Gaku Mitsuka
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Gaku Mitsuka has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Larry Ruckman
SLAC National Accelerator Laboratory, 2575 Sand Hill Road, M/S 96, Menlo Park, CA 94025, U.S.A.
3 shared publications - R. Nomaru
Department of Physics, The University of Tokyo, Bunkyo, Tokyo 113-0033, Japan
2 shared publications - B. Urbschat
Nagoya University, Furo-cho, Chikusa, Nagoya, Aichi, Japan
1 shared publication - Ryan Herbst
SLAC National Accelerator Laboratory 1 , Menlo Park, California 94025
1 shared publication - Shinnosuke Kato
The University of Tokyo
1 shared publication
Latest Publications
- Open Access
- 7 October 2026
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 29 (10) , 105103
Implementation and deployment of an injection tuning tool using Bayesian optimization at the SuperKEKB accelerator
As of July 2025, the SuperKEKB accelerator, which collides 7 GeV electrons with 4 GeV positrons to abundantly produce particles such as B mesons and τ leptons, holds the world record for the highest instantaneous luminosity. Continuous operation and upgrades are underway to achieve even higher luminosities. Maintaining a high instantaneous luminosity requires sustaining high beam currents in the storage rings, which in turn demands efficient beam injection from the injector. In particular, a high injection efficiency, defined as the ratio of the beam current successfully accumulated in the ring to the current delivered from the beam transport line, must be ensured. In the present study, we developed a tool to automate the injection tuning process using Bayesian optimization, a machine-learning-based technique, in order to improve the injection efficiency. During test operations conducted in November-December 2024, this tool successfully enhanced the injection efficiency by up to 32%.
- 7 October 2026
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 29 (10) , 105103
Open AccessImplementation and deployment of an injection tuning tool using Bayesian optimization at the SuperKEKB accelerator
As of July 2025, the SuperKEKB accelerator, which collides 7 GeV electrons with 4 GeV positrons to abundantly produce particles such as B mesons and τ leptons, holds the world record for the highest instantaneous luminosity. Continuous operation and upgrades are underway to achieve even higher luminosities. Maintaining a high instantaneous luminosity requires sustaining high beam currents in the storage rings, which in turn demands efficient beam injection from the injector. In particular, a high injection efficiency, defined as the ratio of the beam current successfully accumulated in the ring to the current delivered from the beam transport line, must be ensured. In the present study, we developed a tool to automate the injection tuning process using Bayesian optimization, a machine-learning-based technique, in order to improve the injection efficiency. During test operations conducted in November-December 2024, this tool successfully enhanced the injection efficiency by up to 32%.
- 1 March 2026
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 21 (03) , T03008
Measurement of sudden beam loss events using bunch-by-bunch BPMs at SuperKEKB
At SuperKEKB, Sudden Beam Loss (SBL) events pose a significant challenge to stable accelerator operation. To investigate and better understand SBL, we have developed a new Bunch Oscillation Recorder (BOR). Using this newly developed BOR, we successfully observed SBL events and conducted a detailed analysis of the recorded data. By analyzing the patterns of bunch position oscillations and charge loss, we found a strong correlation between SBL events and pressure burst phenomena occurring inside the vacuum chamber. These pressure bursts are known to accompany almost all SBL events, and our analysis shows that the bunch position oscillation patterns vary depending on the location of the pressure burst. Our observations suggest that bunch positions begin oscillation under some influence at the location of the pressure burst. These observations and analyses have significantly advanced our understanding of the causes and mechanisms behind SBL.
- 1 March 2026
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 21 (03) , T03008
Measurement of sudden beam loss events using bunch-by-bunch BPMs at SuperKEKB
At SuperKEKB, Sudden Beam Loss (SBL) events pose a significant challenge to stable accelerator operation. To investigate and better understand SBL, we have developed a new Bunch Oscillation Recorder (BOR). Using this newly developed BOR, we successfully observed SBL events and conducted a detailed analysis of the recorded data. By analyzing the patterns of bunch position oscillations and charge loss, we found a strong correlation between SBL events and pressure burst phenomena occurring inside the vacuum chamber. These pressure bursts are known to accompany almost all SBL events, and our analysis shows that the bunch position oscillation patterns vary depending on the location of the pressure burst. Our observations suggest that bunch positions begin oscillation under some influence at the location of the pressure burst. These observations and analyses have significantly advanced our understanding of the causes and mechanisms behind SBL.
