Kuniaki Yagi
Research Subjects
Kuniaki Yagi has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Kazutoshi Kojima
Advanced Power Electronics Research Center
1 shared publication - Keiko Masumoto
Advanced Power Electronics Research Center
1 shared publication Kunihide Ozono
Advanced Power Electronics Research Center, National Institute of Advanced Industrial Science and Technology (AIST)
1 shared publicationMotoki Kobayashi
SICOXS Corporation
1 shared publication- Naoki Hatta
Advanced Power Electronics Research Center, National Institute of Advanced Industrial Science and Technology (AIST)
1 shared publication - Seiji Ishikawa
Advanced Power Electronics Research Center
1 shared publication
Latest Publications
- Open Access
- 6 June 2023
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 948, 107-113
Reduction of Forward Bias Degradation in 4H-SiC PiN Diodes Fabricated on 4H-SiC Bonded Substrates
The advantage in reducing forward bias degradation of bipolar 4H-SiC devices using a 4H-SiC bonded substrate is demonstrated. To evaluate the differences in forward bias degradation between a 4H-SiC bonded substrate and a commercially available 4H-SiC bulk substrate, a forward current stress test and subsequent photoluminescence (PL) imaging of PiN diodes fabricated on both the substrates were performed. Unlike the bulk substrate, the bonded substrate maintained a low ΔVf and the variation among the measured diodes was extremely small even after applying the highest current density of 1500 A/cm2. The investigated number of bar-shaped SSFs within the electrically stressed diodes with more than 1000 A/cm2 revealed the possibility that the BPDs existing at deep positions below the epilayer/substrate interface were drastically reduced in the 4H-SiC bonded substrate.
- 6 June 2023
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 948, 107-113
Open AccessReduction of Forward Bias Degradation in 4H-SiC PiN Diodes Fabricated on 4H-SiC Bonded Substrates
The advantage in reducing forward bias degradation of bipolar 4H-SiC devices using a 4H-SiC bonded substrate is demonstrated. To evaluate the differences in forward bias degradation between a 4H-SiC bonded substrate and a commercially available 4H-SiC bulk substrate, a forward current stress test and subsequent photoluminescence (PL) imaging of PiN diodes fabricated on both the substrates were performed. Unlike the bulk substrate, the bonded substrate maintained a low ΔVf and the variation among the measured diodes was extremely small even after applying the highest current density of 1500 A/cm2. The investigated number of bar-shaped SSFs within the electrically stressed diodes with more than 1000 A/cm2 revealed the possibility that the BPDs existing at deep positions below the epilayer/substrate interface were drastically reduced in the 4H-SiC bonded substrate.