Pietro Salvi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Pietro Salvi has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Andrea Leonardo Lacaita
Dipartimento di Elettronica, Informazione e Bioingegneria, Politecnico di Milano, Milan, Italy
3 shared publications - Michele Rossoni
Dipartimento di Elettronica, Informazione e Bioingegneria, Politecnico di Milano, Milan, Italy
3 shared publications - Salvatore Levantino
Dipartimento di Elettronica, Informazione e Bioingegneria, Politecnico di Milano, Milan, Italy
3 shared publications - Simone Mattia Dartizio
Dipartimento di Elettronica, Informazione e Bioingegneria, Politecnico di Milano, Milan, Italy
3 shared publications - Daniele Lodi Rizzini
Dipartimento di Elettronica, Informazione e Bioingegneria, Politecnico di Milano, Milan, Italy
2 shared publications - Francesco Tesolin
Dipartimento di Elettronica, Informazione e Bioingegneria, Politecnico di Milano, Milan, Italy
2 shared publications
Latest Publications
- 30 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (12) , 4572-4586
A Low-Noise Digital PLL With an Adaptive Common-Mode Resonance Tuning Technique for Voltage-Biased Oscillators
This work presents a digital phase-locked loop (PLL) incorporating an adaptive common-mode (CM) resonance tuning technique applied to a voltage-biased digitally-controlled oscillator (DCO). The method leverages the principle that the sensitivity of the oscillator frequency to a dither signal injected into the gate voltage of the cross-coupled transistors diminishes to near zero when the CM resonance is optimally tuned for minimal phase noise (PN). By detecting and nullifying this sensitivity, the proposed technique automatically adjusts the CM resonance to its ideal value. This background operation is continuous across the entire tuning range. The concept was validated through a digital PLL prototype fabricated in a 28-nm CMOS process, which achieved a jitter of 45.9 fs, a power-versus-jitter figure-of-merit of −257 dB, and a PN of −146.6 dBc/Hz at 10-MHz offset from a 4.75-GHz carrier, all within an active area of 0.21 mm2 .
- 30 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (12) , 4572-4586
A Low-Noise Digital PLL With an Adaptive Common-Mode Resonance Tuning Technique for Voltage-Biased Oscillators
This work presents a digital phase-locked loop (PLL) incorporating an adaptive common-mode (CM) resonance tuning technique applied to a voltage-biased digitally-controlled oscillator (DCO). The method leverages the principle that the sensitivity of the oscillator frequency to a dither signal injected into the gate voltage of the cross-coupled transistors diminishes to near zero when the CM resonance is optimally tuned for minimal phase noise (PN). By detecting and nullifying this sensitivity, the proposed technique automatically adjusts the CM resonance to its ideal value. This background operation is continuous across the entire tuning range. The concept was validated through a digital PLL prototype fabricated in a 28-nm CMOS process, which achieved a jitter of 45.9 fs, a power-versus-jitter figure-of-merit of −257 dB, and a PN of −146.6 dBc/Hz at 10-MHz offset from a 4.75-GHz carrier, all within an active area of 0.21 mm2 .
- 4 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (7) , 2619-2631
A Low-Noise Fractional-N Digital PLL Using a Resistor-Based Inverse-Constant-Slope DTC
This work presents a digital-to-time converter (DTC)-based fractional- $N$ phase-locked loop (PLL) achieving low jitter and low spurs. Thanks to the proposed resistor-based inverse-constant-slope (R-ICS) DTC, the DTC random jitter is drastically reduced while retaining the excellent linearity performance of the conventional ICS-DTC architecture. Moreover, a tailored DTC range reduction technique is introduced to further improve DTC random noise. The PLL prototype has been fabricated in 28-nm CMOS and consumes 16.7 mW, with an active area of 0.21 mm 2 . It generates an output frequency in the 8.75–10.25-GHz range from a 125-MHz input reference frequency. At 9.25-GHz near-integer channels, it achieves a 67-fs rms jitter, a $-$ 108.5-dBc/Hz in-band phase noise (at 10-kHz offset), and fractional spurs below $-$ 63 dBc.
- 4 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (7) , 2619-2631
A Low-Noise Fractional-N Digital PLL Using a Resistor-Based Inverse-Constant-Slope DTC
This work presents a digital-to-time converter (DTC)-based fractional- $N$ phase-locked loop (PLL) achieving low jitter and low spurs. Thanks to the proposed resistor-based inverse-constant-slope (R-ICS) DTC, the DTC random jitter is drastically reduced while retaining the excellent linearity performance of the conventional ICS-DTC architecture. Moreover, a tailored DTC range reduction technique is introduced to further improve DTC random noise. The PLL prototype has been fabricated in 28-nm CMOS and consumes 16.7 mW, with an active area of 0.21 mm 2 . It generates an output frequency in the 8.75–10.25-GHz range from a 125-MHz input reference frequency. At 9.25-GHz near-integer channels, it achieves a 67-fs rms jitter, a $-$ 108.5-dBc/Hz in-band phase noise (at 10-kHz offset), and fractional spurs below $-$ 63 dBc.