Kazutoshi Kojima
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Kazutoshi Kojima has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Keiko Masumoto
Advanced Power Electronics Research Center
2 shared publications Kunihide Ozono
Advanced Power Electronics Research Center
2 shared publications- Shinsuke Harada
National Institute of Advanced Industrial Science and Technology (AIST)
2 shared publications - Hidetsugu Uchida
SICOXS Corporation
1 shared publication - Kuniaki Yagi
SICOXS Corporation
1 shared publication Motoki Kobayashi
SICOXS Corporation
1 shared publication
Latest Publications
- Open Access
- 22 August 2024
- Published by Trans Tech Publications, Ltd. in Defect and Diffusion Forum
- Vol. 434, 39-44
Analysis of Forward Bias Degradation Reduction in 4H-SiC PiN Diodes on Bonded Substrates
Analysis of forward bias degradation reduction of 4H-Silicon Carbide (4H-SiC) PiN diodes on bonded substrates was performed. In the analysis, cathodoluminescence (CL), photoluminescence imaging (PL imaging), and transmission electron microscope (TEM) were used. Under high forward bias stress, the Shockley-type stacking fault (SSF) does not expand into the transferred layer of the bonded substrate, while in the monocrystalline substrate, the SSF expands below the epilayer/substrate interface. The basal plane dislocation (BPD) within the transferred layer does not expand to the SSF. The transferred layer has the effect of suppressing the expansion of SSFs. This effect can be caused by hydrogen implantation for wafer splitting to produce bonded SiC substrates.
- 22 August 2024
- Published by Trans Tech Publications, Ltd. in Defect and Diffusion Forum
- Vol. 434, 39-44
Open AccessAnalysis of Forward Bias Degradation Reduction in 4H-SiC PiN Diodes on Bonded Substrates
Analysis of forward bias degradation reduction of 4H-Silicon Carbide (4H-SiC) PiN diodes on bonded substrates was performed. In the analysis, cathodoluminescence (CL), photoluminescence imaging (PL imaging), and transmission electron microscope (TEM) were used. Under high forward bias stress, the Shockley-type stacking fault (SSF) does not expand into the transferred layer of the bonded substrate, while in the monocrystalline substrate, the SSF expands below the epilayer/substrate interface. The basal plane dislocation (BPD) within the transferred layer does not expand to the SSF. The transferred layer has the effect of suppressing the expansion of SSFs. This effect can be caused by hydrogen implantation for wafer splitting to produce bonded SiC substrates.
- Open Access
- 6 June 2023
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 948, 107-113
Reduction of Forward Bias Degradation in 4H-SiC PiN Diodes Fabricated on 4H-SiC Bonded Substrates
The advantage in reducing forward bias degradation of bipolar 4H-SiC devices using a 4H-SiC bonded substrate is demonstrated. To evaluate the differences in forward bias degradation between a 4H-SiC bonded substrate and a commercially available 4H-SiC bulk substrate, a forward current stress test and subsequent photoluminescence (PL) imaging of PiN diodes fabricated on both the substrates were performed. Unlike the bulk substrate, the bonded substrate maintained a low ΔVf and the variation among the measured diodes was extremely small even after applying the highest current density of 1500 A/cm2. The investigated number of bar-shaped SSFs within the electrically stressed diodes with more than 1000 A/cm2 revealed the possibility that the BPDs existing at deep positions below the epilayer/substrate interface were drastically reduced in the 4H-SiC bonded substrate.
- 6 June 2023
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 948, 107-113
Open AccessReduction of Forward Bias Degradation in 4H-SiC PiN Diodes Fabricated on 4H-SiC Bonded Substrates
The advantage in reducing forward bias degradation of bipolar 4H-SiC devices using a 4H-SiC bonded substrate is demonstrated. To evaluate the differences in forward bias degradation between a 4H-SiC bonded substrate and a commercially available 4H-SiC bulk substrate, a forward current stress test and subsequent photoluminescence (PL) imaging of PiN diodes fabricated on both the substrates were performed. Unlike the bulk substrate, the bonded substrate maintained a low ΔVf and the variation among the measured diodes was extremely small even after applying the highest current density of 1500 A/cm2. The investigated number of bar-shaped SSFs within the electrically stressed diodes with more than 1000 A/cm2 revealed the possibility that the BPDs existing at deep positions below the epilayer/substrate interface were drastically reduced in the 4H-SiC bonded substrate.