XGXilin Gan

Xilin Gan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xilin Gan has a total of 6 co-authors. Here are the top co-authors by number of shared publications:

  • Hang Yan

    Innovation & Interdisciplinary Institute of Low Carbon Metallurgical Engineering, School of Materials and Energy, Guangdong University of Technology, Guangzhou 510006, China

    1 shared publication
  • Lingbo Mao

    Institute of Interdisciplinary Innovation in Low Carbon Metallurgical Engineering (School of Materials and Energy), Guangdong University of Technology, Guangzhou, China

    1 shared publication
  • Shichao Liu

    School of Iron and Steel, Soochow University, Suzhou 215021, China

    1 shared publication
  • Shougang Duan

    School of Materials Science and Engineering, South China University of Technology, Guangzhou 510640, China

    1 shared publication
  • Yong Dong

    Innovation & Interdisciplinary Institute of Low Carbon Metallurgical Engineering (School of Materials and Energy), Guangdong University of Technology, Guangzhou, China

    1 shared publication
  • Yu Wang

    School of Materials Science and Engineering, North University of China, Taiyuan, China

    1 shared publication

Latest Publications

  • Open Access

    Microstructure Evolution and Mechanical Properties of Dual-Phase AlCrFe2Ni2 High-Entropy Alloy Under High-Strain-Rate Compression

    by Hang Yan, Yu Wang, Xilin Gan, Yong Dong, Shichao Liu, Shougang Duan, Lingbo Mao

    This paper investigates the effect of strain rate on the mechanical deformation and microstructural development of dual-phase AlCrFe2Ni2 high-entropy alloy during quasi-static and dynamic compression processes. It is revealed that the as-cast AlCrFe2Ni2 alloy is composed of a mixture of FCC, disordered BCC, and ordered B2 crystal structure phases. The alloy shows excellent compressive properties under quasi-static and dynamic deformation. The yield strength exceeds 600 MPa while the compressive strength is more than 3000 MPa at the compression rates of 30% under quasi-static conditions. Under dynamic compression conditions, the ultimate compression stresses are 1522 MPa, 1816 MPa, and 1925 MPa with compression strains about 12.8%, 14.7%, and 18.2% at strain rates of 1300 s−1, 1700 s−1 and 2100 s−1, respectively. The dynamic yield strength is approximately linear with strain rate within the specified range and exhibit great sensitivity. The strong localized deformation regions (i.e., adiabatic shear bands (ASBs)) appear in dynamically deformed samples by dynamic recrystallization due to the conflicting processes of strain rate hardening and heat softening.