NHNaurotul Husna

Naurotul Husna

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Naurotul Husna has a total of 4 co-authors. Here are the top co-authors by number of shared publications:

  • Maya Ismayati

    Research Center for Biomass and Bioproduct, National Research and Innovation Agency, Tangerang Selatan, Indonesia

    1 shared publication
  • Nissa Nurfajrin Solihat

    National Research and Innovation Agency (BRIN) Research Center for Biomass and Bioproducts, Research Organization for Life Sciences and Environment Cibinong

    1 shared publication
  • Wasrin Syafii

    Research Center for Biomass and Bioproducts, National Research and Innovation Agency (BRIN), Jl Raya Bogor KM 46, Cibinong, 16911, Indonesia

    1 shared publication
  • Widya Fatriasari

    Research Center for Biomass and Bioproducts, Research Organization for Nanotechnology and Material, National Research and Innovation Agency (BRIN), Serpong 15314, Indonesia

    1 shared publication

Latest Publications

  • Mechanically Strong and Fast‐Curing Kraft Lignin‐Based Polyurethane Foam

    by Naurotul Husna, Maya Ismayati, Wasrin Syafii, Widya Fatriasari, Nissa Nurfajrin Solihat

    The creation of biobased rigid polyurethane from nonfood resources such as lignin has garnered significant interest, especially concerning the biorefinery concept. However, few studies have investigated virgin lignin as a polyol source for polyurethane foam and the effects of single factors, such as the lignin solvent, lignin concentration, and lignin:isocyanate ratio, on the properties of polyurethane. High‐density rigid foam (~500 kg/m3) was successfully formed by all the solvents except sodium hydroxide, which was confirmed via Fourier transform infrared (FTIR) spectroscopy and pyrolysis‐gas chromatography–mass spectrometry (Py‐GCMS). The highest to lowest modulus of elasticity (MOE) and modulus of rupture (MOR) values for the different lignin solvents were as follows: tetrahydrofuran (THF) (402.25 and 13.24 N/mm2) > dimethyl formamide (DMF) (46 and 1.69 N/mm2) > dimethyl sulfoxide (DMSO) (29 and 1.39 N/mm2). DMSO was selected as the optimal solvent because of the considerable curing time (26.67 s) needed to produce rigid foam. A higher lignin concentration resulted in better physical, mechanical, and thermal properties of the foam to some extent. Moreover, the opposite occurred with increasing isocyanate ratio in the system. These findings can serve as a basis for optimizing the utilization of lignin as a bioresource in the manufacture of rigid polyurethane foam with more specific uses.