- Open Access
- 1 March 2026
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 21 (03) , P03035
Application of RFSoC technology for beam position monitors at the SuperKEKB storage rings injection points
In order to achieve its ambitious luminosity target, the SuperKEKB collider must achieve and sustain high beam currents on the order of Ampere in its storage rings. This requires continuous top-up injection and operation with a two-bunch injection scheme, injecting two 96 ns spaced bunches in a single injection cycle. An important input for tuning the injection beam is the position reading from a dedicated beam position monitor (BPM), located after the septum magnets, slightly upstream of where the injected and stored beams converge. Previously, the readout electronics used for these special BPMs were not capable of independent measurement of both bunches in the two-bunch injection mode and modification of the concerned devices and their firmware was not feasible. The opportunity was taken to develop a new readout device based on the AMD/Xilinx RF System on a Chip (RFSoC) platform with the goal of not only providing a sufficiently flexible and performant readout solution for the concerned BPMs, but also to evaluate and gain experience with the platform for beam monitor electronics applications. This paper is concerned with the details of this development as well as evaluation and operation of the developed device.
- 1 March 2026
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 21 (03) , P03035
Open AccessApplication of RFSoC technology for beam position monitors at the SuperKEKB storage rings injection points
In order to achieve its ambitious luminosity target, the SuperKEKB collider must achieve and sustain high beam currents on the order of Ampere in its storage rings. This requires continuous top-up injection and operation with a two-bunch injection scheme, injecting two 96 ns spaced bunches in a single injection cycle. An important input for tuning the injection beam is the position reading from a dedicated beam position monitor (BPM), located after the septum magnets, slightly upstream of where the injected and stored beams converge. Previously, the readout electronics used for these special BPMs were not capable of independent measurement of both bunches in the two-bunch injection mode and modification of the concerned devices and their firmware was not feasible. The opportunity was taken to develop a new readout device based on the AMD/Xilinx RF System on a Chip (RFSoC) platform with the goal of not only providing a sufficiently flexible and performant readout solution for the concerned BPMs, but also to evaluate and gain experience with the platform for beam monitor electronics applications. This paper is concerned with the details of this development as well as evaluation and operation of the developed device.
- 1 December 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (12) , P12026
Development of a novel bunch oscillation recorder with RFSoC technology
The SuperKEKB accelerator is designed to achieve unprecedented luminosity levels, but this goal is currently hindered by Sudden Beam Loss (SBL) events. These events not only obstruct luminosity improvement but also pose a significant risk to accelerator components, the Belle II detectors, and the superconducting focusing system, potentially leading to severe damage and quenching of the superconducting system. To address this critical challenge, we have developed a novel Bunch Oscillation Recorder (BOR) based on RFSoC technology. The BOR has demonstrated high precision with a position resolution of 0.03 mm, making it a powerful tool for real-time beam monitoring. In its initial deployment, the BOR successfully recorded multiple SBL events, providing valuable data for further analysis. By strategically positioning BORs at the suspected points of SBL origin, we aim to directly identify sources of beam instability. We anticipate that this portable, high-speed BOR monitor will play a crucial role in resolving the SBL issue, ultimately helping achieve SuperKEKB's luminosity targets.
- 1 December 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (12) , P12026
Development of a novel bunch oscillation recorder with RFSoC technology
The SuperKEKB accelerator is designed to achieve unprecedented luminosity levels, but this goal is currently hindered by Sudden Beam Loss (SBL) events. These events not only obstruct luminosity improvement but also pose a significant risk to accelerator components, the Belle II detectors, and the superconducting focusing system, potentially leading to severe damage and quenching of the superconducting system. To address this critical challenge, we have developed a novel Bunch Oscillation Recorder (BOR) based on RFSoC technology. The BOR has demonstrated high precision with a position resolution of 0.03 mm, making it a powerful tool for real-time beam monitoring. In its initial deployment, the BOR successfully recorded multiple SBL events, providing valuable data for further analysis. By strategically positioning BORs at the suspected points of SBL origin, we aim to directly identify sources of beam instability. We anticipate that this portable, high-speed BOR monitor will play a crucial role in resolving the SBL issue, ultimately helping achieve SuperKEKB's luminosity targets.