RWRichard Wuhrer

Richard Wuhrer

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Richard Wuhrer has a total of 40 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Climate drivers of mesophyll conductance: temperature and water deficit alter CO 2 diffusion and leaf anatomy in cotton

    by Demi Sargent, Warren C. Conaty, Kelly Chapman, Garima Dubey, Laurel George, Sue Lindsay, Richard Wuhrer, Susanne von Caemmerer, John R. Evans, Robert E. Sharwood

    Summary: Mesophyll conductance ( g m ) limits CO 2 delivery to Rubisco, yet its responses to temperature, heat and water deficit are poorly resolved in cotton ( Gossypium hirsutum ). We characterised photosynthetic and g m temperature responses in five Gossypium species, then examined cultivated G. hirsutum and the Australian native Gossypium bickii under combined elevated temperature and soil water deficit to link physiological responses with mesophyll anatomy. Plants were grown under controlled glasshouse conditions. We quantified g m using simultaneous gas exchange and online stable carbon isotope discrimination (Δ, ‰) and measured leaf anatomy. Across species, photosynthesis and g m exhibited broad thermal optima (33–36°C). In G. hirsutum , water deficit at control temperature reduced g m and induced thicker, more porous mesophyll and thicker cell walls, while assimilation declined only under combined heat and water deficit. In G. bickii , g m and assimilation remained stable under combined stress, and g m was stimulated by elevated temperature without anatomical adjustment. g m emerged as a stress‐sensitive trait in cultivated cotton, whereas G. bickii exhibited stress resilience, with responses incompletely explained by anatomical acclimation. Further research on g m responses to environmental stresses and on the mechanisms underpinning these responses is required to inform model development and identify traits for climate resilient crops.

  • Open Access

    Evidence for a defensive ceiling in the effectiveness of plant silicon defences against an insect herbivore

    by Marie‐Emma Denarié, Uffe N. Nielsen, Susan E. Hartley, Richard Wuhrer, Scott N. Johnson

    Many plants take up silicon (Si) from the soil and deposit it in their tissues to resist insect herbivory via physical and chemical mechanisms. Si‐supplemented wheat, for example, negatively impacts insects such as the cotton bollworm ( Helicoverpa armigera ). Si‐based defences are rapidly deployed, but it is unclear whether levels of Si defence affect herbivore performance linearly (i.e., increasing levels of Si continue to decrease performance), or whether resistance saturates at a certain level of Si accumulation. We examined how a gradient of Si supplementation in wheat affected relative growth rates (RGRs) and mandible wear of H. armigera . Plants were either not provided with Si or supplemented with one of four levels of Si (0.25 mM, 0.5 mM, 2 mM and 4 mM) in hydroponic solutions and fed to second‐instar H. armigera larvae. RGR declined most with higher levels of Si compared to the lowest levels of Si supplementation, and there was a significant negative correlation between plant Si and RGR. However, significant reductions in RGR were generally achieved midway through the Si gradient (2 mM). Si supplementation increased plant biomass overall and ameliorated biomass losses due to herbivory. The wearing of insect mandibles was lower on larvae that had fed on silicified plants. Our study also revealed that wheat can take up Si at concentrations beyond its polymerization threshold of 2 mM. We demonstrate that although wheat can acquire Si at relatively high concentrations, accumulation beyond this level does not confer further benefits in terms of herbivore defence.

  • Open Access

    Trade-offs between photosynthetic capacity, mesophyll conductance stability and leaf anatomy shape heat and water deficit resilience in Gossypium

    by Demi Sargent, Warren Conaty, Kelly Chapman, Garima Dubey, Laurel George, Sue Lindsay, Richard Wuhrer, Susanne von Caemmerer, John Evans, Robert Sharwood

    Summary: Mesophyll conductance ( g m ) governs CO 2 diffusion to Rubisco and is a key determinant of photosynthetic performance, yet the mechanisms underlying its sensitivity to heat and water stress remain unresolved. We quantified g m temperature responses across diverse Gossypium species and examined anatomical drivers of g m plasticity in cultivated cotton ( G. hirsutum ) and the wild Australian species G. bickii under elevated temperature and soil water deficit. Species exhibited contrasting g m strategies: G. hirsutum exhibited high g m and carbon assimilation near thermal optima but showed greater sensitivity under combined heat and water deficit, whereas G. bickii maintained comparatively stable g m and photosynthesis across stress conditions. Under water deficit, structural adjustments in G. hirsutum (increased leaf porosity, cell wall thickness and mesophyll surface exposure to intercellular airspaces) were insufficient to sustain g m , suggesting that liquid-phase resistances impose dominant constraints on CO 2 diffusion under extreme climatic stress. These results identify g m as a dynamic, multi-component trait and a key physiological vulnerability in cotton, shaped by coordinated anatomical characteristics and potentially cell wall properties and membrane-associated processes, with major implications for mechanistic photosynthesis modelling and improving climate resilience in cotton and other C 3 species.

