses, whose peaks were positively associated with the peak root stresses of bushings A and B. For representative high-voltage bushing B, the DFP retrofit achieved a mean isolation efficiency of approximately 60%. These results elucidate the mechanisms by which steel supports amplify the seismic response of the large 500 kV three-phase power transformer and provide a numerical evaluation of the effectiveness of a DFP base-isolation retrofit for this transformer.