  • Open Access

    Analyzing the Chemical Stability of Bio‐Based Polyamide Resins via Solubility Parameters, NMR Spectroscopy and Capillary Electrophoresis

    by Kash A. Bhullar, Richard Wuhrer, Patrice Castignolles, Marianne Gaborieau

    Chemical stability is a key property for polymeric hot‐melt adhesives (HMAs) used in industrial settings. The chemical stability of an HMA and its polyamide base resin (obtained from bio‐based dimer acids) is assessed after immersion in various solvents. Visual observation and gravimetry show that they resist alkaline conditions better than acidic conditions and are susceptible to dispersion in organic solvents. The organic solvents’ impact can be predicted using Hansen parameters. Infrared (FTIR) and solid‐state NMR spectroscopies confirm the degradation of the polyamide resins and HMA at the molecular level. Solution‐state NMR allows the identification of the type of degradation, such as aromatic substitution. Aromatics and vinylics (from the dimer acid) are quantified with solution‐state NMR, including benchtop NMR. The precision of the quantification does not depend on the sensitivity of the instrument but rather on the user‐dependent data treatment. The degradation occurs via amide hydrolysis, leading to chain scission, without imide formation. Degradation does not affect the relative amount of vinylics but surprisingly affects that of the aromatics. Free‐solution capillary electrophoresis (CE) allows the detection and separation of the most hydrophilic degradation products, including monomers, during the degradation in highly acidic or alkaline conditions without any sample preparation.


  • Open Access

    Microanalysis and X-Ray Mapping of Plant Material: Sample Preparation, Instrument Operation and XRM Processing Considerations

    by Laurel George, Daniel J. Fanna, Ken Moran, Hyunsung Min, Richard Wuhrer

    The use of microanalysis and X-ray mapping (XRM) techniques to locate, identify and spatially map elements in plant materials is of growing interest in the area of plant sciences. Some recent examples include the use of XRM to examine silicon deposition in grass leaf guard cells [ 1- 2], locate calcium oxalate in Eucalyptus leaves [ 3], and assess concentrations of salts in germinating seeds [ 4] and grass leaf tissues [ 5]. The increasing use of XRM in plant sciences is in a large part due to advancements associated with instrument hardware and analysis software, reducing the analysis times needed and hence making these techniques more accessible. There is a lot to consider when preparing and analysing plant material, however, such as how the material preparation method affects the results, the SEM/XRM settings and conditions used for the analysis, and lastly the processing of the XRM results. With developments in analysis software, there is now a lot more information that can be extracted. For example, while XRM can be used to colour-code and examine the spatial distribution of elements present in a sample, the X-ray intensity distributions of the elements can also be used to generate two and three-dimensional scatter diagrams. These can then be used to identify and spatially map ratios of elements selected, and chemical phases present [ 6]. In this study, Eucalyptus robusta leaves were used to demonstrate how different sample preparation techniques (e.g. critical point dried samples versus oven dried at 60°C), and different SEM and XRM conditions (e.g. mapping carbon coated samples under high vacuum versus uncoated samples in low vacuum, and the use of different accelerating voltages) can affect XRM results obtained.

  • Open Access

    Testing of aluminium composite panels in a cone calorimeter: A new specimen preparation method

    by Delwar Hossain, Swapan Saha, Kamrul Hassan, Anthony Chun Yin Yuen, Cheng Wang, Waseem Hittini, Laurel George, Richard Wuhrer


  • Open Access

    Leaf silicification provides herbivore defence regardless of the extensive impacts of water stress

    by Rebecca K. Vandegeer, Ximena Cibils‐Stewart, Richard Wuhrer, Susan E. Hartley, David T. Tissue, Scott N. Johnson

    Altered precipitation patterns due to climate change are likely to impose water‐deficit stress in plants resulting in changes to specific leaf mass, leaf water content and chemical defences that may impact herbivorous arthropods. Grasses, in particular, accumulate large concentrations of silicon (Si) which provides physical defence against herbivores. Although Si uptake by plants may be affected by water availability, very few studies have investigated the combined effect of water‐deficit stress and Si on insect herbivore performance. We grew tall fescueFestuca arundinaceaSchreb. hydroponically, with and without Si, and half of the plants were treated with 20% polyethylene glycol (PEG) to impose osmotic stress. In all, 11 leaf traits (physiological, chemical and structural) were measured, silicified phytoliths on the leaf surface were visualised using scanning electron microscopy (SEM) in conjunction with X‐ray mapping, and plants were exposed to a chewing insect herbivore [Helicoverpa armigeraHübner (Lepidoptera: Noctuidae)]. Although osmotic stress was associated with changes to leaf physiological and chemical traits, including increased specific leaf mass, decreased leaf relative water content and increased leaf nitrogen (N), there was no significant effect onH. armigerarelative growth rate (RGR). However, Si reduced RGR ofH. armigeraby 80%–98% while generating few changes to physiological and chemical leaf traits. Instead, the decline in RGR with Si was associated with changes to leaf structural traits, in particular, a greater density of silicified phytoliths on the leaf surface. Comparison of effect sizes indicated that leaf traits were primarily affected by osmotic stress but not Si, and that herbivore RGR was strongly negatively affected by Si but not osmotic stress. There was no interactive effect between the osmotic stress and Si treatments onH. armigeraRGR or plant traits except for leaf nitrogen and phenolic concentrations. This study provides further support that Si may prove to be beneficial to plants against chewing insect pests and remains robust regardless of water‐deficit stress conditions. A freePlain Language Summarycan be found within the Supporting Information of this article.


  • Open Access

    Ternary β and γ phases in the Al–Au–Cu system at 750°C

    by V.K. Bhatia, C.S. Kealley, R. Wuhrer, K.S. Wallwork, M.B. Cortie